Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userExperimental demonstration of crowd synchrony and first-order transition with lasers
77
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Crowd synchrony, which corresponds to the synchronization of different and independent oscillators that interact with each other via a common intermediate, is ubiquitous in many fields. Here, we experimentally demonstrate the effect of crowd synchrony, analogous to that of the Millennium Bridge, by resorting to coupled lasers. When the number of lasers is below a critical number, there is no synchronization, but after reaching the critical number, the lasers instantaneously synchronize. We show that the synchronization of the lasers as a function of their number follows a first-order-like transition, and that our experimental results are in good agreement with those predicted by theoretical models.
rate research
Read More
Recently, the coexistence of parity-time (PT) symmetric laser and absorber has gained tremendous research attention. While the PT symmetric absorber has been observed in microwave metamaterials, the experimental demonstration of PT symmetric laser is still absent. Here we experimentally study PT-symmetric laser absorber in stripe waveguide. Using the concept of PT symmetry to exploit the light amplification and absorption, PT-symmetric laser absorbers have been successfully obtained. Different from the single-mode PT symmetric lasers, the PT-symmetric stripe lasers have been experimentally confirmed by comparing the relative wavelength positions and mode spacing under different pumping conditions. When the waveguide is half pumped, the mode spacing is doubled and the lasing wavelengths shift to the center of every two initial lasing modes. All these observations are consistent with the theoretical predictions and confirm the PT-symmetry breaking well.
Frequency pulling is a well-known phenomenon in standard laser physics, leading to a shift of the laser frequency when the cavity and maximum gain frequencies are detuned. In this letter we present the first experimental demonstration of frequency pulling in single-pass free-electron lasers. Measurements are performed using the single-pass free-electron laser installed on the Elettra storage ring.
Critical phenomena in complex networks, and the emergence of dynamical abrupt transitions in the macroscopic state of the system are currently a subject of the outmost interest. We report evidence of an explosive phase synchronization in networks of chaotic units. Namely, by means of both extensive simulations of networks made up of chaotic units, and validation with an experiment of electronic circuits in a star configuration, we demonstrate the existence of a first order transition towards synchronization of the phases of the networked units. Our findings constitute the first prove of this kind of synchronization in practice, thus opening the path to its use in real-world applications.
Mode-locked lasers exhibit complex nonlinear dynamics. Precise observation of these dynamics will aid in understanding of the underlying physics and provide new insights for laser design and applications. The starting dynamics, from initial noise fluctuations to the mode-locking regime, have previously been observed directly by time-stretched transform-based real-time spectroscopy. However, the regime transition dynamics, which are essential processes in mode-locked lasers, have not yet been resolved because regime transition process tracking is very challenging. Here we demonstrate the first insight into the regime transition dynamics enabled by our design of a real-time programmable mode-locked fibre laser, in which different operating regimes can be achieved and switched automatically. The regime transition dynamics among initial noise fluctuations, Q-switching, fundamental mode-locking and harmonic mode-locking regimes have been observed and thoroughly analysed by both temporal and spectral means. These findings will enrich our understanding of the complex dynamics inside mode-locked lasers.
We present the design, fabrication and initial characterization of a paddle nanocavity consisting of a suspended sub-picogram nanomechanical resonator optomechanically coupled to a photonic crystal nanocavity. The optical and mechanical properties of the paddle nanocavity can be systematically designed and optimized, and key characteristics including mechanical frequency easily tailored. Measurements under ambient conditions of a silicon paddle nanocavity demonstrate an optical mode with quality factor $Q_o$ ~ 6000 near 1550 nm, and optomechanical coupling to several mechanical resonances with frequencies $omega_m/2pi$ ~ 12-64 MHz, effective masses $m_text{eff}$ ~ 350-650 fg, and mechanical quality factors $Q_m$ ~ 44-327. Paddle nanocavities are promising for optomechanical sensing and nonlinear optomechanics experiments.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
