Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userIntergrain current flow in a randomly oriented polycrystalline SmFeAsO0.85 oxypnictide
351
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We report a direct current transport study of the local intergrain connections in a polycrystalline SmFeAsO0.85 (Sm1111) bulk, for which we earlier estimated significant intergranular critical current density Jc. Our combined low temperature laser scanning microscopy (LTLSM) and scanning electron microscopy observations revealed only few grain-to-grain transport current paths, most of which switched off when a magnetic field was applied. These regions typically occur where current crosses Fe-As, which is a normal-metal wetting-phase that surrounds Sm1111 grains, producing a dense array of superconducting-normal-superconducting contacts. Our study points out the need to reduce the amount of grain boundary-wetting Fe-As phase, as well as the crack density within pnictide grains, as these defects produce a multiply connected current-blocking network.
rate research
Read More
In order to understand why the inter- and intra-granular current densities of polycrystalline superconducting oxypnictides differ by three orders of magnitude, we have conducted combined magneto-optical and microstructural examinations of representative randomly oriented polycrystalline Nd and Sm single-layer oxypnictides. Magneto optical images show that the highest Jc values are observed within single grains oriented with their c axes perpendicular to the observation plane, implying that the intragranular current is anisotropic. The much lower intergranular Jc is at least partially due to many extrinsic factors, because cracks and a ubiquitous wetting As-Fe phase are found at many grain boundaries. However, some grain boundaries are structurally clean under high resolution transmission electron microscopy examination. Because the whole-sample global Jc(5K) values of the two samples examined are 1000-4000 A/cm2, some 10-40 times that found in random, polycrystalline YBa2Cu3O7-x, it appears that the dominant obstruction to intergranular current flow of many present samples is extrinsic, though some intrinsic limitation of current flow across grain boundaries cannot yet be ruled out.
Magnetic measurements and 57Fe Mossbauer spectroscopy studies were performed on oxygen- deficient high temperature superconductor SmFeAsO0.85 with TC=52.4 K. The upper-critical behavior (HC2) values were extracted from the real part of ac measurements. The field dependence of HC2 is consistent with a two band model. M{o}ssbauer spectra below and above TC consist of a singlet and a doublet, which are attributed to Fe ions which have two or one oxygen ions in their close vicinity, respectively. No change is observed in the major (~75%) singlet related to Fe ions surrounded by two oxygen ions. On the other hand, the doublet which senses oxygen vacancies shows a well defined magnetic sextet below TC. This indicates coexistence on a microscopic level of the two mutually exclusive states namely: superconductivity which is confined to the Fe-As layers and magnetism, in the same layers. Alternatively, the hyperfine parameters of the doublet are similar to the reported values of FeAs which orders magnetically at 77 K. Thus the magnetic features observed below TC, may be related to FeAs as an extra phase.
The discovery of superconductivity at 39 K in MgB2[1] raises many issues. One of the central questions is whether this new superconductor resembles a high-temperature-cuprate superconductor or a low-temperature metallic superconductor in terms of its current carrying characteristics in applied magnetic fields. In spite of the very high transition temperatures of the cuprate superconductors, their performance in magnetic fields has several drawbacks[2]. Their large anisotropy restricts high bulk current densities to much less than the full magnetic field-temperature (H-T) space over which superconductivity is found. Further, weak coupling across grain boundaries makes transport current densities in untextured polycrystalline forms low and strongly magnetic field sensitive[3,4]. These studies of MgB2 address both issues. In spite of the multi-phase, untextured, nano-scale sub-divided nature of our samples, supercurrents flow throughout without the strong sensitivity to weak magnetic fields characteristic of Josephson-coupled grains[3]. Magnetization measurements over nearly all of the superconducting H-T plane show good temperature scaling of the flux pinning force, suggestive of a current density determined by flux pinning. At least two length scales are suggested by the magnetization and magneto optical (MO) analysis but the cause of this seems to be phase inhomogeneity, porosity, and minority insulating phase such as MgO rather than by weakly coupled grain boundaries. Our results suggest that polycrystalline ceramics of this new class of superconductor will not be compromised by the weak link problems of the high temperature superconductors, a conclusion with enormous significance for applications if higher temperature analogs of this compound can be discovered.
Investigating the anisotropy of superconductors permits an access to fundamental properties. Having succeeded in the fabrication of epitaxial superconducting LaFeAs(O,F) thin films we performed an extensive study of electrical transport properties. In face of multiband superconductivity we can demonstrate that a Blatter scaling of the angular dependent critical current densities can be adopted, although being originally developed for single band superconductors. In contrast to single band superconductors the mass anisotropy of LaFeAs(O,F) is temperature dependent. A very steep increase of the upper critical field and the irreversibility field can be observed at temperatures below 6K, indicating that the band with the smaller gap is in the dirty limit. This temperature dependence can be theoretically described by two dominating bands responsible for superconductivity. A pinning force scaling provides insight into the prevalent pinning mechanism and can be specified in terms of the Kramer model.
The stability against quench is one of the main issue to be pursued in a superconducting material which should be able to perform at very high levels of current densities. Here we focus on the connection between the critical current $I_c$ and the quenching current $I^*$ associated to the so-called flux-flow instability phenomenon, which sets in as an abrupt transition from the flux flow state to the normal state. To this purpose, we analyze several current-voltage characteristics of three types of iron-based thin films, acquired at different temperature and applied magnetic field values. For these samples, we discuss the impact of a possible coexistence of intrinsic electronic mechanisms and extrinsic thermal effects on the quenching current dependence upon the applied magnetic field. The differences between the quenching current and the critical current are reported also in the case of predominant intrinsic mechanisms. Carrying out a comparison with high-temperature cuprate superconductors, we suggest which material can be the best trade-off between maximum operating temperature, higher upper critical field and stability under high current bias.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
