Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userElectronic Transport through YBCO Grain Boundary Interfaces between 4.2 K and 300 K
114
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
The current-induced dissipation in YBCO grain boundary tunnel junctions has been measured between 4.2 K and 300 K. It is found that the resistance of 45 degree (100)/(110) junctions decreases linearly by a factor of four when their temperature is increased from 100 K to 300 K. At the superconducting transition temperature Tc the grain boundary resistance of the normal state and of the superconducting state extrapolate to the same value.
rate research
Read More
A dipper probe for broadband Ferromagnetic Resonance (FMR) operating from 4.2 K to room temperature is described. The apparatus is based on a 2-port transmitted microwave signal measurement with a grounded coplanar waveguide. The waveguide generates a microwave field and records the sample response. A 3-stage dipper design is adopted for fast and stable temperature control. The temperature variation due to FMR is in the milli-Kelvin range at liquid helium temperature. We also designed a novel FMR probe head with a spring-loaded sample holder. Improved signal-to-noise ratio and stability compared to a common FMR head are achieved. Using a superconducting vector magnet we demonstrate Gilbert damping measurements on two thin film samples using a vector network analyzer with frequency up to 26 GHz: 1) A Permalloy film of 5 nm thickness and 2) a CoFeB film of 1.5 nm thickness. Experiments were performed with the applied magnetic field parallel and perpendicular to the film plane.
The electrical resistivity rho_c of the underdoped cuprate superconductor YBCO was measured perpendicular to the CuO_2 planes on ultra-high quality single crystals in magnetic fields large enough to suppress superconductivity. The incoherent insulating-like behavior of rho_c at high temperature, characteristic of all underdoped cuprates, is found to cross over to a coherent regime of metallic behavior at low temperature. This crossover coincides with the emergence of the small electron pocket detected in the Fermi surface of YBCO via quantum oscillations, the Hall and Seebeck coefficients and with the detection of a unidirectional modulation of the charge density as seen by high-field NMR measurements. The low coherence temperature is quantitatively consistent with the small hopping integral t_perp inferred from the splitting of the quantum oscillation frequencies. We conclude that the Fermi-surface reconstruction in YBCO at dopings from p = 0.08 to at least p = 0.15, attributed to stripe order, produces a metallic state with 3D coherence deep in the underdoped regime.
A new hight Tc Fe-based compound system, AFe2As2 with A = K, Cs, K/Sr and Cs/Sr has been found. Through electron-doping, Tc of the A = K and Cs compounds rises to ~37 K, and finally enter a spin-density-wave state (SDW) through further electron doping with Sr. The observation demonstrates the crucial role of the (FeAs)-layers in the superconductivity in the Fe-based layered system and the special feature of elemental A-layers in this complex chemical system may provide new avenues to superconductivity at a higher Tc.
We have mapped the neutron scattering spin spectrum at low-energies in YBa2Cu3O6.353 (Tc=18 K) where the doping ~0.06 is near the critical value (pc=0.055) for superconductivity. No coexistence with long range ordered antiferromagnetism is found. The spins fluctuate on two energy scales, one a damped spin response with a ~2 meV relaxation rate and the other a central mode with a relaxation rate that slows to less than 0.08 meV below Tc. The spectrum mirrors that of a soft mode driving a central mode. Extremely short correlation lengths, 42+-5 Angstrom in-plane and 8+-2 Angstrom along the c direction, and isotropic spin orientations for the central mode indicate that the correlations are subcritical with respect to any second order transition to Neel order. The dynamics follows a model where damped spin fluctuations are coupled to the slow fluctuations of regions with correlations shortened by the hole doping.
Diamond is a material that offers potential in numerous device applications. In particular, highly boron doped diamond is attractive due to its superconductivity and high Youngs Modulus. The fabrication of stable, low resistance, ohmic contacts is essential to ensure proper device function. Previous work has established the efficacy of several methods of forming suitable contacts to diamond at room temperature and above, including carbide forming and carbon soluble metallisation schemes. Herein, the stability of several contact schemes (Ti, Cr, Mo, Ta and Pd) to highly boron doped nanocrystalline diamond was verified down to the cryogenic temperatures with modified Transmission Line Model (TLM) measurements. While all contact schemes remained ohmic, a significant temperature dependency is noted at Tc and at the lowest temperatures the contact resistances ranged from Ti/Pt/Au with ${(8.83 pm 0.10)times 10^{-4} :{Omega}.cm}$ to Ta/Pt/Au with ${(8.07 pm 0.62) times 10^{-6} :{Omega}.cm}$.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
