Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userThe effects of toroidal magnetic field on the vertical structure of hot accretion flows
80
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We solved the set of two-dimensional magnetohydrodynamic (MHD) equations for optically thin black hole accretion flows incorporating toroidal component of magnetic field. Following global and local MHD simulations of black hole accretion disks, the magnetic field inside the disk is decomposed into a large scale field and a fluctuating field. The effects of the fluctuating magnetic field in transferring the angular momentum and dissipating the energy are described through the usual $ alpha $ description. We solved the MHD equations by assuming steady state and radially self-similar approximation in $ r-theta $ plane of spherical coordinate system. We found that as the amount of magnetic field at the equatorial plane increases, the heating by the viscosity decreases. In addition, the maximum amount of the heating by the viscous dissipation is produced at the mid-plane of the disk, while that of the heating by the magnetic field dissipation is produced at the surface of the disk. Our main conclusion is that in terms of the no-outflow solution, thermal equilibrium still exists for the strong magnetic filed at the equatorial plane of the disk.
rate research
Read More
The magnitude of the viscosity and magnetic field parameters in hot accretion flows is investigated in low luminosity active galactic nuclei (LLAGNs). Theoretical studies show that a geometrically thin, optically thick disk is truncated at mass accretion rates less than a critical value by mass evaporated vertically from the disk to the corona, with the truncated region replaced by an advection dominated accretion flow (ADAF). The critical accretion rate for such a truncation is a function of the viscosity and magnetic field. Observations of X-ray photon indices and spectral fits of a number of LLAGNs published in the literature provide an estimate of the critical rate of mass accretion and the truncation radius respectively. By comparing the observational results with theoretical predictions, the viscosity and magnetic field parameters in the hot accretion flow region are estimated. Specifically, the mass accretion rates inferred in different sources constrain the viscosity parameter, whereas the truncation radii of the disk, as inferred from spectral fits, further constrain the magnetic field parameter. It is found that the value of the viscosity parameter in the corona/ADAF ranges from 0.17 to 0.5, with values clustered about 0.2-0.3. Magnetic pressure is required by the relatively small truncation radii for some LLAGNs and is found to be as high as its equipartition value with the gas pressure. The inferred values of the viscosity parameter are in agreement with those obtained from the observations of non-stationary accretion in stellar mass black hole X-ray transients. This consistency provides support for the paradigm that a geometrically thin disk is truncated by means of a mass evaporation process from the disk to the corona at low mass accretion rates.
We study the effects of accretion environment (gas density, temperature and angular momentum) at large radii ($sim 10$pc) on luminosity of hot accretion flows. The radiative feedback effects from the accretion flow on the accretion environment are also self-consistently taken into account. We find that the slowly rotating flows at large radii can significantly deviate from Bondi accretion when radiation heating and cooling are considered. We further find that when the temperature of environment gas is low (e.g. $T=2times 10^7$K), the luminosity of hot accretion flows is high. When the temperature of gas is high (e.g. $Tgeq4times 10^7$K), the luminosity of hot accretion flow significantly deceases. The environment gas density can also significantly influence the luminosity of accretion flows. When density is higher than $sim 4times 10^{-22}text{g} text{cm}^{-3}$ and temperature is lower than $2times 10^7$K, hot accretion flow with luminosity lower than $2%L_{text{Edd}}$ is not present. Therefore, the pc-scale environment density and temperature are two important parameters to determine the luminosity. The results are also useful for the sub-grid models adopted by the cosmological simulations.
Several observations of astrophysical jets show evidence of a structure in the direction perpendicular to the jet axis, leading to the development of spine & sheath models of jets. Most studies focus on a two-component jet consisting of a highly relativistic inner jet and a slower - but still relativistic - outer jet surrounded by an unmagnetized environment. These jets are believed to be susceptible to a relativistic Rayleigh-Taylor-type instability, depending on the effective inertia ratio of the two components. We extend previous studies by taking into account the presence of a non-zero toroidal magnetic field. Different values of magnetization are examined, to detect possible differences in the evolution and stability of the jet. We find that the toroidal field, above a certain level of magnetization $sigma$, roughly equal to 0.01, can stabilize the jet against the previously mentioned instabilities and that there is a clear trend in the behaviour of the average Lorentz factor and the effective radius of the jet when we continuously increase the magnetization. The simulations are performed using the relativistic MHD module from the open source, parallel, grid adaptive, MPI-AMRVAC code.
This is the fourth paper of our series of works studying winds from hot accretion flows around black holes. In the first two papers, we have shown the existence of strong winds in hot accretion flows using hydrodynamical and magnetohydrodynamical (MHD) simulations. In the third paper, by using three dimensional general relativity MHD numerical simulation data of hot accretion flows and adopting a virtual particle trajectory data analysis approach, we have calculated the properties of wind, such as its mass flux and velocity. However, that paper focuses only on a non-spinning black hole and SANE (standard and normal accretion). In the present paper, we extend the third paper by including cases of a rapidly rotating black hole and MAD (magnetically arrested disk). We focus on investigating the effect of spin and magnetic field on the properties of wind and jet. It is found that a larger spin and stronger magnetic field usually enhance the wind and jet. The formulae describing the mass flux, poloidal velocity, and fluxes of momentum, kinetic energy, and total energy of wind and jet are presented. One interesting finding, among others, is that even in the case of very rapidly spinning black hole where the jet is supposed to be the strongest, the momentum flux of jet is smaller than that of wind, while the total energy flux of jet is larger than that of wind by at most a factor of 10. This result suggests that wind potentially plays a more important role than jet at least for some problems in active galactic nuclei feedback.
We analyze two 3D general-relativistic magnetohydrodynamic accretion simulations in the context of how they would manifest in Event Horizon Telescope (EHT) observations of supermassive black holes. The two simulations differ only in whether the initial angular momentum of the plasma is aligned with the rapid (a = 0.9) spin of the black hole. Both have low net magnetic flux. Ray tracing is employed to generate resolved images of the synchrotron emission. When using parameters appropriate for Sgr A* and assuming a viewing angle aligned with the black hole spin, we find the most prominent difference is that the central shadow in the image is noticeably eccentric in tilted models, with the ring of emission relatively unchanged. Applying this procedure to M87 with a viewing angle based on the large-scale jet, we find that adding tilt increases the angular size of the ring for fixed black hole mass and distance, while at the same time increasing the number of bright spots in the image. Our findings illustrate observable features that can distinguish tilted from aligned flows. They also show that tilted models can be viable for M87, and that not accounting for tilt can bias inferences of physical parameters. Future modeling of horizon-scale observations should account for potential angular momentum misalignment, which is likely generic at the low accretion rates appropriate for EHT targets.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
