Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userINTEGRAL Cross-calibration Status
123
0
0.0
(
0
)
Authors
Piotr Lubinski
Ask ChatGPT about the research
No Arabic abstract
The status of the INTEGRAL cross-calibration is presented for a standard X-ray astronomy source, the Crab Nebula, as well as for some weaker sources. The relative flux normalization for the different INTEGRAL instruments is discussed together with spectral shape features.
rate research
Read More
The XMM-Newton observatory has the largest collecting area flown so far for an X-ray imaging system, resulting in a very high sensitivity over a broad spectral range. In order to exploit fully these performances, a very accurate calibration of the XMM-Newton instruments is required, and has led to an extensive ground and flight calibration program. We report here on the current status of the EPIC/MOS cameras calibrations, highlighting areas for which a reasonably good accuracy has been achieved, and noting points where further work is needed.
We summarize the current status of accelerator based neutrino crosssection measurements. We focus on the experimental challenges while also presenting the motivation for these measurements. Selected results are highlighted after a quick description of the current major collaborations working on the field.
Neutrino oscillations physics entered in the precision era. In this context accelerator-based neutrino experiments need a reduction of systematic errors to the level of a few percent. Today one of the most important sources of systematic errors are the neutrino-nucleus cross sections. The status of our knowledge of these cross sections in the different open channels in the few-GeV region, i.e. the quasielastic, the pion production and the multinucleon emission, is reviewed. Special emphasis is devoted to the multinucleon emission channel, which attracted a lot of attention in the last few years. It is crucial to properly reconstruct the neutrino energy which enters the expression of the oscillation probability. This channel was not included in the generators used for the analyses of the neutrino cross sections and oscillations experiments.
We present the new energy calibration of the ISGRI detector onboard INTEGRAL, that has been implemented in the Offline Scientific Analysis (OSA) version 10. With the previous OSA 9 version, a clear departure from stability of both W and 22Na background lines was observed after MJD 54307 (revolution ~583). To solve this problem, the energy correction in OSA 10 uses: 1) a new description for the gain depending on the time and the pulse rise time, 2) an improved temperature correction per module, and 3) a varying shape of the low threshold, corrected for the change in energy resolution. With OSA 10, both background lines show a remarkably stable behavior with a relative energy variation below 1% around the nominal position (>6% in OSA 9), and the energy reconstruction at low energies is more stable compared to previous O
Since the release of the INTEGRAL Offline Scientific Analysis (OSA) software version 9.0, the ghost busters module has been introduced in the INTEGRAL/IBIS imaging procedure, leading to an improvement of the sensitivity around bright sources up to a factor of 7. This module excludes in the deconvolution process the IBIS/ISGRI detector pixels corresponding to the projection of a bright source through mask elements affected by some defects. These defects are most likely associated with screws and glue fixing the IBIS mask to its support. Following these major improvements introduced in OSA 9, a second order correction is still required to further remove the residual noise, now at a level of 0.2-1% of the brightest source in the field of view. In order to improve our knowledge of the IBIS mask transparency, a calibration campaign has been carried out during 2010-2012. We present here the analysis of these data, together with archival observations of the Crab and Cyg X-1, that allowed us to build a composite image of the mask defects and to investigate the origin of the residual noise in the IBIS/ISGRI images. Thanks to this study, we were able to point out a simple modification of the ISGRI analysis software that allows to significantly improve the quality of the images in which bright sources are detected at the edge of the field of view. Moreover, a refinement of the area excluded by the ghost busters module is considered, and preliminary results show improvements to be further tested. Finally, this study indicates further directions to be investigated for improving the ISGRI sensitivity, such as taking into account the thickness of the screws in the mask model or studying the possible discrepancy between the modeled and actual mask element bridges.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
