Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userStructure, magnetic susceptibility and specific heat of the spin-orbital-liquid candidate FeSc2S4 : Influence of fe off-stoichiometry
71
0
0.0
(
0
)
Added by
Vladimir Tsurkan Dr
Publication date
2017
fields
Physics
and research's language is
English
Ask ChatGPT about the research
No Arabic abstract
We report structural, susceptibility and specific heat studies of stoichiometric and off-stoichiometric poly- and single crystals of the A-site spinel compound FeSc2S4. In stoichiometric samples no long-range magnetic order is found down to 1.8 K. The magnetic susceptibility of these samples is field independent in the temperature range 10 - 400 K and does not show irreversible effects at low temperatures. In contrast, the magnetic susceptibility of samples with iron excess shows substantial field dependence at high temperatures and manifests a pronounced magnetic irreversibility at low temperatures with a difference between ZFC and FC susceptibilities and a maximum at 10 K reminiscent of a magnetic transition. Single crystal x-ray diffraction of the stoichiometric samples revealed a single phase spinel structure without site inversion. In single crystalline samples with Fe excess besides the main spinel phase a second ordered single-crystal phase was detected with the diffraction pattern of a vacancy-ordered superstructure of iron sulfide, close to the 5C polytype Fe9S10. Specific heat studies reveal a broad anomaly, which evolves below 20 K in both stoichiometric and off-stoichiometric crystals. We show that the low-temperature specific heat can be well described by considering the low-lying spin-orbital electronic levels of Fe2+ ions. Our results demonstrate significant influence of excess Fe ions on intrinsic magnetic behavior of FeSc2S4 and provide support for the spin-orbital liquid scenario proposed in earlier studies for the stoichiometric compound.
rate research
Read More
Theoretical models of the spin-orbital liquid (SOL) FeSc$_2$S$_4$ have predicted it to be in close proximity to a quantum critical point separating a spin-orbital liquid phase from a long-range ordered magnetic phase. Here, we examine the magnetic excitations of FeSc$_2$S$_4$ through time-domain terahertz spectroscopy under an applied magnetic field. At low temperatures an excitation emerges that we attribute to a singlet-triplet excitation from the SOL ground state. A three-fold splitting of this excitation is observed as a function of applied magnetic field. As singlet-triplet excitations are forbidden in inversion symmetric pure spin systems, our results demonstrate the non-trivial character of the entangled spin-orbital singlet ground state. Using experimentally obtained parameters we compare to existing theoretical models to determine FeSc$_2$S$_4$s proximity to the quantum critical point. In the context of these models, we estimate that the characteristic length of the singlet correlations to be $xi/ (textbf{a}/2) approx 8.2$ (where $textbf{a}/2$ is the nearest neighbor lattice constant) which establishes FeSc$_2$S$_4$ as a SOL with long-range entanglement.
We measured the low temperature specific heat of a sputtered $(Fe_{23AA}/Cr_{12AA})_{33}$ magnetic multilayer, as well as separate $1000AA$ thick Fe and Cr films. Magnetoresistance and magnetization measurements on the multilayer demonstrated antiparallel coupling between the Fe layers. Using microcalorimeters made in our group, we measured the specific heat for $4<T<30 K$ and in magnetic fields up to $8 T$ for the multilayer. The low temperature electronic specific heat coefficient of the multilayer in the temperature range $4<T<14 K$ is $gamma_{ML}=8.4 mJ/K^{2}g-at$. This is significantly larger than that measured for the Fe or Cr films (5.4 and $3.5 mJ/K^{2}mol$ respectively). No magnetic field dependence of $gamma_{ML}$ was observed up to $8 T$. These results can be explained by a softening of the phonon modes observed in the same data and the presence of an Fe-Cr alloy phase at the interfaces.
We have grown and studied high quality SrRuO3 films grown by MBE as well as PLD. By changing the oxygen activity during deposition we were able to make SrRuO3 samples that were stoichiometric (low oxygen activity) or with ruthenium vacancies (high oxygen activity). Samples with strontium vacancies were found impossible to produce since the ruthenium would precipitate out as RuO2. The volume of the unit cell of SrRuO3 becomes larger as more ruthenium vacancies are introduced. The residual resistivity ratio (RRR) and room temperature resistivity were found to systematically depend on the volume of the unit cell and therefore on the amount of ruthenium vacancies. The RRR varied from ~30 for stoichiometric samples to less than two for samples that were very ruthenium poor. The room temperature resistivity varied from 190 microOhm cm for stoichoimetric samples to over 300 microOhm cm for very ruthenium poor samples. UPS spectra show a shift of weight from the coherent peak to the incoherent peak around the Fermi level when samples have more ruthenium vacancies. Core level XPS spectra of the ruthenium 3d lines show a strong screened part in the case of stoichiometric samples. This screened part disappears when ruthenium vacancies are introduced. Both the UPS and the XPS results are consistent with the view that correlation increases as the amount of ruthenium vacancies increase.
The electronic and magnetic properties of Fe atoms in the ferromagnetic semiconductor (In,Fe)As codoped with Be have been studied by x-ray absorption spectroscopy (XAS) and x-ray magnetic circular dichroism (XMCD) at the Fe $L_{2,3}$ edge. The XAS and XMCD spectra showed simple spectral line shapes similar to Fe metal, but the ratio of the orbital and spin magnetic moments ($M_mathrm{orb}$/$M_mathrm{spin}$) estimated using the XMCD sum rules was significantly larger than that of Fe metal, indicating a significant orbital moment of Fe $3d$ electrons in (In,Fe)As:Be. The positive value of $M_mathrm{orb}$/$M_mathrm{spin}$ implies that the Fe $3d$ shell is more than half-filled, which arises from the hybridization of the Fe$^{3+}$ ($d^5$) state with the charge-transfer $d^6underline{L}$ states, where $underline{L}$ is a ligand hole in the host valence band. The XMCD intensity as a function of magnetic field indicated hysteretic behavior of the superparamagnetic-like component due to discrete ferromagnetic domains.
In low temperature experiments, resins have many applications as glues or thermal and electrical insulators. Cyanate ester resins (CEs) are a high-temperature compatible thermoset resin whose glass-transition temperature $T_g$ is ~300 $^circ$C. Recently, we found that CEs also withstand low temperatures without microcracking by measuring $^4$He permeability. Here, we measured specific heat C, thermal conductivity kappa, and magnetic susceptibility $chi$ of different kinds of CEs in the wide temperature range from room temperature to 0.5 K for C and 2 K for other two. The thermal properties, C and kappa, of different kinds of CEs are surprisingly coincident with each other. We discuss chemical structures and crystallinity of CEs and their blends based on the measured thermal properties. Compared to Stycast 1266, a commonly-used epoxy resin in low temperature experiments, C of CEs is larger by a factor of 3 (<= 30 K), kappa is lower by a factor of 4 (<= 10 K), indicating the small thermal diffusivity. The chi values are as small as Stycast 1266, indicative of their high purity. Our results show that cyanate esters are a new option for cryogenic resins with thermal insulative properties in/for low temperature experiments.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
