Do you want to publish a course? Click here

Optimal design of a superconducting transmon qubit with tapered wiring

331   0   0.0 ( 0 )
 Added by John Martinis
 Publication date 2021
  fields Physics
and research's language is English




Ask ChatGPT about the research

Analytical formulas are presented for simplified but useful qubit geometries that predict surface dielectric loss when its thickness is much less than the metal thickness, the limiting case needed for real devices. These formulas can thus be used to precisely predict loss and optimize the qubit layout. Surprisingly, a significant fraction of surface loss comes from the small wire that connects the Josephson junction to the qubit capacitor. Tapering this wire is shown to significantly lower its loss. Also predicted are the size and density of the two-level state (TLS) spectrum from individual surface dissipation sites.



rate research

Read More

We present a hybrid semiconductor-based superconducting qubit device which remains coherent at magnetic fields up to 1 T. The qubit transition frequency exhibits periodic oscillations with magnetic field, consistent with interference effects due to the magnetic flux threading the cross section of the proximitized semiconductor nanowire junction. As induced superconductivity revives, additional coherent modes emerge at high magnetic fields, which we attribute to the interaction of the qubit and low-energy Andreev states.
We present a detailed characterization of coherence in seven transmon qubits in a circuit QED architecture. We find that spontaneous emission rates are strongly influenced by far off-resonant modes of the cavity and can be understood within a semiclassical circuit model. A careful analysis of the spontaneous qubit decay into a microwave transmission-line cavity can accurately predict the qubit lifetimes over two orders of magnitude in time and more than an octave in frequency. Coherence times $T_1$ and $T_2^*$ of more than a microsecond are reproducibly demonstrated.
By using the dry etching process of tantalum (Ta) film, we had obtained transmon qubit with the best lifetime (T1) 503 us, suggesting that the dry etching process can be adopted in the following multi-qubit fabrication with Ta film. We also compared the relaxation and coherence times of transmons made with different materials (Ta, Nb and Al) with the same design and fabrication processes of Josephson junction, we found that samples prepared with Ta film had the best performance, followed by those with Al film and Nb film. We inferred that the reason for this difference was due to the different loss of oxide materials located at the metal-air interface.
149 - J. Q. You , Xuedong Hu , S. Ashhab 2009
This Comment has been withdrawn according to a mutual agreement between the authors of the original paper and the authors of this Comment.
We introduce a new hybrid qubit consisting of a Majorana qubit interacting with a transmon longitudinally coupled to a resonator. To do so, we equip the longitudinal transmon qubit with topological quasiparticles, supported by an array of heterostructure nanowires, and derive charge- and phase-based interactions between the Majorana qubit and the resonator and transmon degrees of freedom. Inspecting the charge coupling, we demonstrate that the Majorana self-charging can be eliminated by a judicious choice of charge offset, thereby maintaining the Majorana degeneracy regardless of the quasiparticles spatial arrangement and parity configuration. We perform analytic and numerical calculations to derive the effective qubit-qubit interaction elements and discuss their potential utility for state readout and quantum error correction. Further, we find that select interactions depend strongly on the overall superconducting parity, which may provide a direct mechanism to characterize deleterious quasiparticle poisoning processes.
comments
Fetching comments Fetching comments
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا