Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userSpectroscopy and Differential Emission Measure diagnostics of a coronal dimming associated with a fast halo CME
129
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We study the coronal dimming caused by the fast halo CME (deprojected speed v =1250 km s $^{-1})$ associated with the C3.7 two-ribbon flare on 2012 September 27, using Hinode/EIS spectroscopy and SDO/AIA Differential Emission Measure (DEM) analysis. The event reveals bipolar core dimmings encompassed by hook-shaped flare ribbons located at the ends of the flare-related polarity inversion line, and marking the footpoints of the erupting filament. In coronal emission lines of $log T , [{rm K}] = 5.8-6.3$, distinct double component spectra indicative of the superposition of a stationary and a fast up-flowing plasma component with velocities up to 130 km s$^{-1}$ are observed at regions, which were mapped by the scanning EIS slit close in time of their impulsive dimming onset. The outflowing plasma component is found to be of the same order and even dominant over the stationary one, with electron densities in the upflowing component of $2times 10^{9}$cm$^{-3}$ at $log T , [{rm K}] = 6.2$. The density evolution in core dimming regions derived from SDO/AIA DEM analysis reveals impulsive reductions by $40 - 50%$ within $lesssim$10 min, and remains at these reduced levels for hours. The mass loss rate derived from the EIS spectroscopy in the dimming regions is of the same order than the mass increase rate observed in the associated white light CME ($1 times 10^{12} {rm ; g ; s}^{-1}$), indicative that the CME mass increase in the coronagraphic field-of-view results from plasma flows from below and not from material piled-up ahead of the outward moving and expanding CME front.
rate research
Read More
Coronal mass ejections (CMEs) are often accompanied by coronal dimming evident in extreme ultraviolet (EUV) and soft X-ray observations. The locations of dimming are sometimes considered to map footpoints of the erupting flux rope. As the emitting material expands in the corona, the decreased plasma density leads to reduced emission observed in spectral and irradiance measurements. Therefore, signatures of dimming may reflect properties of CMEs in the early phase of its eruption. In this study, we analyze the event of flare, CME, and coronal dimming on December 26, 2011. We use the data from the Atmospheric Imaging Assembly (AIA) on Solar Dynamics Observatories (SDO) for disk observations of the dimming, and analyze images taken by EUVI, COR1, and COR2 onboard the Solar Terrestrial Relations Observatories to obtain the height and velocity of the associated CMEs observed at the limb. We also measure magnetic reconnection rate from flare observations. Dimming occurs in a few locations next to the flare ribbons, and it is observed in multiple EUV passbands. Rapid dimming starts after the onset of fast reconnection and CME acceleration, and its evolution well tracks the CME height and flare reconnection. The spatial distribution of dimming exhibits cores of deep dimming with a rapid growth, and their light curves are approximately linearly scaled with the CME height profile. From the dimming analysis, we infer the process of the CME expansion, and estimate properties of the CME.
We use Solar Dynamics Observatory (SDO)/Atmospheric Imaging Assembly (AIA) data to reconstruct the plasma properties from differential emission measure (DEM) analysis for a previously studied long-lived, low-latitude coronal hole (CH) over its lifetime of ten solar rotations. We initially obtain a non-isothermal DEM distribution with a dominant component centered around 0.9 MK and a secondary smaller component at 1.5 - 2.0 MK. We find that deconvolving the data with the instrument point spread function (PSF) to account for long-range scattered light reduces the secondary hot component. Using the 2012 Venus transit and a 2013 lunar eclipse to test the efficiency of this deconvolution, significant amounts of residual stray light are found for the occulted areas. Accounting for this stray light in the error budget of the different AIA filters further reduces the secondary hot emission, yielding CH DEM distributions that are close to isothermal with the main contribution centered around 0.9 MK. Based on these DEMs, we analyze the evolution of the emission measure (EM), density, and averaged temperature during the CHs lifetime. We find that once the CH is clearly observed in EUV images, the bulk of the CH plasma reveals a quite constant state, i.e. temperature and density reveal no major changes, whereas the total CH area and the photospheric magnetic fine structure inside the CH show a distinct evolutionary pattern. These findings suggest that CH plasma properties are mostly set at the CH formation or/and that all CHs have similar plasma properties.
