Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userSpecific adsorption of phosphate species on Ag (111) and Ag (100) electrodes and their effect at low overpotentials of the hydrogen evolution reaction
60
0
0.0
(
0
)
Authors
Claudia B. Salim Rosales IFEG
Ask ChatGPT about the research
No Arabic abstract
Investigation of phosphate species adsorption/desorption processes was performed on Ag(100) and Ag(111) electrodes in H$_{3}$PO$_{4}$, KH$_{2}$PO$_{4}$ and K$_{3}$PO$_{4}$ solutions by Current-Potential ($j-V$) profiles and Electrochemical Impedance Spectroscopy ($EIS$). We used the equivalent circuit method to fit the impedance spectra. Different electrical equivalent circuits ($EECs$) were employed depending on the potential region that was analyzed. For potentials more negative than the onset of the hydrogen evolution reaction ($her$), a charge transfer resistance (R$_{ct}$) in parallel to the $(RC)$ branches was included. Peaks from $j-V$ profiles were integrated to estimate surface coverage. A reversible process was observed for Ag(hkl)/KH$_{2}$PO$_{4}$ systems, where a value of 0.07 ML was obtained. For Ag(111)/H$_{3}$PO$_{4}$, a coverage of about 0.024 ML was calculated from anodic/cathodic $j-V$ profiles, whereas for Ag(hkl)/K$_{3}$PO$_{4}$ systems different values were obtained from integration of anodic/cathodic peaks due to highly irreversible processes were observed. In the case of Ag(hkl)/K$_{3}$PO$_{4}$, the capacitance (C$_{(phi)}$) plots are well differentiated for the two faces, and co-adsorption of OH$^{-}$ was evaluated from resistance parameters. Characteristic face-specific relaxation times are obtained for each electrode. In addition, it was found that the onset potential of $her$ for Ag(111) at pH=1.60 was about 100 mV more negative compare to Ag(100).
rate research
Read More
Part of developing new strategies for fabrications of nanowire structures involves in many cases the aid of metal nanoparticles (NPs). It is highly beneficial if one can define both diameter and position of the initial NPs and make well-defined nanowire arrays. This sets additional requirement on the NPs with respect to being able to withstand a pre-growth annealing process (i.e. de- oxidation of the III-V semiconductor surface) in an epitaxy system. Recently, it has been demonstrated that Ag may be an alternative to using Au NPs as seeds for particle-seeded nanowire fabrication. This work brings light onto the effect of annealing of Au, Ag and Au-Ag alloy NP arrays in two commonly used epitaxial systems, the Molecular Beam Epitaxy (MBE) and the Metalorganic Vapor Phase Epitaxy (MOVPE). The NP arrays are fabricated with the aid of Electron Beam Lithography on GaAs 100 and 111B wafers and the evolution of the NPs with respect to shape, size and position on the surfaces are studied after annealing using Scanning Electron Microscopy (SEM). We find that while the Au NP arrays are found to be stable when annealed up to 600 $^{circ}$C in a MOVPE system, a diameter and pitch dependent splitting of the particles are seen for annealing in a MBE system. The Ag NP arrays are less stable, with smaller diameters ($leq$ 50 nm) dissolving during annealing in both epitaxial systems. In general, the mobility of the NPs is observed to differ between the two the GaAs 100 and 111B surfaces. While the initial pattern is found be intact on the GaAs 111B surface for a particular annealing process and particle type, the increased mobility of the NP on the 100 may influence the initial pre-defined positions at higher annealing temperatures. The effect of annealing on Au-Ag alloy NP arrays suggests that these NP can withstand necessary annealing conditions for a complete de-oxidation of GaAs surfaces.
The first principles density functional theory (DFT) is applied to study effects of molecular adsorption on optical losses of silver (111) surface. The ground states of the systems including water, methanol, and ethanol molecules adsorbed on Ag (111) surface were obtained by the total energy minimization method within the local density approximation (LDA). Optical functions were calculated within the Random Phase Approximation (RPA) approach. Contribution of the surface states to optical losses was studied by calculations of the dielectric function of bare Ag (111) surface. Substantial modifications of the real and imaginary parts of the dielectric functions spectra in the near infrared and visible spectral regions, caused by surface states and molecular adsorption, were obtained. The results are discussed in comparison with available experimental data.
Based on density functional theory calculations, we systematically investigate the behaviors of a H atom in Ag-doped ZnO, involving the preference sites, diffusion behaviors, the electronic structures and vibrational properties. We find that a H atom can migrate to the doped Ag to form a Ag-H complex by overcoming energy barriers of 0.3 - 1.0 eV. The lowest-energy site for H location is the bond center of a Ag-O in the basal plane. Moreover, H can migrate between this site and its equivalent sites with energy cost of less than 0.5 eV. In contrast, dissociation of such a Ag-H complex needs energy of about 1.1 - 1.3 eV. This implies that the Ag-H complexes can commonly exist in the Ag-doped ZnO, which have a negative effect on the desirable p-type carrier concentrations of Ag-doped ZnO. In addition, based on the frozen phonon calculation, the vibrational properties of ZnO with a Ag-H complex are predicted. Some new vibrational modes associated with the Ag-H complex present in the vibrational spectrum of the system.
We investigate equilibrium and transport properties of a copper phthalocyanine (CuPc) molecule adsorbed on Au(111) and Ag(111) surfaces. The CuPc molecule has essentially three localized orbitals close to the Fermi energy resulting in strong local Coulomb repulsion not accounted for properly in density functional calculations. Hence, they require a proper many-body treatment within, e.g., the Anderson impurity model (AIM). The occupancy of these orbitals varies with the substrate on which CuPc is adsorbed. Starting from density functional theory calculations, we determine the parameters for the AIM embedded in a noninteracting environment that describes the residual orbitals of the entire system. While correlation effects in CuPc on Au(111) are already properly described by a single orbital AIM, for CuPc on Ag(111) the three orbital AIM problem can be simplified into a two orbital problem coupled to the localized spin of the third orbital. This results in a Kondo effect with a mixed character, displaying a symmetry between SU(2) and SU(4). The computed Kondo temperature is in good agreement with experimental values. To solve the impurity problem we use the recently developed fork tensor product state solver. To obtain transport properties, a scanning tunneling microscope (STM) tip is added to the CuPc molecule absorbed on the surface. We find that the transmission depends on the detailed position of the STM tip above the CuPc molecule in good agreement with differential conductance measurements.
The evolution of titanyl-phthalocyanine (TiOPc) thin films on Ag(111) has been investigated using IRAS, SPA-LEED and STM. In the (sub)monolayer regime various phases are observed that can be assigned to a 2D gas, a commensurate and a point-on-line phase. In all three phases the non-planar TiOPc molecule is adsorbed on Ag(111) in an oxygen-up configuration with the molecular pi-conjugated backbone oriented parallel to the surface. The commensurate phase reveals a high packing density, containing two molecules at inequivalent adsorption sites within the unit cell. Both molecules assume different azimuthal orientations which is ascribed to preferred sites and azimuthal orientations with respect to the Ag(111) substrate and, to a lesser extent, to a minimization of repulsive Pauli interactions between adjacent molecules at short distances. At full saturation of the monolayer the latter interaction becomes dominant and the commensurate long range order is lost. DFT calculations have been used to study different adsorption geometries of TiOPc on Ag(111). The most stable configurations among those with pointing up oxygen atoms (bridge+, bridgex, topx) seem to correspond to those identified experimentally. The calculated dependence of the electronic structure and molecular dipole on the adsorption site and configuration is found to be rather small.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
