Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userTinselenidene: a Two-dimensional Auxetic Material with Ultralow Lattice Thermal Conductivity and Ultrahigh Hole Mobility
161
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
By means of extensive ab initio calculations, a new two-dimensional (2D) atomic material tin selenide monolayer (coined as tinselenidene) is predicted to be a semiconductor with an indirect gap (1.45 eV) and a high hole mobility (of order 10000 cm2V-1S-1), and will bear an indirect-direct gap transition under a rather low strain (<0.5 GPa). Tinselenidene has a very small Youngs modulus (20-40 GPa) and an ultralow lattice thermal conductivity (<3 Wm-1K-1 at 300 K), making it probably the most flexible and most heat-insulating material in known 2D atomic materials. In addition, tinseleniden has a large negative Poissons ratio of -0.17, thus could act as a 2D auxetic material. With these intriguing properties, tinselenidene could have wide potential applications in thermoelectrics, nanomechanics and optoelectronics.
rate research
Read More
Recent synthesis of monolayer borophene (triangle boron monolayer) on the substrate opens the era of boron nanosheet (Science, 350, 1513, $mathbf{2015}$), but the structural stability and novel physical properties are still open issues. Here we demonstrated borophene can be stabilized with fully surface hydrogenation, called as borophane, from first-principles calculations. Most interesting, it shows that borophane has direction-dependent Dirac cones, which are mainly contributed by in-plane emph{p$_{x}$} and emph{p$_{y}$} orbitals of boron atoms. The Dirac fermions possess an ultrahigh Fermi velocity up to 3.0$times$10$^{6}$ m/s, 4 times higher than that of graphene. The Youngs modules are calculated to be 129 and 200 GPa$cdot$nm along two different directions, which is comparable with steel. The ultrahigh Fermi velocity and high mechanical feature render borophane ideal for nanoelectronics applications.
An ultralow lattice thermal conductivity of 0.14 W$cdot$ m$^{-1} cdot$ K$^{-1}$ along the $vec b$ axis of As$_2$Se$_3$ single crystals was obtained at 300 K by first-principles calculations involving the density functional theory and the resolution of the Boltzmann transport equation. This ultralow lattice thermal conductivity arises from the combination of two mechanisms: 1) a cascade-like fall of the low-lying optical modes, which results in avoided crossings of these with the acoustic modes, low sound velocities and increased scattering rates of the acoustic phonons; and 2) the repulsion between the lone-pair electrons of the As cations and the valence $p$ orbitals of the Se anions, which leads to an increase in the anharmonicity of the bonds. The physical origins of these mechanisms lie on the nature of the chemical bonding in the material and its strong anisotropy. These results, whose validity has been addressed by comparison with SnSe, for which excellent agreement between the theoretical predictions and the experiments is achieved, point out that As$_2$Se$_3$ could exhibit improved thermoelectric properties.
From next generation gas turbines to scavenging waste heat from car exhausts, finding new materials with ultra-low thermal conductivity ($kappa$) has the potential to lead to large gains in device efficiency. Crystal structures with inherently low $kappa$ are consequently desirable, but candidate materials are rare and often difficult to make. Using first principles calculations and inelastic neutron scattering we have studied the pyrochlore La$_2$Zr$_2$O$_7$ which has been proposed as a next generation thermal barrier. We find that there is a highly anharmonic, approximately flat, vibrational mode associated with the kagome planes. Our results suggest that this mode is responsible for the low thermal conductivity observed in the pyrochlores and that kagome compounds will be a fruitful place to search for other low $kappa$ materials.
The thermal conductivity of silicon nanowires (SiNWs) is investigated by molecular dynamics (MD) simulation. It is found that the thermal conductivity of SiNWs can be reduced exponentially by isotopic defects at room temperature. The thermal conductivity reaches the minimum, which is about 27% of that of pure 28Si NW, when doped with fifty percent isotope atoms. The thermal conductivity of isotopic-superlattice structured SiNWs depends clearly on the period of superlattice. At a critical period of 1.09 nm, the thermal conductivity is only 25% of the value of pure Si NW. An anomalous enhancement of thermal conductivity is observed when the superlattice period is smaller than this critical length. The ultra-low thermal conductivity of superlattice structured SiNWs is explained with phonon spectrum theory.
Intrinsically low lattice thermal conductivity ($kappa_l$) is a desired requirement in many crystalline solids such as thermal barrier coatings and thermoelectrics. Here, we design an advanced machine-learning (ML) model based on crystal graph convolutional neural network that is insensitive to volumes (i.e., scale) of the input crystal structures to discover novel quaternary chalcogenides, AMMQ$_3$ (A/M/M=alkali, alkaline-earth, post-transition metals, lanthanides, Q=chalcogens). Upon screening the thermodynamic stability of $sim$ 1 million compounds using the ML model iteratively and performing density functional theory (DFT) calculations for a small fraction of compounds, we discover 99 compounds that are validated to be stable in DFT. Taking several DFT-stable compounds, we calculate their $kappa_l$ using phonon-Boltzmann transport equation, which reveals ultralow-$kappa_l$ ($<$ 2 Wm$^{-1}$K$^{-1}$ at room-temperature) due to their soft elasticity and strong phonon anharmonicity. Our work demonstrates the high-efficiency of scale-invariant ML model in predicting novel compounds and presents experimental research opportunities with these new compounds.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
