Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userMicroalloying effect in ternary Al-Sm-X (X=Ag, Au, Cu) metallic glasses studied by ab initio molecular dynamics
75
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
The icosahedral-like polyhedral fraction (ICO-like fraction) has been studied as a criterion for predicting the glass-forming ability of bulk ternary metallic glasses, Al90Sm8X2 (X = Al (binary), Cu, Ag, Au), using ab initio molecular dynamics (AIMD) simulations. We found that the ICO-like fraction can be determined with adequate precision to explore correlations with AIMD simulations. We then demonstrated that ICO-like fraction correlates with the critical cooling rate, which is a widely used intrinsic measure of glass forming ability. These results suggest that the ICO-like fraction from AIMD simulations may offer a useful guide for searching and screening for good glass formers.
rate research
Read More
254 -
Henry H. Wu
, Dallas R. Trinkle (Department of Materials Science andn Engineering
, University of Illinois
2009
A binary embedded-atom method (EAM) potential is optimized for Cu on Ag(111) by fitting to ab initio data. The fitting database consists of DFT calculations of Cu monomers and dimers on Ag(111), specifically their relative energies, adatom heights, and dimer separations. We start from the Mishin Cu-Ag EAM potential and first modify the Cu-Ag pair potential to match the FCC/HCP site energy difference then include Cu-Cu pair potential optimization for the entire database. The optimized EAM potential reproduce DFT monomer and dimer relative energies and geometries correctly. In trimer calculations, the potential produces the DFT relative energy between FCC and HCP trimers, though a different ground state is predicted. We use the optimized potential to calculate diffusion barriers for Cu monomers, dimers, and trimers. The predicted monomer barrier is the same as DFT, while experimental barriers for monomers and dimers are both lower than predicted here. We attribute the difference with experiment to the overestimation of surface adsorption energies by DFT and a simple correction is presented. Our results show that the optimized Cu-Ag EAM can be applied in the study of larger Cu islands on Ag(111).
GaAs nanowires were grown by metalorganic vapor phase epitaxy on evaporated metal films (Au, Au / Pd, Ag, Ni, Ga, Cu, Al, Ti). The samples were characterized by scanning electron microscope (SEM) and transmission electron microscope (TEM). SEM images reveal that nanowires grow directly on the metals. TEM characterization shows crystalline nanowire (nw) structure originating from Au. Article presents state of the art about nanowire-metal interface growth and enumerates nanowire contacting methods with metals.
The classic metallurgical systems -- noble metal alloys -- that have formed the benchmark for various alloy theories, are revisited. First-principles fully relaxed general potential LAPW total energies of a few ordered structures are used as input to a mixed-space cluster expansion calculation to study the phase stability, thermodynamic properties and bond lengths in Cu-Au, Ag-Au, Cu-Ag and Ni-Au alloys. (i) Our theoretical calculations correctly reproduce the tendencies of Ag-Au and Cu-Au to form compounds and Ni-Au and Cu-Ag to phase separate at T=0 K. (ii) Of all possible structures, Cu/sub 3/Au (L1/sub 2/) and CuAu (L1/sub 0/) are found to be the most stable low-temperature phases of Cu/sub 1-x/Au/sub x/ with transition temperatures of 530 K and 660 K, respectively, compared to the experimental values 663 K and 670 K. The significant improvement over previous first-principles studies is attributed to the more accurate treatment of atomic relaxations in the present work. (iii) LAPW formation enthalpies demonstrate that L1/sub 2/, the commonly assumed stable phase of CuAu/sub 3/, is not the ground state for Au-rich alloys, but rather that ordered <100> superlattices are stabilized. (iv) We extract the non-configurational (e.g., vibrational) entropies of formation and obtain large values for the size mismatched systems: 0.48 k/sub B//atom in Ni/sub 0.5/Au/sub 0.5/ (T=1100 K), 0.37 k/sub B//atom in Cu/sub 0.14/Ag/sub 0.86/ (T=1052 K), and 0.16 k/sub B//atom in Cu/sub 0.5/Au/sub 0.5/ (T=800 K). (v) Using 8 atom/cell special quasirandom structures we study the bond lengths in disordered Cu-Au and Ni-Au alloys and obtain good qualitative agreement with recent EXAFS measurements.
We performed high-pressure angle dispersive x-ray diffraction measurements on Fe5Si3 and Ni2Si up to 75 GPa. Both materials were synthesized in bulk quantities via a solid-state reaction. In the pressure range covered by the experiments, no evidence of the occurrence of phase transitions was observed. On top of that, Fe5Si3 was found to compress isotropically, whereas an anisotropic compression was observed in Ni2Si. The linear incompressibility of Ni2Si along the c-axis is similar in magnitude to the linear incompressibility of diamond. This fact is related to the higher valence-electron charge density of Ni2Si along the c-axis. The observed anisotropic compression of Ni2Si is also related to the layered structure of Ni2Si where hexagonal layers of Ni2+ cations alternate with graphite-like layers formed by (NiSi)2- entities. The experimental results are supported by ab initio total-energy calculations carried out using density functional theory and the pseudopotential method. For Fe5Si3, the calculations also predicted a phase transition at 283 GPa from the hexagonal P63/mcm phase to the cubic structure adopted by Fe and Si in the garnet Fe5Si3O12. The room-temperature equations of state for Fe5Si3 and Ni2Si are also reported and a possible correlation between the bulk modulus of iron silicides and the coordination number of their minority element is discussed. Finally, we report novel descriptions of these structures, in particular of the predicted high-pressure phase of Fe5Si3 (the cation subarray in the garnet Fe5Si3O12), which can be derived from spinel Fe2SiO4 (Fe6Si3O12).
We present a detailed appraisal of the optical and plasmonic properties of ordered alloys of the form Au$_{x}$Ag$_{y}$Cu$_{1-x-y}$, as predicted by means of first-principles many-body perturbation theory augmented by a semi-empirical Drude-Lorentz model. In benchmark simulations on elemental Au, Ag, and Cu, we find that the random-phase approximation (RPA) fails to accurately describe inter-band transitions when it is built upon semi-local approximate Kohn-Sham density-functional theory (KS-DFT) band-structures. We show that non-local electronic exchange-correlation interactions sufficient to correct this, particularly for the fully-filled, relatively narrow $d$-bands that which contribute strongly throughout the low-energy spectral range ($0-6$ eV), may be modelled very expediently using band-stretching operators that imitate the effect of a perturbative G$_0$W$_0$ self-energy correction incorporating quasiparticle mass renormalization. We thereby establish a convenient work-flow for carrying out approximated G$_0$W$_0$+RPA spectroscopic calculations on alloys. We develop a pragmatic procedure for calculating the Drude plasmon frequency from first principles, including self-energy effects, as well as a semi-empirical scheme for interpolating the plasmon inverse lifetimes between stoichiometries. A range of optical and plasmonic figures of merit are discussed at three representative solid-state laser wavelengths.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
