Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userElectrical detection of spin-polarized current in topological insulator Bi1.5Sb0.5Te1.7Se1.3
60
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Spin-momentum locked (SML) topological surface state (TSS) provides exotic properties for spintronics applications. The spin-polarized current, which emerges owing to the SML, can be directly detected by performing spin potentiometric measurement. We observed spin-polarized current using a bulk insulating topological insulator (TI), Bi1.5Sb0.5Te1.7Se1.3, and Co as the ferromagnetic spin probe. The spin voltage was probed with varying the bias current, temperature, and gate voltage. Moreover, we observed non-local spin-polarized current, which is regarded as a distinguishing property of TIs. The spin-polarization ratio of the non-local current was larger than that of the local current. These findings could reveal a more accurate approach to determine spin-polarization ratio at the TSS.
rate research
Read More
We predict a mechanism to generate a pure spin current in a two-dimensional topological insulator. As the magnetic impurities exist on one of edges of the two-dimensional topological insulator, a gap is opened in the corresponding gapless edge states but another pair of gapless edge states with opposite spin are still protected by the time-reversal symmetry. So the conductance plateaus with the half-integer values $e^2/h$ can be obtained in the gap induced by magnetic impurities, which means that the pure spin current can be induced in the sample. We also find that the pure spin current is insensitive to weak disorder. The mechanism to generate pure spin currents is generalized for two-dimensional topological insulators.
The spin-polarized surface states in topological insulators offer unique transport characteristics which make them distinguishable from trivial conductors. Due to the topological protection, these states are gapless over the whole surface of the material. Here, we detect the surface states in the topological insulator BiSbTeSe$_{2}$ by electrical means using a non-local transport configuration. We unambiguously probe the spin-momentum locking of the topologically protected surface states by spin-sensitive electrical read-out using ferromagnetic Co/Al$_2$O$_3$ electrodes. We show that the non-local measurement allows to probe the surface currents flowing along the whole surface, i.e. from the top along the side to the bottom surface and back to the top surface along the opposite side. This is in contrast to local transport configurations where only the surface states of the one face being in contact to the electrodes can be measured. Our results furthermore exclude the contribution of the bulk to the non-local transport at low temperatures. Increasing the temperature, on the other hand, increases the interaction between bulk and surface states, which shortens the non-local current path along the surface and hence leads to a complete disappearance of the non-local signal at around 20 K. All this demonstrates that the non-local signal at low temperatures is solely due to the topologically protected surface states.
We report the observation of ferromagnetic resonance-driven spin pumping signals at room temperature in three-dimensional topological insulator thin films -- Bi2Se3 and (Bi,Sb)2Te3 -- deposited by molecular beam epitaxy on yttrium iron garnet thin films. By systematically varying the Bi2Se3 film thickness, we show that the spin-charge conversion efficiency, characterized by the inverse Rashba-Edelstein effect length (lambda_IREE), increases dramatically as the film thickness is increased from 2 quintuple layers, saturating above 6 quintuple layers. This suggests a dominant role of surface states in spin and charge interconversion in topological insulator/ferromagnet heterostructures. Our conclusion is further corroborated by studying a series of YIG/(BiSb)2Te3 heterostructures. Finally, we use the ferromagnetic resonance linewidth broadening and the inverse Rashba-Edelstein signals to determine the effective interfacial spin mixing conductance and lambda_IREE.
The charge-current-induced spin polarization is a key property of topological insulators for their applications in spintronics. However, topological surface states are expected to give rise to only one type of spin polarization for a given current direction, which has been a limiting factor for spin manipulations. Here we report that in devices based on the bulk-insulating topological insulator BiSbTeSe2, an unexpected switching of spin polarization was observed upon changing the chemical potential. The spin polarization expected from the topological surface states was detected in a heavily electron-doped device, whereas the opposite polarization was reproducibly observed in devices with low carrier densities. We propose that the latter type of spin polarization stems from topologically-trivial two-dimensional states with a large Rashba spin splitting, which are caused by a strong band bending at the surface of BiSbTeSe2 beneath the ferromagnetic electrode used as a spin detector. This finding paves the way for realizing the spin transistor operation in future topological spintronic devices.
The Kondo insulator compound SmB6 has emerged as a strong candidate for the realization of a topologically nontrivial state in a strongly correlated system, a topological Kondo insulator, which can be a novel platform for investigating the interplay between nontrivial topology and emergent correlation driven phenomena in solid state systems. Electronic transport measurements on this material, however, so far showed only the robust surface dominated charge conduction at low temperatures, lacking evidence of its connection to the topological nature by showing, for example, spin polarization due to spin momentum locking. Here, we find evidence for surface state spin polarization by electrical detection of a current induced spin chemical potential difference on the surface of a SmB6 single crystal. We clearly observe a surface dominated spin voltage, which is proportional to the projection of the spin polarization onto the contact magnetization, is determined by the direction and magnitude of the charge current and is strongly temperature dependent due to the crossover from surface to bulk conduction. We estimate the lower bound of the surface state net spin polarization as 15 percent based on the quantum transport model providing direct evidence that SmB6 supports metallic spin helical surface states.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
