Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userRoles of intrinsic anisotropy and pi-band pairbreaking effects on critical currents in tilted c-axis MgB2 films probed by magneto-optical and transport measurements
154
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Investigations of MgB2 and Fe-based superconductors in recent years have revealed many unusual effects of multiband superconductivity but manifestations of anisotropic multiband effects in the critical current density Jc have not been addressed experimentally, mostly because of the difficulties to measure Jc along the c-axis. To investigate the effect of very different intrinsic anisotropies of sigma and pi electron bands in MgB2 on current transport, we grew epitaxial films with tilted c-axis (THETA ~ 19.5{deg}), which enabled us to measure the components of Jc both along the ab-plane and the c-axis using magneto-optical and transport techniques. These measurements were combined with scanning and transmission electron microscopy, which revealed terraced steps on the surface of the c-axis tilted films. The measured field and temperature dependencies of the anisotropic Jc(H) show that Jc,L parallel to the terraced steps is higher than Jc,T perpendicular to the terraced steps, and Jc of thinner films (50 nm) obtained from transport experiments at 0.1 T reaches ~10% of the depairing current density Jd in the ab plane, while magneto-optical imaging revealed much higher Jc at lower fields. To analyze the experimental data we developed a model of anisotropic vortex pinning which accounts for the observed behavior of Jc in the c-axis tilted films and suggests that the apparent anisotropy of Jc is affected by current pairbreaking effects in the weaker {pi} band. Our results indicate that the out-of-plane current transport mediated by the {pi} band could set the ultimate limit of Jc in MgB2 polycrystals.
rate research
Read More
The two tone intermodulation distortion arising in MgB2 thin films synthesized by hybrid physical-chemical vapour deposition is studied in order to probe the influence of the two bands on the nonlinear response of this superconductor. The measurements are carried out by using a dielectrically loaded copper cavity operating at 7 GHz. Microwave data on samples having critical temperatures above 41 K, very low resistivity values, and residual resistivity ratio larger than 10, are shown. The dependence of the nonlinear surface losses and of the third order intermodulation products on the power feeding the cavity and on the temperature is analyzed. At low power, the signal arising from distortion versus temperature shows the intrinsic s-wave behavior expected for this compound. Data are compared with measurements performed on Nb and YBCO thin films using the same technique.
Temperature dependent optical conductivities and DC resistivity of c-axis oriented superconducting (Tc = 39.6 K) MgB2 films (~ 450 nm) have been measured. The normal state ab-plane optical conductivities can be described by the Drude model with a temperature independent Drude plasma frequency of omega_{p,D}=13,600 +/- 100 cm-1 or 1.68 +/- 0.01 eV. The normal state resistivity is fitted by the Bloch-Gruneisen formula with an electron-phonon coupling constant lambda_{tr} = 0.13 +/- 0.02. The optical conductivity spectra below T_c of these films suggest that MgB2 is a multi-gap superconductor.
An important predicted, but so far uncharacterized, property of the new superconductor MgB2 is electronic anisotropy arising from its layered crystal structure. Here we report on three c-axis oriented thin films, showing that the upper critical field anisotropy ratio Hc2par/Hc2perp is 1.8 to 2.0, the ratio increasing with higher resistivity. Measurements of the magnetic field-temperature phase diagram show that flux pinning disappears at H* ~ 0.8Hc2perp(T) in untextured samples. Hc2par(0) is strongly enhanced by alloying to 39 T for the highest resistivity film, more than twice that seen in bulk samples.
We report the growth and properties of epitaxial MgB2 thin films on (0001) Al2O3 substrates. The MgB2 thin films were prepared by depositing boron films via RF magnetron sputtering, followed by a post-deposition anneal at 850C in magnesium vapor. X-ray diffraction and cross-sectional TEM reveal that the epitaxial MgB2 films are oriented with their c-axis normal to the (0001) Al2O3 substrate and a 30 degree rotation in the ab-plane with respect to the substrate. The critical temperature was found to be 35 K and the anisotropy ratio, Hc2(parallel to the film) / Hc2(pendicular to the film), about 3 at 25K. The critical current densities at 4.2 K and 20 K (at 1 T perpendicular magnetic field) are 5x10E6 A/cm2 and 1x10E6 A/cm2, respectively. The controlled growth of epitaxial MgB2 thin films opens a new avenue in both understanding superconductivity in MgB2 and technological applications.
We report the temperature dependence of the transport critical current density (Jc) in textured Sr1-xKxFe2As2/Fe (Sr122) tapes fabricated by an ex situ powder-in-tube process. Critical currents were measured in magnetic fields up to 0-15 T and/or the temperature range 4.2-30 K by using a dc four-probe method. It was found that textured Sr122 tapes heat-treated at low temperatures showed higher transport Jc performance due to much improved intergrain connections. At temperatures of 20 K, easily obtained using a cryocooler, Jc reached ~ 10^4 A/cm^2 in self field, which is the highest transport value of ferropnictide wires and tapes reported so far. Magneto-optical imaging observations further revealed significant and well distributed global Jc at 20 K in our tapes. These results demonstrate that 122 type superconducting tapes are promising for high-field applications at around 20 K.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
