Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userA 1.82 m^2 ring laser gyroscope for nano-rotational motion sensing
421
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We present a fully active-controlled He-Ne ring laser gyroscope, operating in square cavity 1.35 m in side. The apparatus is designed to provide a very low mechanical and thermal drift of the ring cavity geometry and is conceived to be operative in two different orientations of the laser plane, in order to detect rotations around the vertical or the horizontal direction. Since June 2010 the system is active inside the Virgo interferometer central area with the aim of performing high sensitivity measurements of environmental rotational noise. So far, continuous not attempted operation of the gyroscope has been longer than 30 days. The main characteristics of the laser, the active remote-controlled stabilization systems and the data acquisition techniques are presented. An off-line data processing, supported by a simple model of the sensor, is shown to improve the effective long term stability. A rotational sensitivity at the level of ten nanoradiants per squareroot of Hz below 1 Hz, very close to the required specification for the improvement of the Virgo suspension control system, is demonstrated for the configuration where the laser plane is horizontal.
rate research
Read More
GINGERino is a large frame laser gyroscope investigating the ground motion in the most inner part of the underground international laboratory of the Gran Sasso, in central Italy. It consists of a square ring laser with a $3.6$ m side. Several days of continuous measurements have been collected, with the apparatus running unattended. The power spectral density in the seismic bandwidth is at the level of $10^{-10} rm{(rad/s)/sqrt{Hz}}$. A maximum resolution of $30,rm{prad/s}$ is obtained with an integration time of few hundred seconds. The ring laser routinely detects seismic rotations induced by both regional earthquakes and teleseisms. A broadband seismic station is installed on the same structure of the gyroscope. First analysis of the correlation between the rotational and the translational signal are presented.
We report on the measurements of tilt noise performed at the Virgo site with a ring laser gyroscope. The apparatus is a He-Ne laser operating in a square cavity mounted on a vertical plane perpendicular to the north-south arm of the inteferometer. We discuss the possibility of using the ring laser signal to improve the performances of the control system of the Virgo seismic suspensions. The comparison between the ring laser signal and the control signals for the longitudinal translations of the inverted pendulum (IP) shows remarkable coherence in the frequency range 20-200 mHz.
Interferometric gyroscope systems are being developed with the goal of measuring general-relativistic effects including frame-dragging effects. Such devices are also capable of performing searches for Lorentz violation. We summarize efforts that relate gyroscope measurements to coefficients for Lorentz violation in the gravity sector of the Standard-Model Extension.
Large frame ring laser gyroscopes are top sensitivity inertial sensors able to measure absolute angular rotation rate below $rm mathbf{prad/s}$ in few seconds. The development of ring laser based on a simple mechanical structure, usually called hetero lithic structure, requires to control the geometry of the apparatus. Our prototype GP2 is a middle size ring laser, whose main purpose is the geometry control with opto-mechanical means. The first tests have been performed, and the data analysed. The lengths of the diagonals of the ring cavity have been measured with $pmb{mu {rm m}}$ accuracy, and continuous operation has been obtained, without loss of sensitivity. GP2 is located in a standard laboratory, with a temperature stabilisation around 1 degree Celsius. The analysis shows that middle size ring lasers can obtain nrad/s sensitivity also in a standard environment.
We propose an under-ground experiment to detect the general relativistic effects due to the curvature of space-time around the Earth (de Sitter effect) and to rotation of the planet (dragging of the inertial frames or Lense-Thirring effect). It is based on the comparison between the IERS value of the Earth rotation vector and corresponding measurements obtained by a tri-axial laser detector of rotation. The proposed detector consists of six large ring-lasers arranged along three orthogonal axes. In about two years of data taking, the 1% sensitivity required for the measurement of the Lense-Thirring drag can be reached with square rings of 6 $m$ side, assuming a shot noise limited sensitivity ($ 20 prad/s/sqrt{Hz}$). The multi-gyros system, composed of rings whose planes are perpendicular to one or the other of three orthogonal axes, can be built in several ways. Here, we consider cubic and octahedron structures. The symmetries of the proposed configurations provide mathematical relations that can be used to study the stability of the scale factors, the relative orientations or the ring-laser planes, very important to get rid of systematics in long-term measurements, which are required in order to determine the relativistic effects.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
