Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userFocused-ion-beam-induced deposition of superconducting nanowires
75
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Superconducting nanowires, with a critical temperature of 5.2 K, have been synthesized using an ion-beam-induced deposition, with a Gallium focused ion beam and Tungsten Carboxyl, W(CO)6, as precursor. The films are amorphous, with atomic concentrations of about 40, 40, and 20 % for W, C, and Ga, respectively. Zero Kelvin values of the upper critical field and coherence length of 9.5 T and 5.9 nm, respectively, are deduced from the resistivity data at different applied magnetic fields. The critical current density is Jc= 1.5 10^5 A/cm2 at 3 K. This technique can be used as a template-free fabrication method for superconducting devices.
rate research
Read More
Superconducting nanowires can be fabricated by decomposition of an organometallic gas using a focused beam of Ga ions. However, physical damage and unintentional doping often results from the exposure to the ion beam, motivating the search for a means to achieve similar structures with a beam of electrons instead of ions. This has so far remained an experimental challenge. We report the fabrication of superconducting tungsten nanowires by electron-beam-induced-deposition, with critical temperature of 2.0 K and critical magnetic field of 3.7 T, and compare them with superconducting wires made with ions. This work opens up new possibilities for the realization of nanoscale superconducting devices, without the requirement of an ion beam column.
We have used a neon focused-ion-beam to fabricate both nanoscale Nb Dayem bridges and NbN phase-slip nanowires located at the short-circuited end of quarter-wavelength coplanar waveguide resonators. The Dayem bridge devices show flux-tunability and intrinsic quality factor exceeding 10,000 at 300 mK up to local fields of at least 60 mT. The NbN nanowires show signatures of incoherent quantum tunnelling of flux at 300 mK.
In a recent paper Tettamanzi et al (2009 Nanotechnology bf{20} 465302) describe the fabrication of superconducting Nb nanowires using a focused ion beam. They interpret their conductivity data in the framework of thermal and quantum phase slips below $T_c$. In the following we will argue that their analysis is inappropriate and incomplete, leading to contradictory results. Instead, we propose an interpretation of the data within a SN proximity model.
Making use of focused Ga-ion beam (FIB) fabrication technology, the evolution with device dimension of the low-temperature electrical properties of Nb nanowires has been examined in a regime where crossover from Josephson-like to insulating behaviour is evident. Resistance-temperature data for devices with a physical width of order 100 nm demonstrate suppression of superconductivity, leading to dissipative behaviour that is shown to be consistent with the activation of phase-slip below Tc. This study suggests that by exploiting the Ga-impurity poisoning introduced by the FIB into the periphery of the nanowire, a central superconducting phase-slip nanowire with sub-10 nm dimensions may be engineered within the core of the nanowire.
We present low-temperature measurements of low-loss superconducting nanowire-embedded resonators in the low-power limit relevant for quantum circuits. The superconducting resonators are embedded with superconducting nanowires with widths down to 20nm using a neon focused ion beam. In the low-power limit, we demonstrate an internal quality factor up to 3.9x10^5 at 300mK [implying a two-level-system-limited quality factor up to 2x10^5 at 10 mK], not only significantly higher than in similar devices but also matching the state of the art of conventional Josephson-junction-embedded resonators. We also show a high sensitivity of the nanowire to stray infrared photons, which is controllable by suitable precautions to minimize stray photons in the sample environment. Our results suggest that there are excellent prospects for superconducting-nanowire-based quantum circuits.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
