Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userStatistical Analysis of Filament Features Based on the H{alpha} Solar Images from 1988 to 2013 by Computer Automated Detection Method
51
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We improve our filament automated detection method which was proposed in our previous works. It is then applied to process the full disk H$alpha$ data mainly obtained by Big Bear Solar Observatory (BBSO) from 1988 to 2013, spanning nearly 3 solar cycles. The butterfly diagrams of the filaments, showing the information of the filament area, spine length, tilt angle, and the barb number, are obtained. The variations of these features with the calendar year and the latitude band are analyzed. The drift velocities of the filaments in different latitude bands are calculated and studied. We also investigate the north-south (N-S) asymmetries of the filament numbers in total and in each subclass classified according to the filament area, spine length, and tilt angle. The latitudinal distribution of the filament number is found to be bimodal. About 80% of all the filaments have tilt angles within [0{deg}, 60{deg}]. For the filaments within latitudes lower (higher) than 50{deg} the northeast (northwest) direction is dominant in the northern hemisphere and the southeast (southwest) direction is dominant in the southern hemisphere. The latitudinal migrations of the filaments experience three stages with declining drift velocities in each of solar cycles 22 and 23, and it seems that the drift velocity is faster in shorter solar cycles. Most filaments in latitudes lower (higher) than 50{deg} migrate toward the equator (polar region). The N-S asymmetry indices indicate that the southern hemisphere is the dominant hemisphere in solar cycle 22 and the northern hemisphere is the dominant one in solar cycle 23.
rate research
Read More
Radio bursts from the solar corona can provide clues to forecast space weather hazards. After recent technology advancements, regular monitoring of radio bursts has increased and large observational data sets are produced. Hence, manual identification and classification of them is a challenging task. In this paper, we describe an algorithm to automatically identify radio bursts from dynamic solar radio spectrograms using a novel statistical method. We used e-CALLISTO radio spectrometer data observed at Gauribidanur observatory near Bangalore in India during 2013 - 2014. We have studied the classifier performance using the receiver operating characteristics. Further, we studied type III bursts observed in the year 2014 and found that $75%$ of the observed bursts were below 200 MHz. Our analysis shows that the positions of the flare sites which are associated with the type III bursts with upper-frequency cut-off $gtrsim 200$ MHz originate close to the solar disk center
With the rapid development of telescopes, both temporal cadence and the spatial resolution of observations are increasing. This in turn generates vast amount of data, which can be efficiently searched only with automated detections in order to derive the features of interest in the observations. A number of automated detection methods and algorithms have been developed for solar activities, based on the image processing and machine learning techniques. In this paper, after briefly reviewing some automated detection methods, we describe our efficient and versatile automated detection method for solar filaments. It is able not only to recognize filaments, determine the features such as the position, area, spine, and other relevant parameters, but also to trace the daily evolution of the filaments. It is applied to process the full disk H-alpha data observed in nearly three solar cycles, and some statistic results are presented.
In this paper we present an interference detection toolbox consisting of a high dynamic range Digital Fast-Fourier-Transform spectrometer (DFFT, based on FPGA-technology) and data analysis software for automated radio frequency interference (RFI) detection. The DFFT spectrometer allows high speed data storage of spectra on time scales of less than a second. The high dynamic range of the device assures constant calibration even during extremely powerful RFI events. The software uses an algorithm which performs a two-dimensional baseline fit in the time-frequency domain, searching automatically for RFI signals superposed on the spectral data. We demonstrate, that the software operates successfully on computer-generated RFI data as well as on real DFFT data recorded at the Effelsberg 100-m telescope. At 21-cm wavelength RFI signals can be identified down to the 4-sigma level. A statistical analysis of all RFI events detected in our observational data revealed that: (1) mean signal strength is comparable to the astronomical line emission of the Milky Way, (2) interferences are polarised, (3) electronic devices in the neighbourhood of the telescope contribute significantly to the RFI radiation. We also show that the radiometer equation is no longer fulfilled in presence of RFI signals.
Solar explosive events are commonly explained as small scale magnetic reconnection events, although unambiguous confirmation of this scenario remains elusive due to the lack of spatial resolution and of the statistical analysis of large enough samples of this type of events. In this work, we propose a sound statistical treatment of data cubes consisting of a temporal sequence of long slit spectra of the solar atmosphere. The analysis comprises all the stages from the explosive event detection to its characterization and the subsequent sample study. We have designed two complementary approaches based on the combination of standard statistical techniques (Robust Principal Component Analysis in one approach and wavelet decomposition and Independent Component Analysis in the second) in order to obtain least biased samples. These techniques are implemented in the spirit of letting the data speak for themselves. The analysis is carried out for two spectral lines: the C IV line at 1548.2 angstroms and the Ne VIII line at 770.4 angstroms. We find significant differences between the characteristics of the line profiles emitted in the proximities of two active regions, and in the quiet Sun, most visible in the relative importance of a separate population of red shifted profiles. We also find a higher frequency of explosive events near the active regions, and in the C IV line. The distribution of the explosive events characteristics is interpreted in the light of recent numerical simulations. Finally, we point out several regions of the parameter space where the reconnection model has to be refined in order to explain the observations.
Numerical simulations and observations show that galaxies are not uniformly distributed in the universe but, rather, they are spread across a filamentary structure. In this large-scale pattern, highly dense regions are linked together by bridges and walls, all of them surrounded by vast, nearly-empty areas. While nodes of the network are widely studied in the literature, simulations indicate that half of the mass budget comes from a more diffuse part of the network, which is made up of filaments. In the context of recent and upcoming large galaxy surveys, it becomes essential that we identify and classify features of the Cosmic Web in an automatic way in order to study their physical properties and the impact of the cosmic environment on galaxies and their evolution. In this work, we propose a new approach for the automatic retrieval of the underlying filamentary structure from a 2D or 3D galaxy distribution using graph theory and the assumption that paths that link galaxies together with the minimum total length highlight the underlying distribution. To obtain a smoothed version of this topological prior, we embedded it in a Gaussian mixtures framework. In addition to a geometrical description of the pattern, a bootstrap-like estimate of these regularised minimum spanning trees allowed us to obtain a map characterising the frequency at which an area of the domain is crossed. Using the distribution of halos derived from numerical simulations, we show that the proposed method is able to recover the filamentary pattern in a 2D or 3D distribution of points with noise and outliers robustness with a few comprehensible parameters.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
