Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userOptonanofluidics: Modelling fluid flow through surfactant-modified liquid tethers by laser beams
123
0
0.0
(
0
)
Added by
Buddhapriya Chakrabarti
Publication date
2018
fields
Physics
and research's language is
English
Ask ChatGPT about the research
No Arabic abstract
When a surfactant-stabilised oil droplet with an ultralow interfacial tension is trapped in the focus of two laser beams and pulled apart (by moving the laser beams) a configuration of two droplets connected by a thin tether of oil results. The tether radius depends on the ratio of the bending modulus to the renormalized interfacial tension, which takes into account the spontaneous curvature of the interface. The force exerted by the tether on the droplets is shown to be asymmetric with respect to the phase inversion temperature of the emulsion, in agreement with experiment. Fluid can be pumped from one droplet to the other via the tether by increasing the optical pressure on one droplet. The flow is a combination of Poiseuille flow within the thread of oil and the external flow around a rigid cylinder, with the surface velocity determined by tangential stress balance. For typical viscosities of oils and the continuous aqueous medium, flow is predominantly in the external medium. The normal stress balance leads to a variation in the radius of the thread with distance. The radius is shown to decrease approximately linearly with a slope proportional to the volumetric flow rate through the tether. For a tether of a given length, there is therefore an upper limit to the flow rate that can be generated by pumping with optical traps.
rate research
Read More
The development of microfluidic devices is still hindered by the lack of robust fundamental building blocks that constitute any fluidic system. An attractive approach is optical actuation because light field interaction is contactless and dynamically reconfigurable, and solutions have been anticipated through the use of optical forces to manipulate microparticles in flows. Following the concept of an optical chip advanced from the optical actuation of suspensions, we propose in this survey new routes to extend this concept to microfluidic two-phase flows. First, we investigate the destabilization of fluid interfaces by the optical radiation pressure and the formation of liquid jets. We analyze the droplet shedding from the jet tip and the continuous transport in laser-sustained liquid channels. In the second part, we investigate a dissipative light-flow interaction mechanism consisting in heating locally two immiscible fluids to produce thermocapillary stresses along their interface. This opto-capillary coupling is implemented in adequate microchannel geometries to manipulate two-phase flows and propose a contactless optical toolbox including valves, droplet sorters and switches, droplet dividers or droplet mergers. Finally, we discuss radiation pressure and opto-capillary effects in the context of the optical chip where flows, channels and operating functions would all be performed optically on the same device.
The phase behavior of membrane proteins stems from a complex synergy with the amphiphilic molecules required for their solubilization. We show that ionization of a pH-sensitive surfactant, LDAO, bound to a bacterial photosynthetic protein, the Reaction Center (RC), leads in a narrow pH range to protein liquid-liquid phase separation in surprisingly stable `droplets, forerunning reversible aggregation at lower pH. Phase segregation is promoted by increasing temperature and hindered by adding salt. RC light-absorption and photoinduced electron cycle are moreover strongly affected by phase segregation.
We consider a carpet of self-propelled particles at the liquid-gas interface of a liquid film on a solid substrate. The particles excert an excess pressure on the interface and also move along the interface while the swimming direction performs rotational diffusion. We study the intricate influence of these self-propelled insoluble surfactants on the stability of the film surface and show that depending on the strength of in-surface rotational diffusion and the absolute value of the in-surface swimming velocity several characteristic instability modes can occur. In particular, rotational diffusion can either stabilize the film or induce instabilities of different character.
We study the features of a radial Stokes flow due to a submerged jet directed toward a liquid-air interface. The presence of surface-active impurities confers to the interface an in-plane elasticity that resists the incident flow. Both analytical and numerical calculations show that a minute amount of surfactants is enough to profoundly alter the morphology of the flow. The hydrodynamic response of the interface is affected as well, shifting from slip to no-slip boundary condition as the surface compressibility decreases. We argue that the competition between the divergent outward flow and the elastic response of the interface may actually be used as a practical way to detect and quantify a small amount of impurities.
The thermal expansion of a fluid combined with a temperature-dependent viscosity introduces nonlinearities in the Navier-Stokes equations unrelated to the convective momentum current. The couplings generate the possibility for net fluid flow at the microscale controlled by external heating. This novel thermo-mechanical effect is investigated for a thin fluid chamber by a numerical solution of the Navier-Stokes equations and analytically by a perturbation expansion. A demonstration experiment confirms the basic mechanism and quantitatively validates our theoretical analysis.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
