Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userQuasiparticle scattering time in superconducting films: from dirty to clean limit
106
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We study the quasiparticle energy relaxation processes in superconducting Nb films of different thicknesses corresponding to different electron mean free paths in a state far from equilibrium, that is the highly dissipative flux-flow state driven up to the instability point. From the measured current-voltage curves we derive the vortex critical velocity $v^{*}$ for several temperatures. From the $v^{*}(T)$ values, the quasiparticle energy relaxation time $tau_{epsilon}$ is evaluated within the Larkin-Ovchinnikov model and numerical calculations of the quasiparticle energy relaxation rates are carried out to support the experimental findings. Besides the expected constant behavior of $tau_{epsilon}(T)$ for the dirty samples, we observe a strong temperature dependence of the quasiparticle energy relaxation time in the clean samples. This feature is associated with the increasing contribution from the electron-phonon scattering process as the dirty limit is approached from the clean regime.
rate research
Read More
We have studied the upper critical field, Bc2, in poly-crystalline MgB2 samples in which disorder was varied in a controlled way to carry selectively p and s bands from clean to dirty limit. We have found that the clean regime survives when p bands are dirty and s bands are midway between clean and dirty. In this framework we can explain the anomalous behaviour of Al doped samples, in which Bc2 decreases as doping increases.
There is a hot debate on the anomalous behavior of superfluid density $rho_s$ in overdoped La$_{2-x}$Sr$_x$CuO$_4$ films in recent years. Its linear temperature dependence $rho_s(0)-rho_s(T)propto T$ infers the superconductors are clean, but the zero temperature value $rho_s(0)propto T_c$ is a hallmark of the dirty limit in the Bardeen-Cooper-Schrieffer (BCS) framework (Bozovic et al., 2016). In this work, we show that the apical oxygen vacancies can lead to an anisotropic scattering rate $Gamma_dcos^2(2theta)$, which can explain the above two linear scalings simultaneously, and thus provides a plausible solution to this clean-dirty paradox. Furthermore, by analyzing the optical conductivity, it may also explain the ``missing Drude weight upon doping as reported in the THz experiment (Mahmood et al., 2019). Therefore, we conclude that the superconducting states of the overdoped cuprates are consistent with the disordered BCS theory.
Thin-film superconductors with thickness 30 to 500 nm are used as non-equilibrium quantum detectors for photons, phonons or more exotic particles. One of the most basic questions in determining their limiting sensitivity is the efficiency with which the quanta of interest couple to the detected quasiparticles. As low temperature superconducting resonators, thin-films are attractive candidates for producing quantum-sensitive arrayable sensors and the readout uses an additional microwave probe. We have calculated the quasiparticle generation efficiency eta_s for low energy photons in a representative, clean thin-film superconductor (Al) operating well-below its superconductingtransition temperature as a function of film thickness, within the framework of the coupled kineticequations described by Chang and Scalapino.[J. J. Chang and D. J. Scalapino, J. Low Temp. Phys. 31, 1 (1978)]. We have also included the effect of a lower frequency probe. We show that phonon loss from the thin-film reduces eta_s by as much as 40% compared to earlier models that considered relatively thick films or infinite volumes. We also show that the presence of the probe and signal enhances the generation efficiency slightly. We conclude that the ultimate limiting noise equivalent power of this class of detector is determined by the thin-film geometry.
Using both two orbital and five orbital models, we investigate the quasiparticle interference (QPI) patterns in the superconducting (SC) state of iron-based superconductors. We compare the results for nonmagnetic and magnetic impurities in sign-changed s-wave $cos(k_x)cdotcos(k_y)$ and sign-unchanged $|cos(k_x)cdotcos(k_y)|$ SC states. While the patterns strongly depend on the chosen band structures, the sensitivity of peaks around $(pmpi,0)$ and $(0,pmpi)$ wavevectors on magnetic or non-magnetic impurity, and sign change or sign unchanged SC orders is common in two models. Our results strongly suggest that QPI may provide direct information of band structures and evidence of the pairing symmetry in the SC states.
The response of superconducting pair-breaking detectors is dependent on the details of the quasiparticle distribution. In Kinetic Inductance Detectors (KIDs), where both pair breaking and non-pair breaking photons are absorbed simultaneously, calculating the detector response therefore requires knowledge of the often nonequilibrium distributions. The quasiparticle effective temperature provides a good approximation to these nonequilibrium distributions. We compare an analytical expression relating absorbed power and the quasiparticle effective temperature in superconducting thin films to full solutions for the nonequilibrium distributions, and find good agreement for a range of materials, absorbed powers, photon frequencies and temperatures typical of KIDs. This analytical expression allows inclusion of nonequilibrium effects in device models without solving for the detailed distributions. We also show our calculations of the frequency dependence of the detector response are in agreement with recent experimental measurements of the response of Ta KIDs at THz frequencies.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
