Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userExperimental demonstration of photonic crystal waveplates
89
0
0.0
(
0
)
Added by
Jandir Miguel Hickmann
Publication date
2003
fields
Physics
and research's language is
English
Ask ChatGPT about the research
No Arabic abstract
We have constructed and experimentally tested a microwave half waveplate using the dispersive birefringent properties of a bulk two-dimensional photonic crystal away from its band gap. Our waveplate device exhibited a 200:1 polarization contrast, limited by our experimental resolution. We anticipate that photonic crystal waveplates will have important practical applications in several areas, including integrated photonic circuits.
rate research
Read More
We demonstrate experimentally that the spectral broadening of CW supercontinuum can be controlled by using photonic crystal fibers with two zero-dispersion wavelengths pumped by an Yb fiber laser at 1064 nm. The spectrum is bounded by two dispersive waves whose spectral location depends on the two zero-dispersion wavelengths of the fiber. The bandwidth of the generated spectrum and the spectral power density may thus be tailored for particular applications, such as high-resolution optical coherence tomography or optical spectroscopy.
We experimentally demonstrate high Quality factor dual-polarized TE-TM photonic crystal nanobeam cavities. The free-standing nanobeams are fabricated in a 500 nm thick silicon layer, and are probed using both tapered optical fiber and free-space resonant scattering set-ups. We measure Q-factors greater than 10^4 for both TM and TE modes, and observe large fiber transmission drops (0.3 -- 0.4) at the TM mode resonances.
Modulated optical cavities have been proposed and demonstrated for applications in communications, laser frequency stabilization, microwave-to-optical conversion and frequency comb generation. However, most studies are restricted to the adiabatic regime, where either the maximum excursion of the modulation or the modulation frequency itself is below the linewidth of the cavity. Here, using a fiber ring resonator with an embedded electro-optic phase modulator, we investigate the nonadiabatic regime. By strongly driving the modulator at frequencies that are significantly smaller than the free-spectral range of the ring resonator, but well beyond the linewidth of the resonator, we experimentally observe counterintuitive behavior predicted in a recent theoretical study by Minkov et al. [APL Photonics 2, 076101 (2017)], such as the complete suppression of drop-port transmission even when the input laser wavelength is on resonance with the optical cavity. This can be understood as dynamical isolation of the cavity from the input light. We also show qualitative differences in the steady-state responses of the system between the adiabatic and nonadiabatic limits. Our experiments probe a seldom explored regime of operation that is promising for applications in integrated photonic systems with current state-of-the-art technology.
We report on lasing at room temperature and at telecommunications wavelength from photonic crystal nanocavities based on InAsP/InP quantum dots. Such laser cavities with a small modal volume and high quality factor display a high spontaneous emission coupling factor beta. Lasing is confirmed by measuring the second order autocorrelation function. A smooth transition from chaotic to coherent emission is observed, and coherent emission is obtained at 8 times the threshold power.
A simple procedure is demonstrated for fabrication of waveplates which can be released from substrate by laser cutting. Oblique angle deposition, chemical etching and laser inscription steps were used for the final lift-off and release of micro-waveplates in HCl solution.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
