Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userNegative Backaction Noise in Interferometric Detection of a Microlever
122
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Interferometric detection of mirror displacements is intrinsically limited by laser shot noise. In practice, however, it is often limited by thermal noise. Here we report on an experiment performed at the liquid helium temperature to overcome the thermal noise limitation and investigate the effect of classical laser noise on a microlever that forms a Fabry-Perot cavity with an optical fiber. The spectral noise densities show a region of negative contribution of the backaction noise close to the resonance frequency. We interpret this noise reduction as a coherent coupling of the microlever to the laser intensity noise. This optomechanical effect could be used to improve the detection sensitivity as discussed in proposals going beyond the Standard Quantum Limit.
rate research
Read More
We present a frequency domain model of shot noise in the photodetection of ultrashort optical pulse trains using a time-varying analysis. Shot noise-limited photocurrent power spectral densities, signal-to-noise expressions, and shot noise spectral correlations are derived that explicitly include the finite response of the photodetector. It is shown that the strength of the spectral correlations in the shot noise depends on the optical pulse width, and that these correlations can create orders-of-magnitude imbalance between the shot noise-limited amplitude and phase noise of photonically generated microwave carriers. It is also shown that only by accounting for spectral correlations can shot noise be equated with the fundamental quantum limit in the detection of optical pulse-to-pulse timing jitter.
Thermal frequency fluctuations in optical cavities limit the sensitivity of precision experiments ranging from gravitational wave observatories to optical atomic clocks. Conventional modeling of these noises assumes a linear response of the optical field to the fluctuations of cavity frequency. Fundamentally, however, this response is nonlinear. Here we show that nonlinearly transduced thermal fluctuations of cavity frequency can dominate the broadband noise in photodetection, even when the magnitude of fluctuations is much smaller than the cavity linewidth. We term this noise thermal intermodulation noise and show that for a resonant laser probe it manifests as intensity fluctuations. We report and characterize thermal intermodulation noise in an optomechanical cavity, where the frequency fluctuations are caused by mechanical Brownian motion, and find excellent agreement with our developed theoretical model. We demonstrate that the effect is particularly relevant to quantum optomechanics: using a phononic crystal $Si_3N_4$ membrane with a low mass, soft-clamped mechanical mode we are able to operate in the regime where measurement quantum backaction contributes as much force noise as the thermal environment does. However, in the presence of intermodulation noise, quantum signatures of measurement are not revealed in direct photodetectors. The reported noise mechanism, while studied for an optomechanical system, can exist in any optical cavity.
Ultra-low frequency noise lasers have been widely used in laser-based experiments. Most narrow-linewidth lasers are implemented by actively suppressing their frequency noise through a frequency noise servo loop (FNSL). The loop bandwidths (LBW) of FNSLs are currently below megahertz, which is gradually tricky to meet application requirements, especially for wideband quantum sensing experiments. This article has experimentally implemented an FNSL with loop-delay-limited 3.5 MHz LBW, which is an order higher than the usual FNSLs. Using this FNSL, we achieved 70 dB laser frequency noise suppression over 100 kHz Fourier frequency range. This technology has broad applications in vast fields where wideband laser frequency noise suppression is inevitable.
We report on a calibration procedure that enhances the precision of an interferometer based frequency stabilization by several orders of magnitude. For this purpose the frequency deviations of the stabilization are measured precisely by means of a frequency comb. This allows to implement several calibration steps that compensate different systematic errors. The resulting frequency deviation is shown to be less than $5.7 $MHz (rms $1.6 $MHz) in the whole wavelength interval $750 - 795 $nm. Wide tuning of a stabilized laser at this exceptional precision is demonstrated.
A nanoparticle detection scheme with single particle resolution is presented. The sensor contains only a taper fiber thus offering the advantages of compactness and installation flexibility. Sensing method is based on monitoring the transmitted light power which shows abrupt jumps with each particle binding to the taper surface. The experimental validation of the sensor is demonstrated with polystyrene nanoparticles of radii 120 nm and 175 nm in the 1550 nm wavelength band.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
