Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userFrequency-swept high-repetition rate optical source
128
0
0.0
(
0
)
Authors
Christophe Finot
Ask ChatGPT about the research
No Arabic abstract
We propose and numerically validate an all-optical scheme to generate optical pulse trains with varying temporal pulse-to-pulse delay and pulse duration. Applying a temporal sinusoidal phase modulation followed by a shaping of the spectral phase enables us to maintain high-quality Gaussian temporal profiles.
rate research
Read More
High harmonic generation (HHG) enables coherent extreme-ultraviolet (XUV) radiation with ultra-short pulse duration in a table-top setup. This has already enabled a plethora of applications. Nearly all of these applications would benefit from a high photon flux to increase the signal-to-noise ratio and decrease measurement times. In addition, shortest pulses are desired to investigate fastest dynamics in fields as diverse as physics, biology, chemistry and material sciences. In this work, the up-to-date most powerful table-top XUV source with 12.9 mW in a single harmonic line at 26.5 eV is demonstrated via HHG of a frequency-doubled and post-compressed fibre laser. At the same time sub-6 fs XUV pulse duration allows accessing ultrafast dynamics with an order of magnitude higher photon flux than previously demonstrated. This concept will greatly advance and facilitate applications of XUV radiation in science and technology and enable photon-hungry ultrafast studies.
Manipulating the atomic and electronic structure of matter with strong terahertz (THz) fields while probing the response with ultrafast pulses at x-ray free electron lasers (FELs) has offered unique insights into a multitude of physical phenomena in solid state and atomic physics. Recent upgrades of x-ray FEL facilities are pushing to much higher repetition rates, enabling unprecedented signal to noise for pump probe experiments. This requires the development of suitable THz pump sources that are able to deliver intense pulses at compatible repetition rates. Here we present a high power laser-driven THz source based on optical rectification in LiNbO3 using tilted pulse front pumping. Our source is driven by a kilowatt-level Yb:YAG amplifier system operating at 100 kHz repetition rate and employing nonlinear spectral broadening and recompression to achieve sub-100 fs pulses at 1030 nm wavelength. We demonstrate a maximum of 144 mW average THz power (1.44 uJ pulse energy), consisting of single-cycle pulses centered at 0.6 THz with a peak electric field strength exceeding 150 kV/cm. These high field pulses open up a range of possibilities for nonlinear time-resolved experiments with x-ray probing at unprecedented rates.
We demonstrate a Ho:YLF regenerative amplifier (RA) overcoming bifurcation instability and consequently achieving high extraction energies of 6.9 mJ at a repetition rate of 1 kHz with pulse-to-pulse fluctuations of 1.1%. Measurements of the output pulse energy, corroborated by numerical simulations, identify an operation point that allows high-energy pulse extraction at a minimum noise level. Complete suppression of the onset of bifurcation was achieved by gain saturation after each pumping cycle in the Ho:YLF crystal via lowering the repetition rate and cooling the crystal. Even for moderate cooling, a significant temperature dependence of the Ho:YLF RA performance was observed.
We experimentally demonstrate that the transmission of a 1030~nm, 1.3~ps laser beam of 100 mJ energy through fog increases when its repetition rate increases to the kHz range. Due to the efficient energy deposition by the laser filaments in the air, a shockwave ejects the fog droplets from a substantial volume of the beam, at a moderate energy cost. This process opens prospects for applications requiring the transmission of laser beams through fogs and clouds.
Attosecond pulses, produced through high-order harmonic generation in gases, have been successfully used for observing ultrafast, sub-femtosecond electron dynamics in atoms, molecules and solid state systems. Todays typical attosecond sources, however, are often impaired by their low repetition rate and the resulting insufficient statistics, especially when the number of detectable events per shot is limited. This is the case for experiments where several reaction products must be detected in coincidence, and for surface science applications where space-charge effects compromise spectral and spatial resolution. In this work, we present an attosecond light source operating at 200 kHz, which opens up the exploration of phenomena previously inaccessible to attosecond interferometric and spectroscopic techniques. Key to our approach is the combination of a high repetition rate, few-cycle laser source, a specially designed gas target for efficient high harmonic generation, a passively and actively stabilized pump-probe interferometer and an advanced 3D photoelectron/ion momentum detector. While most experiments in the field of attosecond science so far have been performed with either single attosecond pulses or long trains of pulses, we explore the hitherto mostly overlooked intermediate regime with short trains consisting of only a few attosecond pulses.e also present the first coincidence measurement of single-photon double ionization of helium with full angular resolution, using an attosecond source. This opens up for future studies of the dynamic evolution of strongly correlated electrons.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
