Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userThe role of C2 in nanocrystalline diamond growth
57
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
This paper presents findings from a study of nanocrystalline diamond (NCD) growth in a microwave plasma chemical vapour deposition (CVD) reactor. NCD films were grown using Ar/H2/CH4 and He/H2/CH4 gas compositions. The resulting films were characterised using Raman spectroscopy, scanning electron microscopy and atomic force microscopy. Analysis revealed an estimated grain size of the order of 50 nm, growth rates in the range 0.01 to 0.3 um/h and sp3 and sp2 bonded carbon content consistent with that expected for NCD. The C2 Swan band was probed using cavity ring-down spectroscopy (CRDS) to measure the absolute C2 (a) number density in the plasma during diamond film growth. The number density in the Ar/H2/CH4 plasmas was in the range 2 to 4 x 10^12 cm-3, but found to be present in quantities too low to measure in the He/H2/CH4 plasmas. Optical emission spectrometry (OES) was employed to determine the relative densities of the C2 excited state (d) in the plasma. The fact that similar NCD material was grown whether using Ar or He as the carrier gas suggests that C2 does not play a major role in the growth of nanocrystalline diamond.
rate research
Read More
We demonstrate locally coherent heteroepitaxial growth of silicon carbide (SiC) on diamond, a result contrary to current understanding of heterojunctions as the lattice mismatch exceeds $20%$. High-resolution transmission electron microscopy (HRTEM) confirms the quality and atomic structure near the interface. Guided by molecular dynamics simulations, a theoretical model is proposed for the interface wherein the large lattice strain is alleviated via point dislocations in a two-dimensional plane without forming extended defects in three dimensions. The possibility of realising heterojunctions of technologically important materials such as SiC with diamond offers promising pathways for thermal management of high power electronics. At a fundamental level, the study redefines our understanding of heterostructure formation with large lattice mismatch.
Boron-doped single crystal diamond films were grown homoepitaxially on synthetic (100) Type Ib diamond substrates using microwave plasma assisted chemical vapor deposition. A modification in surface morphology of the film with increasing boron concentration in the plasma has been observed using atomic force microscopy. Use of nitrogen during boron doping has been found to improve the surface morphology and the growth rate of films but it lowers the electrical conductivity of the film. The Raman spectra indicated a zone center optical phonon mode along with a few additional bands at the lower wavenumber regions. The change in the peak profile of the zone center optical phonon mode and its downshift were observed with the increasing boron content in the film. However, shrinkage and upshift of Raman line was observed in the film that was grown in presence of nitrogen along with diborane in process gas.
The novel aspect of the centre (NV-) in diamond is the high degree of spin polarisation achieved through optical illumination. In this paper it is shown that the spin polarisation occurs as a consequence of an electron-vibration interaction combined with spin-orbit interaction, and an electronic model involving these interactions is developed to account for the observed polarisation.
Some of the Multiferroics [1] form a rare class of materials that exhibit magnetoelectric coupling arising from the coexistence of ferromagnetism and ferroelectricity, with potential for many technological applications.[2,3] Over the last decade, an active research on multiferroics has resulted in the identification of a few routes that lead to multiferroicity in bulk materials.[4-6] While ferroelectricity in a classic ferroelectric such as BaTiO3 is expected to diminish with the reducing particle size,[7,8] ferromagnetism cannot occur in its bulk form.[9] Here, we use a combination of experiment and first-principles simulations to demonstrate that multiferroic nature emerges in intermediate size nanocrystalline BaTiO3, ferromagnetism arising from the oxygen vacancies at the surface and ferroelectricity from the core. A strong coupling between a surface polar phonon and spin is shown to result in a magnetocapacitance effect observed at room temperature, which can open up possibilities of new electro-magneto-mechanical devices at the nano-scale.
We demonstrate the controlled preparation of heteroepitaxial diamond nano- and microstructures on silicon wafer based iridium films as hosts for single color centers. Our approach uses electron beam lithography followed by reactive ion etching to pattern the carbon layer formed by bias enhanced nucleation on the iridium surface. In the subsequent chemical vapor deposition process, the patterned areas evolve into regular arrays of (001) oriented diamond nano-islands with diameters of <500nm and a height of approx. 60 nm. In the islands, we identify single SiV color centers with narrow zero phonon lines down to 1 nm at room temperature.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
