No Arabic abstract
We perform a full 3D general relativistic magnetohydrodynamical (GRMHD) simulation of an equal-mass, spinning, binary black hole approaching merger, surrounded by a circumbinary disk and with a mini-disk around each black hole. For this purpose, we evolve the ideal GRMHD equations on top of an approximated spacetime for the binary that is valid in every position of space, including the black hole horizons, during the inspiral regime. We use relaxed initial data for the circumbinary disk from a previous long-term simulation, where the accretion is dominated by a $m=1$ overdensity called the lump. We compare our new spinning simulation with a previous non-spinning run, studying how spin influences the mini-disk properties. We analyze the accretion from the inner edge of the lump to the black hole, focusing on the angular momentum budget of the fluid around the mini-disks. We find that mini-disks in the spinning case have more mass over a cycle than the non-spinning case. However, in both cases, we find most of the mass received by the black holes is delivered by the direct plunging of material from the lump. We also analyze the morphology and variability of the electromagnetic fluxes and we find they share the same periodicities of the accretion rate. In the spinning case, we find that the outflows are $8$ times stronger than the non-spinning case. Our results will be useful to understand and produce realistic synthetic light curves and spectra, which can be used in future observations.
Supermassive black hole binaries are likely to accrete interstellar gas through a circumbinary disk. Shortly before merger, the inner portions of this circumbinary disk are subject to general relativistic effects. To study this regime, we approximate the spacetime metric of close orbiting black holes by superimposing two boosted Kerr-Schild terms. After demonstrating the quality of this approximation, we carry out very long-term general relativistic magnetohydrodynamic simulations of the circumbinary disk. We consider black holes with spin dimensionless parameters of magnitude 0.9, in one simulation parallel to the orbital angular momentum of the binary, but in another anti-parallel. These are contrasted with spinless simulations. We find that, for a fixed surface mass density in the inner circumbinary disk, aligned spins of this magnitude approximately reduce the mass accretion rate by 14% and counter-aligned spins increase it by 45%, leaving many other disk properties unchanged.
Recently, the direct detection of gravitational waves from black hole (BH) mergers was announced by the Advanced LIGO Collaboration. Multi-messenger counterparts of stellar-mass BH mergers are of interest, and it had been suggested that a small disk or celestial body may be involved in the binary of two BHs. To test such possibilities, we consider the fate of a wind powered by an active mini-disk in a relatively short, super-Eddington accretion episode onto a BH with ~10-100 solar masses. We show that its thermal emission could be seen as a fast optical transient with the duration from hours to days. We also find that the coasting outflow forms external shocks due to interaction with the interstellar medium, whose synchrotron emission might be expected in the radio band on a time scale of years. Finally, we also discuss a possible jet component and the associated high-energy neutrino emission as well as ultra-high-energy cosmic-ray acceleration.
We study the structure and properties of hot MHD accretion onto a Kerr black hole. In such a system, the hole is magnetically coupled to the inflowing gas and exerts a torque onto the accretion flow. A hot settling flow can form around the hole and transport the angular momentum outward, to the outer edge of the flow. Unlike other hot flows, such as advection- and convection-dominated flows and inflow-outflow solutions (ADAFs, CDAFs, and ADIOS), the properties of the hot settling flow are determined by the spin of the central black hole, but are insensitive to the mass accretion rate. Therefore, it may be possible to identify rapidly spinning BHs simply from their broad-band spectra. Observationally, the hot settling flow around a Kerr hole is somewhat similar to other hot flows in that they all have hard, power-law spectra and relatively low luminosities. Thus, most black hole candidates in the low/hard and, perhaps, intermediate X-ray state may potentially accrete via the hot settling flow. However, a settling flow will be somewhat more luminous than ADAFs/CDAFs/ADIOS, will exhibit high variability in X-rays, and may have relativistic jets. This suggests that galactic microquasars and active galactic nuclei may be powered by hot settling flows. We identify several galactic X-ray sources as the best candidates.
Models of jet production in black hole systems suggest that the properties of the accretion disk - such as its mass accretion rate, inner radius, and emergent magnetic field - should drive and modulate the production of relativistic jets. Stellar-mass black holes in the low/hard state are an excellent laboratory in which to study disk-jet connections, but few coordinated observations are made using spectrometers that can incisively probe the inner disk. We report on a series of 20 Suzaku observations of Cygnus X-1 made in the jet-producing low/hard state. Contemporaneous radio monitoring was done using the Arcminute MicroKelvin Array radio telescope. Two important and simple results are obtained: (1) the jet (as traced by radio flux) does not appear to be modulated by changes in the inner radius of the accretion disk; and (2) the jet is sensitive to disk properties, including its flux, temperature, and ionization. Some more complex results may reveal aspects of a coupled disk-corona-jet system. A positive correlation between the reflected X-ray flux and radio flux may represent specific support for a plasma ejection model of the corona, wherein the base of a jet produces hard X-ray emission. Within the framework of the plasma ejection model, the spectra suggest a jet base with v/c ~ 0.3, or the escape velocity for a vertical height of z ~ 20 GM/c^2 above the black hole. The detailed results of X-ray disk continuum and reflection modeling also suggest a height of z ~ 20 GM/c^2 for hard X-ray production above a black hole, with a spin in the range 0.6 < a < 0.99. This height agrees with X-ray time lags recently found in Cygnus X-1. The overall picture that emerges from this study is broadly consistent with some jet-focused models for black hole spectral energy distributions in which a relativistic plasma is accelerated at z = 10-100 GM/c^2.
It is widely accepted that quasars and other active galactic nuclei (AGN) are powered by accretion of matter onto a central supermassive black hole. While numerical simulations have demonstrated the importance of magnetic fields in generating the turbulence believed necessary for accretion, so far they have not produced the high mass accretion rates required to explain the most powerful sources. We describe new global 3D simulations we are developing to assess the importance of radiation and non-ideal MHD in generating magnetized outflows that can enhance the overall rates of angular momentum transport and mass accretion.