Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userInterisotope effects in optimal dual-isotope loading into a shallow optical trap
126
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Examination of loading the isotopes $^{85}$Rb and $^{87}$Rb simultaneously into a shallow far-off-resonance trap (FORT) has revealed an unexpected decrease in maximum atom number loaded as compared to loading either isotope alone. The simultaneous loading of the FORT will be affected by additional homonuclear and heteronuclear light-assisted collisional losses. However, these losses are measured and found to be insufficient to explain the observed drop in total number of atoms loaded into the FORT. We find that our observations are consistent with a decrease in loading rate caused by inter-isotope disruptions of the efficient laser cooling required to load atoms into the optical trap.
rate research
Read More
We have examined loading of 85Rb atoms into a shallow Far-Off-Resonance Trap (FORT) from an optical molasses and compared it to loading from a Magneto-Optical Trap (MOT). We found that substantially more atoms could be loaded into the FORT via an optical molasses as compared to loading from the MOT alone. To determine why this was the case, we measured the rate of atoms loaded into the FORT and the losses from the FORT during the loading process. For both MOT and molasses loading, we examined atom load rate and losses over a range of detunings as well as hyperfine pump powers. We found that the losses induced during MOT loading were essentially the same as the losses induced during molasses loading at the same MOT/molasses detuning. In contrast, load rate of the molasses was higher than that of a MOT at a given detuning. This caused the optical molasses to be able to load more atoms than the MOT. Optimization of FORT loading form an optical molasses improved the number of atoms we could trap by a factor of two over that of optimal loading from a MOT.
One important factor which determines efficiency of loading cold atoms into an optical dipole trap from a magneto-optical trap is the distance between the trap centers. By studying this efficiency for various optical trap depths (2--110 mK) we find that for optimum dipole trap loading, longitudinal displacements up to 15 mm are necessary. An explanation for this observation is presented and compared with other work and a simple analytical formula is derived for the optimum distance between the trap centers.
We demonstrate an efficient scheme for continuous trap loading based upon spatially selective optical pumping. We discuss the case of $^{1}$S$_{0}$ calcium atoms in an optical dipole trap (ODT), however, similar strategies should be applicable to a wide range of atomic species. Our starting point is a reservoir of moderately cold ($approx 300 mu$K) metastable $^{3}$P$_{2}$-atoms prepared by means of a magneto-optic trap (triplet-MOT). A focused 532 nm laser beam produces a strongly elongated optical potential for $^{1}$S$_{0}$-atoms with up to 350 $mu$K well depth. A weak focused laser beam at 430 nm, carefully superimposed upon the ODT beam, selectively pumps the $^{3}$P$_{2}$-atoms inside the capture volume to the singlet state, where they are confined by the ODT. The triplet-MOT perpetually refills the capture volume with $^{3}$P$_{2}$-atoms thus providing a continuous stream of cold atoms into the ODT at a rate of $10^7 $s$^{-1}$. Limited by evaporation loss, in 200 ms we typically load $5 times 10^5$ atoms with an initial radial temperature of 85 $mu$K. After terminating the loading we observe evaporation during 50 ms leaving us with $10^5$ atoms at radial temperatures close to 40 $mu$K and a peak phase space density of $6.8 times 10^{-5}$. We point out that a comparable scheme could be employed to load a dipole trap with $^{3}$P$_{0}$-atoms.
Neutral Ytterbium (YbI) and singly ionized Ytterbium (YbII) is widely used in experiments in quantum optics, metrology and quantum information science. We report on the investigation of isotope selective two-photoionisation of YbI that allows for efficient loading of ion traps with YbII. Results are presented on two-colour (399 nm and 369 nm) and single-colour (399 nm) photoionisation and their efficiency is compared to electron impact ionisation. Nearly deterministic loading of a desired number of YbII ions into a linear Paul trap is demonstrated.
We present an effective and fast (few microseconds) procedure for transferring ultra-cold atoms from the ground state in a harmonic trap into the desired bands of an optical lattice. Our shortcut method is a designed pulse sequence where the time duration and the interval in each step are fully optimized in order to maximize robustness and fidelity of the final state with respect to the target state. The atoms can be prepared in a single band with even or odd parity, and superposition states of different bands can be prepared and manipulated. Furthermore, we extend this idea to the case of two-dimensional or three-dimensional optical lattices where the energies of excited states are degenerate. We experimentally demonstrate various examples and show very good agreement with the theoretical model. Efficient shortcut methods will find applications in the preparation of quantum systems, in quantum information processing, in precise measurement and as a starting point to investigate dynamics in excited bands.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
