Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userCharacterization of a multimode coplanar waveguide parametric amplifier
193
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We characterize a novel Josephson parametric amplifier based on a flux-tunable quarter-wavelength resonator. The fundamental resonance frequency is ~1GHz, but we use higher modes of the resonator for our measurements. An on-chip tuning line allows for magnetic flux pumping of the amplifier. We investigate and compare degenerate parametric amplification, involving a single mode, and nondegenerate parametric amplification, using a pair of modes. We show that we reach quantum-limited noise performance in both cases, and we show that the added noise can be less than 0.5 added photons in the case of low gain.
rate research
Read More
Losses in superconducting planar resonators are presently assumed to predominantly arise from surface-oxide dissipation, due to experimental losses varying with choice of materials. We model and simulate the magnitude of the loss from interface surfaces in the resonator, and investigate the dependence on power, resonator geometry, and dimensions. Surprisingly, the dominant surface loss is found to arise from the metal-substrate and substrate-air interfaces. This result will be useful in guiding device optimization, even with conventional materials.
We demonstrate edge-emitting exciton-polariton (polariton) lasing from 5 to 300 K and amplification of non-radiative guided polariton modes within ZnO waveguides. The mode dispersion below and above the lasing threshold is directly measured using gratings present on top of the sample, fully demonstrating the polaritonic nature of the lasing modes. The threshold is found to be similar to that of radiative polarions in planar ZnO microcavities. These results open broad perspectives for guided polaritonics by allowing an easier and more straightforward implementation of polariton integrated circuits exploiting fast propagating polaritons.
Superconducting coplanar waveguide resonators that can operate in strong magnetic fields are important tools for a variety of high frequency superconducting devices. Magnetic fields degrade resonator performance by creating Abrikosov vortices that cause resistive losses and frequency fluctuations, or suppressing superconductivity entirely. To mitigate these effects we investigate lithographically defined artificial defects in resonators fabricated from NbTiN superconducting films. We show that by controlling the vortex dynamics the quality factor of resonators in perpendicular magnetic fields can be greatly enhanced. Coupled with the restriction of the device geometry to enhance the superconductors critical field, we demonstrate stable resonances that retain quality factors $simeq 10^5$ at the single photon power level in perpendicular magnetic fields up to $B_perp simeq$ 20 mT and parallel magnetic fields up to $B_parallel simeq$ 6 T. We demonstrate the effectiveness of this technique for hybrid systems by integrating an InSb nanowire into a field resilient superconducting resonator, and use it to perform fast charge readout of a gate defined double quantum dot at $B_parallel =$ 1 T.
We discuss the design and implementation of thin film superconducting coplanar waveguide micro- resonators for pulsed ESR experiments. The performance of the resonators with P doped Si epilayer samples is compared to waveguide resonators under equivalent conditions. The high achievable filling factor even for small sized samples and the relatively high Q-factor result in a sensitivity that is superior to that of conventional waveguide resonators, in particular to spins close to the sample surface. The peak microwave power is on the order of a few microwatts, which is compatible with measurements at ultra low temperatures. We also discuss the effect of the nonuniform microwave magnetic field on the Hahn echo power dependence.
We demonstrate fast readout of a double quantum dot (DQD) that is coupled to a superconducting resonator. Utilizing parametric amplification in a nonlinear operational mode, we improve the signal-to-noise ratio (SNR) by a factor of 2000 compared to the situation with the parametric amplifier turned off. With an integration time of 400 ns we achieve a SNR of 76. By studying SNR as a function of the integration time we extract an equivalent charge sensitivity of 8 x 10^{-5} e/root(Hz). The high SNR allows us to acquire a DQD charge stability diagram in just 20 ms. At such a high data rate, it is possible to acquire charge stability diagrams in a live video-mode, enabling real time tuning of the DQD confinement potential.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
