Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userInfluence of the surface viscous stress on the pinch-off of free surfaces loaded with nearly-inviscid surfactants
146
0
0.0
(
0
)
Added by
Alberto Ponce-Torres PhD.
Publication date
2020
fields
Physics
and research's language is
English
Ask ChatGPT about the research
No Arabic abstract
We analyze both theoretically and experimentally the breakup of a pendant water droplet loaded with Sodium Dodecyl Sulfate (SDS). The free surface minimum radius measured in the experiments is compared with that obtained from a numerical solution of the full Navier-Stokes equations for different values of the shear and dilatational surface viscosities. This comparison shows the small but measurable effect of the surface viscous stresses on the system dynamics for sufficiently small spatiotemporal distances from the breakup point, and allows to establish upper bounds for the values of the shear and dilatational viscosities. We study numerically the distribution of Marangoni and viscous stresses over the free surface as a function of the time to the pinching, and describe how surface viscous stresses grow in the pinching region as the free surface approaches its breakup. When Marangoni and surface viscosity stresses are taken into account, the surfactant is not swept away from the thread neck in the time interval analyzed. Surface viscous stresses eventually balance the driving capillary pressure in that region for small enough values of the time to pinching. Based on this result, we propose a scaling law to account for the effect of the surface viscosities on the last stage of the temporal evolution of the neck radius.
rate research
Read More
The dynamics of wetting and dewetting is largely determined by the velocity field near the contact lines. For water drops it has been observed that adding surfactant decreases the dynamic receding contact angle even at a concentration much lower than the critical micelle concentration (CMC). To better understand why surfactants have such a drastic effect on drop dynamics, we constructed a dedicated a setup on an inverted microscope, in which an aqueous drop is held stationary while the transparent substrate is moved horizontally. Using astigmatism particle tracking velocimetry, we track the 3D displacement of the tracer particles in the flow. We study how surfactants alter the flow dynamics near the receding contact line of a moving drop for capillary numbers in the order of $10^{-6}$. Even for surfactant concentrations $c$ far below the critical micelle concentration ($c ll$ CMC) Marangoni stresses change the flow drastically. We discuss our results first in a 2D model that considers advective and diffusive surfactant transport and deduce estimates of the magnitude and scaling of the Marangoni stress from this. Modeling and experiment agree that a tiny gradient in surface tension of a few $mu N , m^{-1}$ is enough to alter the flow profile significantly. The variation of the Marangoni stress with the distance from the contact line suggests that the 2D advection-diffusion model has to be extended to a full 3D model. The effect is ubiquitous, since surfactant is present in many technical and natural dewetting processes either deliberately or as contamination.
In this paper we present experimental and numerical studies of the electrohydrodynamic stretching of a sub-millimetre-sized salt water drop, immersed in oil with added non-ionic surfactant, and subjected to a suddenly applied electric field of magnitude approaching 1 kV/mm. By varying the drop size, electric field strength and surfactant concentration we cover the whole range of electric capillary numbers ($Ca_E$) from 0 up to the limit of drop disintegration. The results are compared with the analytical result by Taylor (1964) which predicts the asymptotic deformation as a function of $Ca_E$. We find that the addition of surfactant damps the transient oscillations and that the drops may be stretched slightly beyond the stability limit found by Taylor. We proceed to study the damping of the oscillations, and show that increasing the surfactant concentration has a dual effect of first increasing the damping at low concentrations, and then increasing the asymptotic deformation at higher concentrations. We explain this by comparing the Marangoni forces and the interfacial tension as the drops deform. Finally, we have observed in the experiments a significant hysteresis effect when drops in oil with large concentration of surfactant are subjected to repeated deformations with increasing electric field strengths. This effect is not attributable to the flow nor the interfacial surfactant transport.
We consider extensional flows of a dense layer of spheres in a viscous fluid and employ force and torque balances to determine the trajectory of particle pairs that contribute to the stress. In doing this, we use Stokesian dynamics simulations to guide the choice of the near-contacting pairs that follow such a trajectory. We specify the boundary conditions on the representative trajectory, and determine the distribution of particles along it and how the stress depends on the microstructure and strain rate. We test the resulting predictions using the numerical simulations. Also, we show that the relation between the tensors of stress and strain rate involves the second and fourth moments of the particle distribution function.
A charged droplet can be electrodynamically levitated in the air using a quadrupole trap by typically applying a sinusoidal electric field. When a charged drop is levitated it exhibits surface oscillations simultaneously building charge density due to continuous evaporation and subsequently undergoes breakup due to Rayleigh instability. In this work, we examined large-amplitude surface oscillations of a sub-Rayleigh charged drop and its subsequent breakup, levitated by various applied signals such as sine, square and ramp waveform at various imposed frequencies, using high-speed imaging (recorded at 100-130 thousand Frames Per Second (fps)). It is observed that the drop surface oscillates in sphere-prolate-sphere-oblate (SPSO) mode and seldom in the sphere-prolate-sphere (SPS) mode depending on the intricate interplay of various forces due to charge(q), the intensity of applied field ($Lambda$) and shift of the droplet from the geometric center of the trap ($z_{shift}$). The Fast Fourier Transformation (FFT) analysis shows that the droplet oscillates with the forced frequency irrespective of the type of the applied waveform. While in the sinusoidal case, the nonlinearities are significant, in the square and ramp potentials, there is an admittance of all the harmonic frequencies of the applied potential. Interestingly, the breakup characteristics of a critically charged droplet is found to be unaffected by the type of the applied waveform. The experimental observations are validated with an analytical theory as well as with the Boundary Integral (BI) simulations in the potential flow limit and the results are found to be in a reasonable agreement.
The dynamics of the development of instability of the free surface of liquid helium, which is charged by electrons localized above it, is studied. It is shown that, if the charge completely screens the electric field above the surface and its magnitude is much larger then the instability threshold, the asymptotic behavior of the system can be described by the well-known 3D Laplacian growth equations. The integrability of these equations in 2D geometry makes it possible to described the evolution of the surface up to the formation of singularities, viz., cuspidal point at which the electric field strength, the velocity of the liquid, and the curvature of its surface assume infinitely large values. The exact solutions obtained for the problem of the electrocapillary wave profile at the boundary of liquid helium indicate the tendency to a charge in the surface topology as a result of formation of charged bubbles.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
