Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userEnergy correlations of photon pairs generated by a silicon microring resonator probed by Stimulated Four Wave Mixing
193
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Compact silicon integrated devices, such as micro-ring resonators, have recently been demonstrated as efficient sources of quantum correlated photon pairs. The mass production of integrated devices demands the implementation of fast and reliable techniques to monitor the device performances. In the case of time-energy correlations, this is particularly challenging, as it requires high spectral resolution that is not currently achievable in coincidence measurements. Here we reconstruct the joint spectral density of photons pairs generated by spontaneous four-wave mixing in a silicon ring resonator by studying the corresponding stimulated process, namely stimulated four wave mixing. We show that this approach, featuring high spectral resolution and short measurement times, allows one to discriminate between nearly-uncorrelated and highly-correlated photon pairs.
rate research
Read More
We report on four-wave mixing in a silicon microring resonator using a self-pumping scheme instead of an external laser. The ring resonator is inserted in an external-loop cavity with a fibered semiconductor amplifier as a source of gain. The silicon microring acts as a filter and we observe lasing in one of the microrings resonances. We study correlations between signal and idler generated beams using a Joint Spectral Density experiment.
We develop a general Hamiltonian treatement of spontaneous four-wave mixing in a microring resonator side-coupled to a channel waveguide. The effect of scattering losses in the ring is included, as well as parasitic nonlinear effects including self- and cross-phase modulation. A procedure for computing the output of such a system for arbitrary parameters and pump states is presented. For the limit of weak pumping an expression for the joint spectral intensity of generated photon pairs, as well as the singles-to-coincidences ratio, is derived.
Single-photon stimulated four wave mixing (StFWM) processes have great potential for photonic quantum information processing, compatible with optical communication technologies and integrated optoelectronics. In this paper, we demonstrate single-photon StFWM process in a piece of optical fiber, with seeded photons generated by spontaneous four wave mixing process (SpFWM). The effect of the single-photon StFWM is confirmed by time-resolved four-photon coincidence measurement and variation of four-photon coincidence counts under different seed-pump delays. According to the experiment results, the potential performance of quantum cloning machine based on the process is analyzed.
We experimentally determine the quantum discord present in two-mode squeezed vacuum generated by a four-wave mixing process in hot rubidium vapor. The frequency spectra of the discord, as well as the quantum and classical mutual information are also measured. In addition, the effects of symmetric attenuation introduced into both modes of the squeezed vacuum on the discord, the quantum mutual information and the classical correlations are examined experimentally. Finally, we show that due to the multi-spatial-mode nature of the four-wave mixing process, the quantum discord may exhibit sub- or superadditivity depending on which spatial channels are selected.
We observed electromagnetically-induced-transparency-based four-wave mixing (FWM) in the pulsed regime at low light levels. The FWM conversion efficiency of 3.8(9)% was observed in a four-level system of cold 87Rb atoms using a driving laser pulse with a peak intensity of approximately 80 {mu}W/cm^2, corresponding to an energy of approximately 60 photons per atomic cross section. Comparison between the experimental data and the theoretical predictions proposed by Harris and Hau [Phys. Rev. Lett. 82, 4611 (1999)] showed good agreement. Additionally, a high conversion efficiency of 46(2)% was demonstrated when applying this scheme using a driving laser intensity of approximately 1.8 mW/cm^2. According to our theoretical predictions, this FWM scheme can achieve a conversion efficiency of nearly 100% when using a dense medium with an optical depth of 500.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
