Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userA portable laser system for high precision atom interferometry experiments
116
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We present a modular rack-mounted laser system for the cooling and manipulation of neutral rubidium atoms which has been developed for a portable gravimeter based on atom interferometry that will be capable of performing high precision gravity measurements directly at sites of geophysical interest. This laser system is constructed in a compact and mobile design so that it can be transported to different locations, yet it still offers improvements over many conventional laboratory-based laser systems. Our system is contained in a standard 19 rack and emits light at five different frequencies simultaneously on up to 12 fibre ports at a total output power of 800 mW. These frequencies can be changed and switched between ports in less than a microsecond. The setup includes two phase-locked diode lasers with a phase noise spectral density of less than 1 mu rad/sqrt(Hz) in the frequency range in which our gravimeter is most sensitive to noise. We characterize this laser system and evaluate the performance limits it imposes on an interferometer.
rate research
Read More
We describe an optical bench in which we lock the relative frequencies or phases of a set of three lasers in order to use them in a cold atoms interferometry experiment. As a new feature, the same two lasers serve alternately to cool atoms and to realize the atomic interferometer. This requires a fast change of the optical frequencies over a few GHz. The number of required independent laser sources is then only 3, which enables the construction of the whole laser system on a single transportable optical bench. Recent results obtained with this optical setup are also presented.
We propose a set of experiments in which Ramsey-fringe techniques are tailored to probe transitions originating and terminating on the same ground state level. When pulses of resonant radiation, separated by a time delay $% T, $ interact with atoms, it is possible to produce Ramsey fringes having widths of order 1/T. If each pulse contains two counterpropagating travelling wave modes, the atomic wave function is split into two or more components having different center-of-mass momenta. Matter-wave interference of these components leads to atomic gratings, which have been observed in both spatially separated fields and time separated fields. Time-dependent signals can be transformed into frequency dependent signals, leading to ground state Ramsey fringes (GSRF). The signals can be used to probe many problems of fundamental importance: a precise measurement of the earth gravitational acceleration $g$ and residual gravity in a microgravity environment with an accuracy $6 10^{-9}g;$ the rotation rate measurement with an accuracy of 6 10^{-3} deg/h; the recoil frequency measurement. Since only transitions originating and terminating on the same ground state are involved, frequency measurements can be carried out using lasers phase-locked by quartz oscillators having relatively low frequency. Our technique may allow one to increase the precision by a factor of 100 (the rf- to quartz oscillator frequencies ratio) over previous experiments based on Raman-Ramsey fringes or reduce on the same factor requirements for frequency stabilization.
This paper reports on a detailed performance characterization of a recently developed optical single-sideband (OSSB) laser system based on an IQ modulator and second-harmonic generation for rubidium atom interferometry experiments. The measured performance is used to evaluate the noise contributions of this OSSB laser system when it is applied to drive stimulated Raman transitions in $^{87}$Rb for precision measurements of gravitational acceleration. The laser system suppresses unwanted sideband components, but additional phase shift compensation needs to be applied when performing frequency chirps with such an OSSB laser system. The total phase noise contribution of the OSSB laser system in the current experiment is 72 mrad for a single atom-interferometry sequence with interrogation times of $T=120$ ms, which corresponds to a relative precision of 32 n$g$ per shot. The dominant noise sources are found in the relative intensity fluctuations between sideband and carrier components and the phase noise of the microwave source.
We propose a new scheme for an improved determination of the Newtonian gravitational constant G and evaluate it by numerical simulations. Cold atoms in free fall are probed by atom interferometry measurements to characterize the gravitational field generated by external source masses. Two source mass configurations having different geometry and using different materials are compared to identify an optimized experimental setup for the G measurement. The effects of the magnetic fields used to manipulate the atoms and to control the interferometer phase are also characterized.
We present a source engineering concept for a binary quantum mixture suitable as input for differential, precision atom interferometry with drift times of several seconds. To solve the non-linear dynamics of the mixture, we develop a set of scaling approach equations and verify their validity contrasting it to the one of a system of coupled Gross-Pitaevskii equations. This scaling approach is a generalization of the standard approach commonly used for single species. Its validity range is discussed with respect to intra- and inter-species interaction regimes. We propose a multi-stage, non-linear atomic lens sequence to simultaneously create dual ensembles with ultra-slow kinetic expansion energies, below 15 pK. Our scheme has the advantage of mitigating wave front aberrations, a leading systematic effect in precision atom interferometry.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
