Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userCharacterization and Suppression of Low-frequency Noise in Si/SiGe Quantum Point Contacts and Quantum Dots
146
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We report on the effects of a global top gate on low-frequency noise in Schottky gate-defined quantum point contacts (QPCs) and quantum dots (QDs) in a modulation-doped Si/SiGe heterostructure. For a relatively large top gate voltage, the QPC current shows frequent switching with 1/f2 Lorentzian type charge noise. As the top gate voltage is decreased, the QPC pinch-off voltage becomes less negative, and the 1/f2 noise becomes rapidly suppressed in a homogeneous background 1/f noise. We apply this top-gating technique to double QDs to stabilize the charge state for the electron number down to zero.
rate research
Read More
Electron spins in silicon have long coherence times and are a promising qubit platform. However, electric field noise in semiconductors poses a challenge for most single- and multi-qubit operations in quantum-dot spin qubits. Here, we investigate the dependence of low-frequency charge noise spectra on temperature and aluminum-oxide gate dielectric thickness in Si/SiGe quantum dots with overlapping gates. We find that charge noise increases with aluminum oxide thickness. We also find strong dot-to-dot variations in the temperature dependence of the noise magnitude and spectrum. These findings suggest that each quantum dot experiences noise caused by a distinct ensemble of two-level systems, each of which has a non-uniform distribution of thermal activation energies. Taken together, our results suggest that charge noise in Si/SiGe quantum dots originates at least in part from a non-uniform distribution of two-level systems near the surface of the semiconductor.
We fabricated strongly confined Schottky-gated quantum point contacts by etching Si/SiGe heterostructures and observed intriguing conductance quantization in units of approximately 1e2/h. Non-linear conductance measurements were performed depleting the quantum point contacts at fixed mode-energy separation. We report evidences of the formation of a half 1e2/h plateau, supporting the speculation that adiabatic transmission occurs through 1D modes with complete removal of valley and spin degeneracies.
We report on the fabrication and electronic transport characterisation of Schottky-gated strongly confined Si/SiGe quantum point contacts (QPC). At zero magnetic field and T=450mK the QPC conductance as a function of gate voltage shows a quantization in units of e^2/h, indicative of transport through 1D modes which appear to lack both spin and valley degeneracy.
The valley degree of freedom presents challenges and opportunities for silicon spin qubits. An important consideration for singlet-triplet states is the presence of two distinct triplets, comprised of valley vs. orbital excitations. Here we show that both of these triplets are present in the typical operating regime, but that only the valley-excited triplet offers intrinsic protection against charge noise. We further show that this protection arises naturally in dots with stronger confinement. These results reveal an inherent advantage for silicon-based multi-electron qubits.
We report on a quantum dot device design that combines the low disorder properties of undoped SiGe heterostructure materials with an overlapping gate stack in which each electrostatic gate has a dominant and unique function -- control of individual quantum dot occupancies and of lateral tunneling into and between dots. Control of the tunneling rate between a dot and an electron bath is demonstrated over more than nine orders of magnitude and independently confirmed by direct measurement within the bandwidth of our amplifiers. The inter-dot tunnel coupling at the (0,2)<-->(1,1) charge configuration anti-crossing is directly measured to quantify the control of a single inter-dot tunnel barrier gate. A simple exponential dependence is sufficient to describe each of these tunneling processes as a function of the controlling gate voltage.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
