Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userPhotorefractive effect in LiNbO$_3$-based integrated-optical circuits for continuous variable experiments
253
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We investigate the impact of photorefractive effect on lithium niobate integrated quantum photonic circuits dedicated to continuous variable on-chip experiments. The circuit main building blocks, i.e. cavities, directional couplers, and periodically poled nonlinear waveguides are studied. This work demonstrates that, even when the effect of photorefractivity is weaker than spatial mode hopping, they might compromise the success of on-chip quantum photonics experiments. We describe in detail the characterization methods leading to the identification of this possible issue. We also study to which extent device heating represents a viable solution to counter this effect. We focus on photorefractive effect induced by light at 775 nm, in the context of the generation of non-classical light at 1550 nm telecom wavelength.
rate research
Read More
In this paper, we present a novel concept for a multi-channel swept source optical coherence tomography (OCT) system based on photonic integrated circuits (PICs). At the core of this concept is a low-loss polarization dependent path routing approach allowing for lower excess loss compared to previously shown PIC-based OCT systems, facilitating a parallelization of measurement units. As a proof of concept for the low-loss path routing, a silicon nitride PIC-based single-channel swept source OCT system operating at 840 nm was implemented and used to acquire in-vivo tomograms of a human retina. The fabrication of the PIC was done via CMOS-compatible plasma-enhanced chemical vapor deposition to allow future monolithic co-integration with photodiodes and read-out electronics. A performance analysis using the results of the implemented photonic building blocks shows a potential tenfold increase of the acquisition speed for a multi-channel system compared to an ideal lossless single-channel system with the same signal-to-noise ratio.
In a new branch of quantum computing, information is encoded into coherent states, the primary carriers of optical communication. To exploit it, quantum bits of these coherent states are needed, but it is notoriously hard to make superpositions of such continuous-variable states. We have realized the complete engineering and characterization of a qubit of two optical continuous-variable states. Using squeezed vacuum as a resource and a special photon subtraction technique, we could with high precision prepare an arbitrary superposition of squeezed vacuum and a squeezed single photon. This could lead the way to demonstrations of coherent state quantum computing.
Valley pseudospin, a new degree of freedom in photonic lattices, provides an intriguing way to manipulate photons and enhance the robustness of optical networks. Here we experimentally demonstrated topological waveguiding, refracting, resonating, and routing of valley-polarized photons in integrated circuits. Specifically, we show that at the domain wall between photonic crystals of different topological valley phases, there exists a topologically protected valley kink state that is backscattering-free at sharp bends and terminals. We further harnessed these valley kink states for constructing high-Q topological photonic crystal cavities with tortuously shaped cavity geometries. We also demonstrated a novel optical routing scheme at an intersection of multiple valley kink states, where light splits counterintuitively due to the valley pseudospin of photons. These results will not only lead to robust optical communication and signal processing, but also open the door for fundamental research of topological photonics in areas such as lasing, quantum photon-pair generation, and optomechanics.
We propose and demonstrate a modular architecture for reconfigurable on-chip linear-optical circuits. Each module contains 10 independent phase-controlled Mach-Zehnder interferometers; several such modules can be connected to each other to build large reconfigurable interferometers. With this architecture, large interferometers are easier to build and characterize than with traditional, bespoke, monolithic designs. We demonstrate our approach by fabricating three modules in the form of UV-written silica-on-silicon chips. We characterize these chips, connect them to each other, and implement a wide range of linear optical transformations. We envisage that this architecture will enable many future experiments in quantum optics.
We provide an explicit construction of a universal gate set for continuous-variable quantum computation with microwave circuits. Such a universal set has been first proposed in quantum-optical setups, but its experimental implementation has remained elusive in that domain due to the difficulties in engineering strong nonlinearities. Here, we show that a realistic three-wave mixing microwave architecture based on the SNAIL [Frattini et al., Appl. Phys. Lett. 110, 222603 (2017)] allows us to overcome this difficulty. As an application, we show that this architecture allows for the generation of a cubic phase state with an experimentally feasible procedure. This work highlights a practical advantage of microwave circuits with respect to optical systems for the purpose of engineering non-Gaussian states, and opens the quest for continuous-variable algorithms based on few repetitions of elementary gates from the continuous-variable universal set.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
