Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userOn-chip error counting for hybrid metallic single-electron turnstiles
78
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We perform in-situ detection of individual electrons pumped through a single-electron turnstile based on ultrasmall normal metal - insulator - superconductor tunnel junctions. In our setup, limited by the detector bandwidth, at low repetition rates we observe errorless sequential transfer of up to several hundred electrons through the system. At faster pumping speeds up to 100 kHz, we show relative error rates down to 10^-3, comparable to typical values obtained from measurements of average pumped current in non-optimized individual turnstiles. The work constitutes an initial step towards a self-referenced current standard realized with metallic single-electron turnstiles, complementing approaches based on semiconductor quantum dot pumps. It is the first demonstration of on-chip pumping error detection at operation frequencies exceeding the detector bandwidth, in a configuration where the average pumped current can be simultaneously measured. The scheme in which electrons are counted from the superconducting lead of the turnstile, instead of direct probing of the normal metal island, also enables studies of fundamental higher-order tunneling processes in the hybrid structures, previously not in reach with simpler configurations.
rate research
Read More
We demonstrate shadow evaporation-based fabrication of high-quality ultrasmall normal metal -- insulator -- superconductor tunnel junctions where the thickness of the superconducting electrode is not limited by the requirement of small junction size. The junctions are formed between a film of manganese-doped aluminium acting as the normal conducting electrode, covered by a thicker, superconducting layer of pure Al. We characterize the junctions by sub-gap current--voltage measurements and charge pumping measurements in a gate-driven hybrid single-electron transistor, operated as a turnstile for single electrons. The technique allows to advance towards turnstiles with close to ideally thermalized superconducting reservoirs, prerequisite for reaching metrological current quantization accuracy in a hybrid turnstile. We further present an alternative way to realize small junctions with thick Al leads based on multi-angle deposition. The work enables the future investigation of turnstiles based on superconductors other than Al, and benefits various other Al tunnel junction devices for which quasiparticle thermalization is essential.
We present an experimental study of hybrid turnstiles with high charging energies in comparison to the superconducting gap. The device is modeled with the sequential tunneling approximation. The backtunneling effect is shown to limit the amplitude of the gate drive and thereby the maximum pumped current of the turnstile. We compare results obtained with sine and square wave drive and show how a fast rise time can suppress errors due to leakage current. Quantized current plateaus up to 160 pA are demonstrated.
In this letter, we describe operation of a radio-frequency superconducting single electron transistor (RF-SSET) with an on-chip superconducting LC matching network consisting of a spiral inductor L and its capacitance to ground. The superconducting network has a lower parasitic capacitance and gives a better matching for the RF-SSET than does a commercial chip inductor. Moreover, the superconducting network has negligibly low dissipation, leading to sensitive response to changes in the RF-SSET impedance. The charge sensitivity 2.4*10^-6 e/(Hz)^1/2 in the sub-gap region and energy sensitivity of 1.9 hbar indicate that the RF-SSET is operating in the vicinity of the shot noise limit.
We investigate a hybrid structure consisting of $20pm4$ implanted $^{31}$P atoms close to a gate-induced silicon single electron transistor (SiSET). In this configuration, the SiSET is extremely sensitive to the charge state of the nearby centers, turning from the off state to the conducting state when the charge configuration is changed. We present a method to measure fast electron tunnel rates between donors and the SiSET island, using a pulsed voltage scheme and low-bandwidth current detection. The experimental findings are quantitatively discussed using a rate equation model, enabling the extraction of the capture and emission rates.
Molecular electronics is a rapidly developing field focused on using molecules as the structural basis for electronic components. It is common in such devices for the system of interest to couple simultaneously to multiple environments. Here we consider a model comprised of a double quantum dot (or molecule) coupled strongly to vibrations and weakly to two electronic leads held at arbitrary bias voltage. The strong vibrational coupling invalidates treating the bosonic and electronic environments simply as acting additively, as would be the case in the weak coupling regime or for flat leads at infinite bias. Instead, making use of the reaction coordinate framework we incorporate the dominant vibrational coupling effects within an enlarged system Hamiltonian. This allows us to derive a non-additive form for the lead couplings that accounts properly for the influence of strong and non-Markovian coupling between the double dot system and the vibrations. Applying counting statistics techniques we track electron flow between the double dot and the electronic leads, revealing both strong-coupling and non-additive effects in the electron current, noise and Fano factor.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
