Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userRoom-temperature insulating ferromagnetic (Ni,Co)1+2xTi1-xO3 thin films
83
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Insulating uniaxial room-temperature ferromagnets are a prerequisite for commonplace spin wave-based devices, the obstacle in contemporary ferromagnets being the coupling of ferromagnetism with large conductivity. We show that the uniaxial $A^{1+2x}$Ti$^{4+}$$_{1-x}$O$_3$ (ATO), $A=$Ni$^{2+}$,Co$^{2+}$ and $0.6<x leq 1$, thin films are electrically insulating ferromagnets already at room-temperature. The octahedra network of the ATO and ilmenite structures are similar yet different octahedra-filling proved to be a route to switch from the antiferromagnetic to ferromagnetic regime. Octahedra can continuously be filled up to $x=1$, or vacated $(-0.24<x<0)$ in the ATO structure. TiO-layers, which separate the ferromagnetic (Ni,Co)O-layers and intermediate the antiferromagnetic coupling between the ferromagnetic layers in the NiTiO$_3$ and CoTiO$_3$ ilmenites, can continuously be replaced by (Ni,Co)O-layers to convert the ATO-films to ferromagnetic insulator with abundant direct cation interactions.
rate research
Read More
Ferroelectricity at room temperature has been demonstrated in nanometer-thin quasi 2D croconic acid thin films, by the polarization hysteresis loop measurements in macroscopic capacitor geometry, along with observation and manipulation of the nanoscale domain structure by piezoresponse force microscopy. The fabrication of continuous thin films of the hydrogen-bonded croconic acid was achieved by the suppression of the thermal decomposition using low evaporation temperatures in high vacuum, combined with growth conditions far from thermal equilibrium. For nominal coverages >=20 nm, quasi 2D and polycrystalline films, with an average grain size of 50-100 nm and 3.5 nm roughness, can be obtained. Spontaneous ferroelectric domain structures of the thin films have been observed and appear to correlate with the grain patterns. The application of this solvent-free growth protocol may be a key to the development of flexible organic ferroelectric thin films for electronic applications.
To explore the further possibilities of nanometer-thick ferromagnetic films (ultrathin ferromagnetic films), we investigated the ferromagnetic resonance (FMR) of 1 nm-thick Co film. Whilst an FMR signal was not observed for the Co film grown on a SiO2 substrate, the insertion of a 3 nm-thick amorphous Ta buffer layer beneath the Co enabled the detection of a salient FMR signal, which was attributed to the smooth surface of the amorphous Ta. This result implies the excitation of FMR in an ultrathin ferromagnetic film, which can pave the way to controlling magnons in ultrathin ferromagnetic films.
We report on the formation of the dilute $Pd_{1-x}Fe_x$ compositions with tunable magnetic properties under an ion-beam implantation of epitaxial Pd thin films. Binary $Pd_{1-x}Fe_x$ alloys with a mean iron content $x$ of $0.025$, $0.035$ or $0.075$ were obtained by the implantation of $40 keV$ $Fe^+$ ions into the palladium films on MgO (001) substrate to the doses of $0.5cdot10^{16}, 1.0cdot10^{16}$ and $3.0cdot10^{16}$ $ions/cm^2$, respectively. Structural and magnetic studies have shown that iron atoms occupy regular fcc-lattice Pd-sites without the formation of any secondary crystallographic phase. All the iron implanted Pd films reveal ferromagnetism at low temperatures (below $200 K$) with both the Curie temperature and saturation magnetization determined by the implanted iron dose. In contrast to the magnetic properties of the molecular beam epitaxy grown $Pd_{1-x}Fe_x$ alloy films with the similar iron contents, the Fe-implanted Pd films possess weaker in-plane magnetocrystalline anisotropy, and, accordingly, a lower coercivity. The observed multiple ferromagnetic resonances in the implanted $Pd_{1-x}Fe_x$ films indicate a formation of a magnetically inhomogeneous state due to spinodal decomposition into regions, presumably layers, with identical crystal symmetry but different iron contents. The multiphase magnetic structure is robust with respect to the vacuum annealing at $770 K$, though develops towards well-defined local $Pd-Fe$ compositions.
Ferromagnetic insulators (FMIs) are one of the most important components in developing dissipationless electronic and spintronic devices. However, since ferromagnetism generally accompanies metallicity, FMIs are innately rare to find in nature. Here, novel room-temperature FMI films are epitaxially synthesized by deliberate control of the ratio of two B-site cations in the double perovskite Sr2FeReO6. In contrast to the known ferromagnetic metallic phase in stoichiometric Sr2FeReO6, a FMI state with a high Curie temperature (Tc~400 K) and a large saturation magnetization (MS~1.8 {mu}B/f.u.) is found in highly cation-ordered Fe-rich phases. The stabilization of the FMI state is attributed to the formation of extra Fe3+-Fe3+ and Fe3+-Re6+ bonding states, which originate from the excess Fe. The emerging FMI state by controlling cations in the epitaxial oxide perovskites opens the door to developing novel oxide quantum materials & heterostructures.
Epitaxial La2NiMnO6 thin films have been grown on (001)-oriented SrTiO3 using the PLD technique. The thin films are semiconducting and FM with a TC close to 270K, a coercive field of 920Oe, and a saturation magnetization of 5muB per f.u. TEM, conducted at RT, reveals a majority phase having I-centered structure with a=c=1.4asub and b=2asub along with a minority phase-domains having P-type structure (asub being the lattice parameter of the perovskite structure). A discusion on the presence of Ni/Mn long-range ordering, in light of recent literature on double perovskites La2NiMnO6 is presented.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
