No Arabic abstract
There has been growing interest in perovskite BaSnO3 due to its desirable properties for oxide electronic devices including high electron mobility at room temperature and optical transparency. As these electronic and optical properties originate largely from the electronic structure of the material, here the basic electronic structure of epitaxially-grown BaSnO3 films is studied using high-energy-resolution electron energy-loss spectroscopy in a transmission electron microscope and ab initio calculations. This study provides a detailed description of the dielectric function of BaSnO3, including the energies of bulk plasmon excitations and critical interband electronic transitions, the band structure and partial densities of states, the measured band gap, and more. To make the study representative of a variety of deposition methods, results from BaSnO3 films grown by both hybrid molecular beam epitaxy and high pressure oxygen sputter deposition are reported.
Resonant photoemission spectroscopy has been used to investigate the character of Fe 3d states in FeAl alloy. Fe 3d states have two different character, first is of itinerant nature located very close to the Fermi level, and second, is of less itinerant (relatively localized character), located beyond 2 eV below the Fermi level. These distinct states are clearly distinguishable in the resonant photoemission data. Comparison between the results obtained from experiments and first principle based electronic structure calculation show that the origin of the itinerant character of the Fe 3d states is due to the ordered B2 structure, whereas the relatively less itinerant (localized) Fe 3d states are from the disorders present in the sample. The exchange splitting of the Fe 3s core level peak confirms the presence of local moment in this system. It is found that the itinerant electrons arise due to the hybridization between Fe 3d and Al 3s-3p states. Presence of hybridization is observed as a shift in the Al 2p core-level spectra as well as in the X-ray near edge absorption spectra towards lower binding energy. Our photoemission results are thus explained by the co-existence of ordered and disordered phases in the system.
The electronic excitation spectra of undoped, and potassium as well as calcium doped phenantrene-type hydrocarbons have been investigated using electron energy-loss spectroscopy (EELS) in transmission. In the undoped materials, the lowest energy excitations are excitons with a relatively high binding energy. These excitons also are rather localized as revealed by their vanishing dispersion. Upon doping, new low energy excitation features appear in the former gaps of the materials under investigation. In K$_3$picene and K$_3$chrysene they are characterized by a negative dispersion while in Ca$_3$picene they are dispersionless.
The effect of nanocrystal orientation on the energy loss spectra of monoclinic hafnia (m-HfO$_2$) is measured by high resolution transmission electron microscopy (HRTEM) and valence energy loss spectroscopy (VEELS) on high quality samples. For the same momentum-transfer directions, the dielectric properties are also calculated ab initio by time-dependent density-functional theory (TDDFT). Experiments and simulations evidence anisotropy in the dielectric properties of m-HfO$_2$, most notably with the direction-dependent oscillator strength of the main bulk plasmon. The anisotropic nature of m-HfO$_2$ may contribute to the differences among VEELS spectra reported in literature. The good agreement between the complex dielectric permittivity extracted from VEELS with nanometer spatial resolution, TDDFT modeling, and past literature demonstrates that the present HRTEM-VEELS device-oriented methodology is a possible solution to the difficult nanocharacterization challenges given in the International Technology Roadmap for Semiconductors.
Measurements by high-resolution electron energy-loss spectroscopy (HREELS) of NaxCoO2 reveal spectral features that differ remarkably between the metallic Na0.33CoO2 and the charge-ordered insulator Na0.5CoO2. Calculations by density functional theory plus Hubbard U (DFT+U) demonstrate that these differences arise essentially from the relatively greater strength of electron correlation in addition to the crystal-field effect in Na0.5CoO2. The effective U values are estimated to be ~3.0eV for x=0.5 and ~1.0eV for x=0.33, respectively. The electronic structures for these correlation strengths give good interpretations for the physical properties observed in the materials.
The electronic band structure of complex nanostructured semiconductors has a considerable effect on the final electronic and optical properties of the material and, ultimately, on the functionality of the devices incorporating them. Valence electron energy-loss spectroscopy (VEELS) in the transmission electron microscope (TEM) provides the possibility of measuring this property of semiconductors with high spatial resolution. However, it still represents a challenge for narrow-bandgap semiconductors, since an electron beam with low energy spread is required. Here we demonstrate that by means of monochromated VEELS we can study the electronic band structure of narrow-gap materials GaSb and InAs in the form of heterostructured nanowires, with bandgap values down to 0.5 eV, especially important for newly developed structures with unknown bandgaps. Using complex heterostructured InAs-GaSb nanowires, we determine a bandgap value of 0.54 eV for wurtzite InAs. Moreover, we directly compare the bandgaps of wurtzite and zinc-blende polytypes of GaSb in a single nanostructure, measured here as 0.84 and 0.75 eV, respectively. This allows us to solve an existing controversy in the band alignment between these structures arising from theoretical predictions. The findings demonstrate the potential of monochromated VEELS to provide a better understanding of the band alignment at the heterointerfaces of narrow-bandgap complex nanostructured materials with high spatial resolution. This is especially important for semiconductor device applications where even the slightest variations of the electronic band structure at the nanoscale can play a crucial role in their functionality.