Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userDecoupling of graphene from Ni(111) via oxygen intercalation
185
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
The combination of the surface science techniques (STM, XPS, ARPES) and density-functional theory calculations was used to study the decoupling of graphene from Ni(111) by oxygen intercalation. The formation of the antiferromagnetic (AFM) NiO layer at the interface between graphene and ferromagnetic (FM) Ni is found, where graphene protects the underlying AFM/FM sandwich system. It is found that graphene is fully decoupled in this system and strongly $p$-doped via charge transfer with a position of the Dirac point of $(0.69pm0.02)$ eV above the Fermi level. Our theoretical analysis confirms all experimental findings, addressing also the interface properties between graphene and AFM NiO.
rate research
Read More
We have performed electron energy-loss spectroscopy (EELS) studies of Ni(111), graphene/Ni(111), and the graphene/Au/Ni(111) intercalation-like system at different primary electron energies. A reduced parabolic dispersion of the pi plasmon excitation for the graphene/Ni(111) system is observed compared to that for bulk pristine and intercalated graphite and to linear for free graphene, reflecting the strong changes in the electronic structure of graphene on Ni(111) relative to free-standing graphene. We have also found that intercalation of gold underneath a graphene layer on Ni(111) leads to the disappearance of the EELS spectral features which are characteristic of the graphene/Ni(111) interface. At the same time the shift of the pi plasmon to the lower loss-energies is observed, indicating the transition of initial system of strongly bonded graphene on Ni(111) to a quasi free-standing-like graphene state.
Intercalation of alkali atoms within the lamellar transition metal dichalcogenides is a possible route toward a new generation of batteries. It is also a way to induce structural phase transitions authorizing the realization of optical and electrical switches in this class of materials. The process of intercalation has been mostly studied in three-dimensional dichalcogenide films. Here, we address the case of a single-layer of molybdenum disulfide (MoS$_2$), deposited on a gold substrate, and intercalated with cesium (Cs) in ultra-clean conditions (ultrahigh vacuum). We show that intercalation decouples MoS$_2$ from its substrate. We reveal electron transfer from Cs to MoS$_2$, relative changes in the energy of the valence band maxima, and electronic disorder induced by structural disorder in the intercalated Cs layer. Besides, we find an abnormal lattice expansion of MoS$_2$, which we relate to immediate vicinity of Cs. Intercalation is thermally activated, and so is the reverse process of de-intercalation. Our work opens the route to a microscopic understanding of a process of relevance in several possible future technologies, and shows a way to manipulate the properties of two-dimensional dichalcogenides by under-cover functionalization.
We report the structural and electronic properties of an artificial graphene/Ni(111) system obtained by the intercalation of a monoatomic layer of Ni in graphene/Ir(111). Upon intercalation, Ni grows epitaxially on Ir(111), resulting in a lattice mismatched graphene/Ni system. By performing Scanning Tunneling Microscopy (STM) measurements and Density Functional Theory (DFT) calculations, we show that the intercalated Ni layer leads to a pronounced buckling of the graphene film. At the same time an enhanced interaction is measured by Angle-Resolved Photo-Emission Spectroscopy (ARPES), showing a clear transition from a nearly-undisturbed to a strongly-hybridized graphene $pi$-band. A comparison of the intercalation-like graphene system with flat graphene on bulk Ni(111), and mildly corrugated graphene on Ir(111), allows to disentangle the two key properties which lead to the observed increased interaction, namely lattice matching and electronic interaction. Although the latter determines the strength of the hybridization, we find an important influence of the local carbon configuration resulting from the lattice mismatch.
Angle-resolved photoemission spectroscopy and Auger electron spectroscopy have been applied to study the intercalation process of silver underneath a monolayer of graphite (MG) on Ni(111). The room-temperature deposition of silver on top of MG/Ni(111) system leads to the islands-like growth of Ag on top of the MG. Annealing of the as-deposited system at temperature of 350-450 C results in the intercalation of about 1-2 ML of Ag underneath MG on Ni(111) independently of the thickness of pre-deposited Ag film (3-100 A). The intercalation of Ag is followed by a shift of the graphite-derived valence band states towards energies which are slightly larger than ones characteristic for pristine graphite. This observation is understood in terms of a weakening of chemical bonding between the MG and the substrate in the MG/Ag/Ni(111) system with a small MG/Ni(111) covalent contribution to this interaction.
Experimental and theoretical studies of manganese deposition on graphene/Ni(111) shows that a thin ferromagnetic Ni3Mn layer, which is protected by the graphene overlayer, is formed upon Mn intercalation. The electronic bands of graphene are affected by Ni3Mn interlayer formation through a slight reduction of n-type doping compared to graphene/Ni(111) and a suppression of the interface states characteristic of graphene/Ni(111). Our DFT-based theoretical analysis of interface geometric, electronic, and magnetic structure gives strong support to our interpretation of the experimental scanning tunneling microscopy, low energy electron diffraction, and photoemission results, and shows that the magnetic structure of graphene is strongly influenced by Ni3Mn formation.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
