Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userDevelopment of a pulsar-based timescale
159
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Using observations of pulsars from the Parkes Pulsar Timing Array (PPTA) project we develop the first pulsar-based timescale that has a precision comparable to the uncertainties in international atomic timescales. Our ensemble of pulsars provides an Ensemble Pulsar Scale (EPS) analogous to the free atomic timescale Echelle Atomique Libre (EAL). The EPS can be used to detect fluctuations in atomic timescales and therefore can lead to a new realisation of Terrestrial Time, TT(PPTA11). We successfully follow features known to affect the frequency of the International Atomic Timescale (TAI) and we find marginally significant differences between TT(PPTA11) and TT(BIPM11). We discuss the various phenomena that lead to a correlated signal in the pulsar timing residuals and therefore limit the stability of the pulsar timescale.
rate research
Read More
We have constructed a new timescale, TT(IPTA16), based on observations of radio pulsars presented in the first data release from the International Pulsar Timing Array (IPTA). We used two analysis techniques with independent estimates of the noise models for the pulsar observations and different algorithms for obtaining the pulsar timescale. The two analyses agree within the estimated uncertainties and both agree with TT(BIPM17), a post-corrected timescale produced by the Bureau International des Poids et Mesures (BIPM). We show that both methods could detect significant errors in TT(BIPM17) if they were present. We estimate the stability of the atomic clocks from which TT(BIPM17) is derived using observations of four rubidium fountain clocks at the US Naval Observatory. Comparing the power spectrum of TT(IPTA16) with that of these fountain clocks suggests that pulsar-based timescales are unlikely to contribute to the stability of the best timescales over the next decade, but they will remain a valuable independent check on atomic timescales. We also find that the stability of the pulsar-based timescale is likely to be limited by our knowledge of solar-system dynamics, and that errors in TT(BIPM17) will not be a limiting factor for the primary goal of the IPTA, which is to search for the signatures of nano-Hertz gravitational waves.
Combined studies of variable stars and stellar clusters open great horizons, and they allow us to improve our understanding of stellar cluster formation and stellar evolution. In that prospect, the Gaia mission will provide astrometric, photometric, and spectroscopic data for about one billion stars of the Milky Way. This will represent a major census of stellar clusters, and it will drastically increase the number of known variable stars. In particular, the peculiar Gaia scanning law offers the opportunity to investigate the rather unexplored domain of short timescale variability (from tens of seconds to a dozen of hours), bringing invaluable clues to the fields of stellar physics and stellar aggregates. We assess the Gaia capabilities in terms of short timescale variability detection, using extensive light-curve simulations for various variable object types. We show that Gaia can detect periodic variability phenomena with amplitude variations larger than a few millimagnitudes. Additionally, we plan to perform subsequent follow-up of variables stars detected in clusters by Gaia to better characterize them. Hence, we develop a pipeline for the analysis of high cadence photometry from ground-based telescopes such as the 1.2m Euler telescope (La Silla, Chile) and the 1.2m Mercator telescope (La Palma, Canary Islands).
We developed a polarization modulation unit (PMU) to rotate a waveplate continuously in order to observe solar magnetic fields by spectropolarimetry. The non-uniformity of the PMU rotation may cause errors in the measurement of the degree of linear polarization (scale error) and its angle (crosstalk between Stokes-Q and -U), although it does not cause an artificial linear polarization signal (spurious polarization). We rotated a waveplate with the PMU to obtain a polarization modulation curve and estimated the scale error and crosstalk caused by the rotation non-uniformity. The estimated scale error and crosstalk were <0.01 % for both. This PMU will be used as a waveplate motor for the Chromospheric Lyman-Alpha SpectroPolarimeter (CLASP) rocket experiment. We confirmed that the PMU has the sufficient performance and function for CLASP.
Pulsar timing array experiments search for phenomena that produce angular correlations in the arrival times of signals from millisecond pulsars. The primary goal is to detect an isotropic and stochastic gravitational wave background. We use simulated data to show that this search can be affected by the presence of other spatially correlated noise, such as errors in the reference time standard, errors in the planetary ephemeris, the solar wind and instrumentation issues. All these effects can induce significant false detections of gravitational waves. We test mitigation routines to account for clock errors, ephemeris errors and the solar wind. We demonstrate that it is non-trivial to find an effective mitigation routine for the planetary ephemeris and emphasise that other spatially correlated signals may be present in the data.
To assist with the commissioning (Jiang et al. 2019) of the Five-hundred-meter Aperture Spherical radio Telescope (FAST), we performed a pulsar search, with the primary goal of developing and testing the pulsar data acquisition and processing pipelines. We tested and used three pipelines, two (P1 and P2 hereafter) searched for the periodic signature of pulsars whereas the other one was used to search for bright single pulses (P3 hereafter). A pulsar candidate was discovered in the observation on the 22nd August, 2017, and later confirmed by the Parkes radio telescope on the 10th September, 2017. This pulsar, named PSR J1900-0134, was the first pulsar discovered by FAST. The pulsar has a pulse period of 1.8 s and a dispersion measure (DM) of 188,pc,cm$^{-3}$.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