Coronal mass ejections (CMEs) are often associated with coronal dimmings, i.e. transient dark regions that are most distinctly observed in Extreme Ultra-violet (EUV) wavelengths. Using Atmospheric Imaging Assembly (AIA) data, we apply Differential Emission Measure (DEM) diagnostics to study the plasma characteristics of six coronal dimming events. In the core dimming region, we find a steep and impulsive decrease of density with values up to 50-70%. Five of the events also reveal an associated drop in temperature of 5-25%. The secondary dimming regions also show a distinct decrease in density, but less strong, decreasing by 10-45%. In both the core and the secondary dimming the density changes are much larger than the temperature changes, confirming that the dimming regions are mainly caused by plasma evacuation. In the core dimming, the plasma density reduces rapidly within the first 20-30 min after the flare start, and does not recover for at least 10 hrs later, whereas the secondary dimming tends to be more gradual and starts to replenish after 1-2 hrs. The pre-event temperatures are higher in the core dimming (1.7-2.6 MK) than in the secondary dimming regions (1.6-2.0 MK). Both core and secondary dimmings are best observed in the AIA 211 AA and 193 AA filters. These findings suggest that the core dimming corresponds to the footpoints of the erupting flux rope rooted in the AR, while the secondary dimming represents plasma from overlying coronal structures that expand during the CME eruption.
Determining the temperature distribution of coronal plasmas can provide stringent constraints on coronal heating. Current observations with the Extreme ultraviolet Imaging Spectrograph onboard Hinode and the Atmospheric Imaging Assembly onboard the Solar Dynamics Observatory provide diagnostics of the emission measure distribution (EMD) of the coronal plasma. Here we test the reliability of temperature diagnostics using 3D radiative MHD simulations. We produce synthetic observables from the models, and apply the Monte Carlo Markov chain EMD diagnostic. By comparing the derived EMDs with the true distributions from the model we assess the limitations of the diagnostics, as a function of the plasma parameters and of the signal-to-noise of the data. We find that EMDs derived from EIS synthetic data reproduce some general characteristics of the true distributions, but usually show differences from the true EMDs that are much larger than the estimated uncertainties suggest, especially when structures with significantly different density overlap along the line-of-sight. When using AIA synthetic data the derived EMDs reproduce the true EMDs much less accurately, especially for broad EMDs. The differences between the two instruments are due to the: (1) smaller number of constraints provided by AIA data, (2) broad temperature response function of the AIA channels which provide looser constraints to the temperature distribution. Our results suggest that EMDs derived from current observatories may often show significant discrepancies from the true EMDs, rendering their interpretation fraught with uncertainty. These inherent limitations to the method should be carefully considered when using these distributions to constrain coronal heating.
Solar coronal dimmings have been observed extensively in the past two decades and are believed to have close association with coronal mass ejections (CMEs). Recent study found that coronal dimming is the only signature that could differentiate powerful ares that have CMEs from those that do not. Therefore, dimming might be one of the best candidates to observe the stellar CMEs on distant Sun-like stars. In this study, we investigate the possibility of using coronal dimming as a proxy to diagnose stellar CMEs. By simulating a realistic solar CME event and corresponding coronal dimming using a global magnetohydrodynamics model (AWSoM: Alfven-wave Solar Model), we first demonstrate the capability of the model to reproduce solar observations. We then extend the model for simulating stellar CMEs by modifying the input magnetic flux density as well as the initial magnetic energy of the CME flux rope. Our result suggests that with improved instrument sensitivity, it is possible to detect the coronal dimming signals induced by the stellar CMEs.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
