Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userDissipative current in SIFS Josephson junctions
127
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We investigate superconductor/insulator/ferromagnet/superconductor (SIFS) tunnel Josephson junctions in the dirty limit, using the quasiclassical theory. We consider the case of a strong tunnel barrier such that the left S layer and the right FS bilayer are decoupled. We calculate quantitatively the density of states (DOS) in the FS bilayer for arbitrary length of the ferromagnetic layer, using a self-consistent numerical method. We compare these results with a known analytical DOS approximation, which is valid when the ferromagnetic layer is long enough. Finally we calculate quantitatively the current-voltage characteristics of a SIFS junction.
rate research
Read More
We present the latest generation of superconductor-insulator-ferromagnet-superconductor Josephson tunnel junctions with a step-like thickness of the ferromagnetic (F) layer. The F-layer thicknesses $d_1$ and $d_2$ in both halves were varied to obtain different combinations of positive and negative critical current densities $j_{c,1}$ and $j_{c,2}$. The measured dependences of the critical current on applied magnetic field can be well described by a model which takes into account different critical current densities (obtained from reference junctions) and different net magnetization of the multidomain ferromagnetic layer in both halves.
We study theoretically the properties of SIFS type Josephson junctions composed of two superconducting (S) electrodes separated by an insulating layer (I) and a ferromagnetic (F) film consisting of periodic magnetic domains structure with antiparallel magnetization directions in neighboring domains. The two-dimensional problem in the weak link area is solved analytically in the framework of the linearized quasiclassical Usadel equations. Based on this solution, the spatial distributions of the critical current density, $J_{C},$ in the domains and critical current, $I_{C},$ of SIFS structures are calculated as a function of domain wall parameters, as well as the thickness, $d_{F},$ and the width, $W,$ of the domains. We demonstrate that $I_{C}(d_{F},W)$ dependencies exhibit damped oscillations with the ratio of the decay length, $xi_{1},$ and oscillation period, $xi_{2},$ being a function of the parameters of the domains, and this ratio may take any value from zero to unity. Thus, we propose a new physical mechanism that may explain the essential difference between $xi_{1}$ and $xi_{2}$ observed experimentally in various types of SFS Josephson junctions.
Josephson junctions have broad applications in metrology, quantum information processing, and remote sensing. For these applications, the electronic noise is a limiting factor. In this work we study the thermal noise in narrow Josephson junctions using a tight-binding Hamiltonian. For a junction longer than the superconducting coherence length, several self-consistent gap profiles appear close to a phase difference $pi$. They correspond to two stable solutions with an approximately constant phase-gradient over the thin superconductor connected by a $2pi$ phase slip, and a solitonic branch. The current noise power spectrum has pronounced peaks at the transition frequencies between the different states in each branch. We find that the noise is reduced in the gradient branches in comparison to the zero-length junction limit. In contrast, the solitonic branch exhibits an enhanced noise and a reduced current due to the pinning of the lowest excitation energy to close to zero energy.
We present a detailed analysis of the dependence of the critical current I_c on the magnetic field B of 0, Pi, and 0-Pi superconductor-insulator-ferromagnet-superconductor Josephson junctions. I_c(B) of the 0 and Pi junction closely follows a Fraunhofer pattern, indicating a homogeneous critical current density j_c(x). The maximum of I_c(B) is slightly shifted along the field axis, pointing to a small remanent in-plane magnetization of the F-layer along the field axis. I_c(B) of the 0-Pi junction exhibits the characteristic central minimum. I_c however has a finite value here, due to an asymmetry of j_c in the 0 and Pi part. In addition, this I_c(B) exhibits asymmetric maxima and bumped minima. To explain these features in detail, flux penetration being different in the 0 part and the Pi part needs to be taken into account. We discuss this asymmetry in relation to the magnetic properties of the F-layer and the fabrication technique used to produce the 0-Pi junctions.
We study magnetization reversal in a $varphi_0$ Josephson junction with direct coupling between magnetic moment and Josephson current. Our simulations of magnetic moment dynamics show that by applying an electric current pulse, we can realize the full magnetization reversal. We propose different protocols of full magnetization reversal based on the variation of the Josephson junction and pulse parameters, particularly, electric current pulse amplitude, damping of magnetization and spin-orbit interaction. We discuss experiments which can probe the magnetization reversal in $varphi_0$-junctions.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
