Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userInsight into perovskite antiferroelectric phases: Landau theory and phase field study
76
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Understanding the appearance of commensurate and incommensurate modulations in perovskite antiferroelectrics (AFEs) is of great importance for material design and engineering. The dielectric and elastic properties of the AFE domain boundaries are lack of investigation. In this work, a novel Landau theory is proposed to understand the transformation of AFE commensurate and incommensurate phases, by considering the coupling between the oxygen octahedral tilt mode and the polar mode. The derived relationship between the modulation periodicity and temperature is in good agreement with the experimental results. Using the phase field study, we show that the polarization is suppressed at the AFE domain boundaries, contributing to a remnant polarization and local elastic stress field in AFE incommensurate phases.
rate research
Read More
Oxygen is widely used to tune the performance of chalcogenide phase-change materials in the usage of phase-Change random access memory (PCRAM) which is considered as the most promising next-generation non-volatile memory. However, the microscopic role of oxygen in the write-erase process, i.e., the reversible phase transition between crystalline and amorphous state of phase-change materials is not clear yet. Using oxygen doped GeTe as an example, this work unravels the role of oxygen at the atomic scale by means of ab initio total energy calculations and ab initio molecular dynamics simulations. Our main finding is that after the amorphization and the subsequent re-crystallization process simulated by ab initio molecular dynamics, oxygen will drag one Ge atom out of its lattice site and both atoms stay in the interstitial region near the Te vacancy that was originally occupied by the oxygen, forming a dumbbell-like defect (O-VTe-Ge), which is in sharp contrast to the results of ab initio total energy calculations at 0 K showing that the oxygen prefers to substitute Te in crystalline GeTe. This specific defect configuration is found to be responsible for the slower crystallization speed and hence the improved data retention of oxygen doped GeTe as reported in recent experimental work. Moreover, we find that the oxygen will increase the effective mass of the carrier and thus increases the resistivity of GeTe. Our results unravel the microscopic mechanism of the oxygen-doping optimization of phase-change material GeTe, and the present reported mechanism can be applied to other oxygen doped ternary chalcogenide phase-change materials.
Understanding the formation of lead halide (LH) perovskite solution precursors is crucial to gain insight into the evolution of these materials to thin films for solar cells. Using density-functional theory in conjunction with the polarizable continuum model, we investigate 18 complexes with chemical formula PbX$_2$M$_4$, where X = Cl, Br, I and M are common solvent molecules. Through the analysis of structural properties, binding energies, and charge distributions, we clarify the role of halogen species and solvent molecules in the formation of LH perovskite precursors. We find that interatomic distances are critically affected by the halogen species, while the energetic stability is driven by the solvent coordination to the backbones. Regardless of the solvent, lead iodide complexes are more strongly bound than the others. Based on the charge distribution analysis, we find that all solvent molecules bind covalently with the LH backbones and that Pb-I and Pb-Br bonds lose ionicity in solution. Our results contribute to clarify the physical properties of LH perovskite solution precursors and offer a valuable starting point for further investigations on their crystalline intermediates.
We provide a combined theoretical and experimental study of the electronic structure and the optical absorption edge of the orthorhombic perovskite LaInO$_{3}$. Employing density-functional theory and many-body perturbation theory, we predict a direct electronic quasiparticle band gap of about 5 eV and an effective electron (hole) mass of 0.31 (0.48) m$_{0}$. We find the lowest-energy excitation at 0.2 eV below the fundamental gap, reflecting a sizeable electron-hole attraction. Since the transition from the valence band maximum (VBM, $Gamma$ point) is, however, dipole forbidden the onset is characterized by weak excitations from transitions around it. The first intense excitation appears about 0.32 eV above. Interestingly, this value coincides with an experimental value obtained by ellipsometry (4.80 eV) which is higher than the onset from optical absorption spectroscopy (4.35 eV). The latter discrepancy is attributed to the fact that the weak transitions that define the optical gap are not resolved by the ellipsometry measurement. The absorption edge shows a strong dependency on the light polarization, reflecting the character of the involved valence states. Temperature-dependent measurements show a redshift of the optical gap by about 120 meV by increasing the temperature from 5 to 300 K. Renormalization due to zero-point vibrations is extrapolated from the latter measurement to amount to 150 meV. By adding the excitonic binding energy of 0.2 eV obtained theoretically to the experimental optical absorption onset, we determine the fundamental band gap at room temperature to be 4.55 eV.
Considering the recent breakthroughs in the synthesis of novel two-dimensional (2D) materials from layered bulk structures, ternary layered transition metal borides, known as MAB phases, have come under scrutiny as a means of obtaining novel 2D transition metal borides, so-called MBene. Here, based on a set of phonon calculations, we show the dynamic stability of many Al-containing MAB phases, MAlB (M = Ti, Hf, V, Nb, Ta, Cr, Mo, W, Mn, Tc), M$_2$AlB$_2$ (Sc, Ti, Zr, Hf, V, Cr, Mo, W, Mn, Tc, Fe, Rh, Ni), M$_3$Al$_2$B$_2$ (M = Sc, T, Zr, Hf, Cr, Mn, Tc, Fe, Ru, Ni), M$_3$AlB$_4$ (M = Sc, Ti, Zr, Hf, V, Nb, Ta, Cr, Mo, W, Mn, Fe), and M$_4$AlB$_6$ (M = Sc, Ti, Zr, Hf, V, Nb, Ta, Cr, Mo). By comparing the formation energies of these MAB phases with those of their available competing binary M$-$B and M$-$Al, and ternary M$-$Al$-$B phases, we find that some of the Sc-, Ti-, V-, Cr-, Mo-, W-, Mn-, Tc-, and Fe-based MAB phases could be favorably synthesized in an appropriate experimental condition. In addition, by examining the strengths of various bonds in MAB phases via crystal orbital Hamilton population and spring constant calculations, we find that the B$-$B and then M$-$B bonds are stiffer than the M$-$Al and Al$-$B bonds. The different strength between these bonds implies the etching possibility of Al atoms from MAB phases, consequently forming various 2D MB, M$_2$B$_3$, and M$_3$B$_4$ MBenes. Furthermore, we employ the nudged elastic band method to investigate the possibility of the structural phase transformation of the 2D MB MBenes into graphene-like boron sheets sandwiched between transition metals and find that the energy barrier of the transformation is less than $0.4$ eV/atom.
Crystalline materials with broken inversion symmetry can exhibit a spontaneous electric polarization, which originates from a microscopic electric dipole moment. Long-range polar or anti-polar order of such permanent dipoles gives rise to ferroelectricity or antiferroelectricity, respectively. However, the recently discovered antiferroelectrics of fluorite structure (HfO$_2$ and ZrO$_2$) are different: A non-polar phase transforms into a polar phase by spontaneous inversion symmetry breaking upon the application of an electric field. Here, we show that this structural transition in antiferroelectric ZrO$_2$ gives rise to a negative capacitance, which is promising for overcoming the fundamental limits of energy efficiency in electronics. Our findings provide insight into the thermodynamically forbidden region of the antiferroelectric transition in ZrO$_2$ and extend the concept of negative capacitance beyond ferroelectricity. This shows that negative capacitance is a more general phenomenon than previously thought and can be expected in a much broader range of materials exhibiting structural phase transitions.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
