Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userTwo-layer Thermally Driven Turbulence: Mechanisms for Interface Breakup
157
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
It is commonly accepted that the breakup criteria of drops or bubbles in turbulence is governed by surface tension and inertia. However, also {it{buoyancy}} can play an important role at breakup. In order to better understand this role, here we numerically study Rayleigh-Benard convection for two immiscible fluid layers, in order to identify the effects of buoyancy on interface breakup. We explore the parameter space spanned by the Weber number $5leq We leq 5000$ (the ratio of inertia to surface tension) and the density ratio between the two fluids $0.001 leq Lambda leq 1$, at fixed Rayleigh number $Ra=10^8$ and Prandtl number $Pr=1$. At low $We$, the interface undulates due to plumes. When $We$ is larger than a critical value, the interface eventually breaks up. Depending on $Lambda$, two breakup types are observed: The first type occurs at small $Lambda ll 1$ (e.g. air-water systems) when local filament thicknesses exceed the Hinze length scale. The second, strikingly different, type occurs at large $Lambda$ with roughly $0.5 < Lambda le 1$ (e.g. oil-water systems): The layers undergo a periodic overturning caused by buoyancy overwhelming surface tension. For both types the breakup criteria can be derived from force balance arguments and show good agreement with the numerical results.
rate research
Read More
We analyze the reversals of the large scale flow in Rayleigh-Benard convection both through particle image velocimetry flow visualization and direct numerical simulations (DNS) of the underlying Boussinesq equations in a (quasi) two-dimensional, rectangular geometry of aspect ratio 1. For medium Prandtl number there is a diagonal large scale convection roll and two smaller secondary rolls in the two remaining corners diagonally opposing each other. These corner flow rolls play a crucial role for the large scale wind reversal: They grow in kinetic energy and thus also in size thanks to plume detachments from the boundary layers up to the time that they take over the main, large scale diagonal flow, thus leading to reversal. Based on this mechanism we identify a typical time scale for the reversals. We map out the Rayleigh number vs Prandtl number phase space and find that the occurrence of reversals very sensitively depends on these parameters.
This numerical study presents a simple but extremely effective way to considerably enhance heat transport in turbulent multiphase flows, namely by using oleophilic walls. As a model system, we pick the Rayleigh-Benard setup, filled with an oil-water mixture. For oleophilic walls, e.g. using only $10%$ volume fraction of oil in water, we observe a remarkable heat transport enhancement of more than $100%$ as compared to the pure water case. In contrast, for oleophobic walls, the enhancement is then only about $20%$ as compared to pure water. The physical explanation of the highly-efficient heat transport for oleophilic walls is that thermal plumes detach from the oil-rich boundary layer and are transported together with the oil phase. In the bulk, the oil-water interface prevents the plumes to mix with the turbulent water bulk. To confirm this physical picture, we show that the minimum amount of oil to achieve the maximum heat transport is set by the volume fraction of the thermal plumes. Our findings provide guidelines of how to optimize heat transport in thermal turbulence. Moreover, the physical insight of how coherent structures are coupled with one phase of a two-phase system has very general applicability for controlling transport properties in other turbulent multiphase flows.
Simulations of elastoinertial turbulence (EIT) of a polymer solution at low Reynolds number are shown to display localized polymer stretch fluctuations. These are very similar to structures arising from linear stability (Tollmien-Schlichting (TS) modes) and resolvent analyses: i.e., critical-layer structures localized where the mean fluid velocity equals the wavespeed. Computation of self-sustained nonlinear TS waves reveals that the critical layer exhibits stagnation points that generate sheets of large polymer stretch. These kinematics may be the genesis of similar structures in EIT.
We develop a novel data-driven approach to modeling the atmospheric boundary layer. This approach leads to a nonlocal, anisotropic synthetic turbulence model which we refer to as the deep rapid distortion (DRD) model. Our approach relies on an operator regression problem which characterizes the best fitting candidate in a general family of nonlocal covariance kernels parameterized in part by a neural network. This family of covariance kernels is expressed in Fourier space and is obtained from approximate solutions to the Navier--Stokes equations at very high Reynolds numbers. Each member of the family incorporates important physical properties such as mass conservation and a realistic energy cascade. The DRD model can be calibrated with noisy data from field experiments. After calibration, the model can be used to generate synthetic turbulent velocity fields. To this end, we provide a new numerical method based on domain decomposition which delivers scalable, memory-efficient turbulence generation with the DRD model as well as others. We demonstrate the robustness of our approach with both filtered and noisy data coming from the 1968 Air Force Cambridge Research Laboratory Kansas experiments. Using this data, we witness exceptional accuracy with the DRD model, especially when compared to the International Electrotechnical Commission standard.
We study periodically driven Taylor-Couette turbulence, i.e. the flow confined between two concentric, independently rotating cylinders. Here, the inner cylinder is driven sinusoidally while the outer cylinder is kept at rest (time-averaged Reynolds number is $Re_i = 5 times 10^5$). Using particle image velocimetry (PIV), we measure the velocity over a wide range of modulation periods, corresponding to a change in Womersley number in the range $15 leq Wo leq 114$. To understand how the flow responds to a given modulation, we calculate the phase delay and amplitude response of the azimuthal velocity. In agreement with earlier theoretical and numerical work, we find that for large modulation periods the system follows the given modulation of the driving, i.e. the system behaves quasi-stationary. For smaller modulation periods, the flow cannot follow the modulation, and the flow velocity responds with a phase delay and a smaller amplitude response to the given modulation. If we compare our results with numerical and theoretical results for the laminar case, we find that the scalings of the phase delay and the amplitude response are similar. However, the local response in the bulk of the flow is independent of the distance to the modulated boundary. Apparently, the turbulent mixing is strong enough to prevent the flow from having radius-dependent responses to the given modulation.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
