Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userSub-arcsecond imaging with the International LOFAR Telescope I. Foundational calibration strategy and pipeline
98
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
[abridged] The International LOFAR Telescope is an interferometer with stations spread across Europe. With baselines of up to ~2,000 km, LOFAR has the unique capability of achieving sub-arcsecond resolution at frequencies below 200 MHz, although this is technically and logistically challenging. Here we present a calibration strategy that builds on previous high-resolution work with LOFAR. We give an overview of the calibration strategy and discuss the special challenges inherent to enacting high-resolution imaging with LOFAR, and describe the pipeline, which is publicly available, in detail. We demonstrate the calibration strategy by using the pipeline on P205+55, a typical LOFAR Two-metre Sky Survey (LoTSS) pointing. We perform in-field delay calibration, solution referencing to other calibrators, self-calibration, and imaging of example directions of interest in the field. For this specific field and these ionospheric conditions, dispersive delay solutions can be transferred between calibrators up to ~1.5 degrees away, while phase solution transferral works well over 1 degree. We demonstrate a check of the astrometry and flux density scale. Imaging in 17 directions, the restoring beam is typically 0.3 x 0.2 although this varies slightly over the entire 5 square degree field of view. We achieve ~80 to 300 $mu$Jy/bm image rms noise, which is dependent on the distance from the phase centre; typical values are ~90 $mu$Jy/bm for the 8 hour observation with 48 MHz of bandwidth. Seventy percent of processed sources are detected, and from this we estimate that we should be able to image ~900 sources per LoTSS pointing. This equates to ~3 million sources in the northern sky, which LoTSS will entirely cover in the next several years. Future optimisation of the calibration strategy for efficient post-processing of LoTSS at high resolution (LoTSS-HR) makes this estimate a lower limit.
rate research
Read More
The Low-Frequency Array (LOFAR) Long-Baseline Calibrator Survey (LBCS) was conducted between 2014 and 2019 in order to obtain a set of suitable calibrators for the LOFAR array. In this paper we present the complete survey, building on the preliminary analysis published in 2016 which covered approximately half the survey area. The final catalogue consists of 30006 observations of 24713 sources in the northern sky, selected for a combination of high low-frequency radio flux density and flat spectral index using existing surveys (WENSS, NVSS, VLSS, and MSSS). Approximately one calibrator per square degree, suitable for calibration of $geq$ 200 km baselines is identified by the detection of compact flux density, for declinations north of 30 degrees and away from the Galactic plane, with a considerably lower density south of this point due to relative difficulty in selecting flat-spectrum candidate sources in this area of the sky. Use of the VLBA calibrator list, together with statistical arguments by comparison with flux densities from lower-resolution catalogues, allow us to establish a rough flux density scale for the LBCS observations, so that LBCS statistics can be used to estimate compact flux densities on scales between 300 mas and 2 arcsec, for sources observed in the survey. The LBCS can be used to assess the structures of point sources in lower-resolution surveys, with significant reductions in the degree of coherence in these sources on scales between 2 arcsec and 300 mas. The LBCS survey sources show a greater incidence of compact flux density in quasars than in radio galaxies, consistent with unified schemes of radio sources. Comparison with samples of sources from interplanetary scintillation (IPS) studies with the Murchison Widefield Array (MWA) shows consistent patterns of detection of compact structure in sources observed both interferometrically with LOFAR and using IPS.
3C295 is a bright, compact steep spectrum source with a well-studied integrated radio spectral energy distribution (SED) from 132 MHz to 15 GHz. However, spatially resolved spectral studies have been limited due to a lack of high resolution images at low radio frequencies. These frequencies are crucial for measuring absorption processes, and anchoring the overall spectral modelling of the radio SED. In this paper, we use International LOFAR (LOw-Frequency ARray) Telescope (ILT) observations of 3C295 to study its spatially resolved spectral properties with sub-arcsecond resolution at 132 MHz. Combining our new 132 MHz observation with archival data at 1.6 GHz, 4.8 GHz, and 15 GHz, we are able to carry out a resolved radio spectral analysis. The spectral properties of the hotspots provides evidence for low frequency flattening. In contrast, the spectral shape across the lobes is consistent with a JP spectral ageing model. Using the integrated spectral information for each component, we then fit low-frequency absorption models to the hotspots, finding that both free-free absorption and synchrotron self-absorption models provide a better fit to the data than a standard power law. Although we can say there is low-frequency absorption present in the hotspots of 3C295, future observations with the Low Band Antenna of the ILT at 55 MHz may allow us to distinguish the type of absorption.
One of the science drivers of the new Low Frequency Array (LOFAR) is large-area surveys of the low-frequency radio sky. Realizing this goal requires automated processing of the interferometric data, such that fully calibrated images are produced by the system during survey operations. The LOFAR Imaging Pipeline is the tool intended for this purpose, and is now undergoing significant commissioning work. The pipeline is now functional as an automated processing chain. Here we present several recent LOFAR images that have been produced during the still ongoing commissioning period. These early LOFAR images are representative of some of the science goals of the commissioning team members.
Active galactic nuclei (AGNs) show episodic activity, evident in galaxies that exhibit restarted radio jets. These restarted jets can interact with their environment, leaving signatures on the radio spectral energy distribution. Tracing these signatures requires resolved spectral index measurements over a broad frequency range including low frequencies. We present such a study for the radio galaxy 3C 293. Using the International LOFAR telescope (ILT) we probed spatial scales as fine as ~0.2 at 144 MHz, and to constrain the spectrum we combined these data with Multi-Element Radio Linked Interferometer Network (MERLIN) and Very Large Array (VLA) archival data. In the inner lobes (~2 kpc), we detect the presence of a spectral turnover that peaks at ~225 MHz and is most likely caused by free-free absorption from the rich surrounding medium. We confirm that these inner lobes are part of a jet-dominated young radio source (spectral age $lesssim$0.17 Myr), which is strongly interacting with the rich interstellar medium (ISM) of the host galaxy. The outer lobes (~100 kpc) have a spectral index of $alpha$~0.6-0.8 from 144-4850 MHz with a remarkably uniform spatial distribution and only mild spectral curvature ($Deltaalphalesssim$ 0.2). We propose that intermittent fuelling and jet flow disruptions are powering the mechanisms that keep the spectral index in the outer lobes from steepening and maintain the spatial uniformity of the spectral index. Overall, it appears that 3C 293 has gone through multiple (two to three) epochs of activity. This study adds 3C 293 to the new sub-group of restarted galaxies with short interruption time periods. This is the first time a spatially resolved study simultaneously studies a young source as well as the older outer lobes at such low frequencies. This illustrates the potential of the ILT to expand such studies to a larger sample of radio galaxies.
The Low Frequency Array (LOFAR) is an ideal instrument to conduct deep extragalactic surveys. It has a large field of view and is sensitive to large scale and compact emission. It is, however, very challenging to synthesize thermal noise limited maps at full resolution, mainly because of the complexity of the low-frequency sky and the direction dependent effects (phased array beams and ionosphere). In this first paper of a series we present a new calibration and imaging pipeline that aims at producing high fidelity, high dynamic range images with LOFAR High Band Antenna data, while being computationally efficient and robust against the absorption of unmodeled radio emission. We apply this calibration and imaging strategy to synthesize deep images of the Bootes and LH fields at 150 MHz, totaling $sim80$ and $sim100$ hours of integration respectively and reaching unprecedented noise levels at these low frequencies of $lesssim30$ and $lesssim23$ $mu$Jy/beam in the inner $sim3$ deg$^2$. This approach is also being used to reduce the LoTSS-wide data for the second data release.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
