Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userEuropas surface water ice crystallinity: Discrepancy between observations and thermophysical and particle flux modeling
175
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Physical processing of Europan surface water ice by thermal relaxation, charged particle bombardment, and possible cryovolcanic activity can alter the percentage of the crystalline form of water ice compared to that of the amorphous form of water ice (the crystallinity) on Europas surface. The timescales over which amorphous water ice is thermally transformed to crystalline water ice at Europan surface temperatures suggests that the water ice there should be primarily in the crystalline form, however, surface bombardment by charged particles induced by Jupiters magnetic field, and vapor deposition of water ice from Europan plumes, can produce amorphous water ice surface deposits on short timescales. The purpose of this investigation is to determine whether the Europan surface water ice crystallinity derived from ground-based spectroscopic measurements is in agreement with the crystallinity expected based on temperature and radiation modeling. Using a 1D thermophysical model of Europas surface, we calculate a full-disk crystallinity of Europas leading hemisphere by incorporating the thermal relaxation of amorphous to crystalline water ice and the degradation of crystalline to amorphous water ice by irradiation. Concurrently, we derive the full-disk crystallinity of Europas leading hemisphere using a comparison of near-infrared ground-based spectral observations from Grundy et al. (1999), Busarev et al. (2018), and the Apache Point Observatory with laboratory spectra from Mastrapa et al. (2018) and the Ice Spectroscopy Lab at the Jet Propulsion Laboratory. We calculate a modeled crystallinity significantly higher than crystallinities derived from ground-based observations and laboratory spectra. This discrepancy may be a result of geophysical processes, such as by vapor-deposited plume material, or it may arise from assumptions and uncertainties in the crystallinity calculations.
rate research
Read More
In this paper, we look at space weathering processes on the icy surface of Jupiters moon Europa. The heavy energetic ions of the Jovian plasma (H+, O+, S+, C+) can erode the surface of Europa via ion sputtering (IS), ejecting up to 1000 H2O molecules per ion. UV Photons impinging the Europas surface can also result in neutral atom release via photon-stimulated desorption (PSD) and chemical change (photolysis). In this work, we study the efficiency of the IS and PSD processes for ejecting water molecules, simulating the resulting neutral H2O density. We also estimate the contribution to the total neutral atom release by the Ion Backscattering (IBS) process. Moreover, we estimate the possibility of detecting the sputtered high energy atoms, in order to distinguish the action of the IS process from other surface release mechanisms. Our main results are: 1) The most significant sputtered-particle flux and the largest contribution to the neutral H2O-density come from the incident S+ ions; 2) The H2O density produced via PSD is lower than that due to sputtering by ~1.5 orders of magnitude; 3) In the energy range below 1 keV, the IBS can be considered negligible for the production of neutrals, whereas in the higher energy range it becomes the dominant neutral emission mechanism; 4) the total sputtering rate for Europa is 2.0cdot 1027 H2O s-1; 5) the fraction of escaping H2O via IS is 22% of the total sputtered population, while the escape fraction for H2O produced by PSD is 30% of the total PSD population. Since the PSD exosphere is lower than the IS one, the major agent for Europas surface erosion is IS on both the non-illuminated and illuminated side. Lastly, the exospheric neutral density, estimated from the Galileo electron density measurements appears to be higher than that calculated for H2O alone; this favours the scenario of the presence of O2 produced by radiolysis and photolysis.
We performed numerical simulations of impact crater formation on Europa to infer the thickness and structure of its ice shell. The simulations were performed using iSALE to test both the conductive ice shell over ocean and the conductive lid over warm convective ice scenarios for a variety of conditions. The modeled crater depth-diameter is strongly dependent on thermal gradient and temperature of the warm convective ice. Our results indicate that both a fully conductive (thin) shell and a conductive-convective (thick) shell can reproduce the observed crater depth-diameter and morphologies. For the conductive ice shell over ocean, the best fit is an approximately 8 km thick conductive ice shell. Depending on the temperature (255 - 265 K) and therefore strength of warm convective ice, the thickness of the conductive ice lid is estimated at 5 - 7 km. If central features within the crater, such as pits and domes, form during crater collapse, our simulations are in better agreement with the fully conductive shell (thin shell). If central features form well after the impact, however, our simulations suggest a conductive-convective shell (thick shell) is more likely. Although our study does not provide firm conclusion regarding the thickness of Europas ice shell, our work indicates that Valhalla-class multiring basins on Europa may provide robust constraints on the thickness of Europas ice shell.
Much of the geologic activity preserved on Europas icy surface has been attributed to tidal deformation, mainly due to Europas eccentric orbit. Although the surface is geologically young (30 - 80 Myr), there is little information as to whether tidally-driven surface processes are ongoing. However, a recent detection of water vapor near Europas south pole suggests that it may be geologically active. Initial observations indicated that Europas plume eruptions are time-variable and may be linked to its tidal cycle. Saturns moon, Enceladus, which shares many similar traits with Europa, displays tidally-modulated plume eruptions, which bolstered this interpretation. However, additional observations of Europa at the same time in its orbit failed to yield a plume detection, casting doubt on the tidal control hypothesis. The purpose of this study is to analyze the timing of plume eruptions within the context of Europas tidal cycle to determine whether such a link exists and examine the inferred similarities and differences between plume activity on Europa and Enceladus.
Themis family is one of the largest and oldest asteroid populations in the main-belt. Water-ice may widely exist on the parent body (24) Themis. In this work, we employ the Advanced Thermophysical Model as well as mid-infrared measurements from NASAs Wide-Field Infrared Survey Explorer to explore thermal parameters of 20 Themis family members. Here we show that the average thermal inertia and geometric albedo are ~$39.5pm26.0 ~rm J m^{-2} s^{-1/2} K^{-1}$ and $0.067pm0.018$, respectively. The family members have a relatively moderate roughness fraction on their surfaces. We find that the relatively low albedos of Themis members are consistent with the typical values of B-type and C-type asteroids. As aforementioned, Themis family bears a very low thermal inertia, which indicates a fine and mature regolith on their surfaces. The resemblance of thermal inertia and geometric albedo of Themis members may reveal their close connection in origin and evolution. In addition, we present the compared results of thermal parameters for several prominent families.
We made near infrared multicolor imaging observations of a disk around Herbig Be star HD100546 using Gemini/NICI. K (2.2,$mu$m), H$_2$O ice (3.06,$mu$m), and L(3.8,$mu$m) disk images were obtained and we found the 3.1,$mu$m absorption feature in the scattered light spectrum, likely due to water ice grains at the disk surface. We compared the observed depth of the ice absorption feature with the disk model based on cite{Oka2012} including water ice photodesorption effect by stellar UV photons. The observed absorption depth can be explained by the both disk models with/without photodesorption effect within the measurement accuracy, but slightly favors the model with photodesorption effects, implying that the UV photons play an important role on the survival/destruction of ice grains at the Herbig Ae/Be disk surface. Further improvement on the accuracy of the observations of the water ice absorption depth is needed to constrain the disk models.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
