Do you want to publish a course? Click here

4f-derived Fermi Surfaces of CeRu2(Si[1-x]Ge[x])2 near the Quantum Critical Point: Resonant Soft X-ray ARPES Study

229   0   0.0 ( 0 )
 Added by Tetsuo Okane
 Publication date 2009
  fields Physics
and research's language is English




Ask ChatGPT about the research

Angle-resolved photoelectron spectroscopy in the Ce 3d-4f excitation region was measured for the paramagnetic state of CeRu2Si2, CeRu2(Si0.82Ge0.18)2, and LaRu2Si2 to investigate the changes of the 4$f$ electron Fermi surfaces around the quantum critical point. While the difference of the Fermi surfaces between CeRu2Si2 and LaRu2Si2 was experimentally confirmed, a strong 4f-electron character was observed in the band structures and the Fermi surfaces of CeRu2Si2 and CeRu2(Si0.82Ge0.18)2, consequently indicating a delocalized nature of the 4$f$ electrons in both compounds. The absence of Fermi surface reconstruction across the critical composition suggests that SDW quantum criticality is more appropriate than local quantum criticality in CeRu2(Si[1-x]Ge[x])2.



rate research

Read More

130 - Veljko Zlatic 2005
The evolution of the thermopower EuCu{2}(Ge{1-x}Si{x}){2} intermetallics, which is induced by the Si-Ge substitution, is explained by the Kondo scattering of conduction electrons on the Eu ions which fluctuate between the magnetic 2+ and non-magnetic 3+ Hunds rule configurations. The Si-Ge substitution is equivalent to chemical pressure which modifies the coupling and the relative occupation of the {it f} and conduction states.
Soft and hard X-ray photoelectron spectroscopy (PES) has been performed for one of the heavy fermion system CeRu$_2$Si$_2$ and a $4f$-localized ferromagnet CeRu$_2$Ge$_2$ in the paramagnetic phase. The three-dimensional band structures and Fermi surface (FS) shapes of CeRu$_2$Si$_2$ have been determined by soft X-ray $h u$-dependent angle resolved photoelectron spectroscopy (ARPES). The differences in the Fermi surface topology and the non-$4f$ electronic structures between CeRu$_2$Si$_2$ and CeRu$_2$Ge$_2$ are qualitatively explained by the band-structure calculation for both $4f$ itinerant and localized models, respectively. The Ce valences in CeRu$_2X_2$ ($X$ = Si, Ge) at 20 K are quantitatively estimated by the single impurity Anderson model calculation, where the Ce 3d hard X-ray core-level PES and Ce 3d X-ray absorption spectra have shown stronger hybridization and signature for the partial $4f$ contribution to the conduction electrons in CeRu$_2$Si$_2$.
We describe a strategy for using resonant soft x-ray scattering (RSXS) to study the electronic structure of transition metal oxide quantum wires. Using electron beam lithography and ion milling, we have produced periodic, patterned arrays of colossal magnetoresistance (CMR) phase La(1-x)Sr(x)MnO(3) consisting of ~ 5000 wires, each of which is 80 nm in width. The scattered intensity exhibits a series of peaks that can be interpreted as Bragg reflections from the periodic structure or, equivalently, diffraction orders from the grating-like structure. RSXS measurements at the Mn L(2,3) edge, which has a large magnetic cross section, show clear evidence for a magnetic superstructure with a commensurate period of five wires, which we interpret as commensurately modulated antiferromagnetism. This superstructure, which is accompanied by non-trivial reorganization of the magnetization within each wire, likely results from classical dipole interactions among the wires. We introduce a simple, exactly soluble, analytic model of the scattering that captures, semi-quantitatively, the primary features in the RSXS data; this model will act as a foundation for forthcoming, detailed studies of the magnetic structure in these systems.
We studied the resonant diffraction signal from stepped surfaces of SrTiO3 at the Ti 2p -> 3d (L2,3) resonance in comparison with x-ray absorption (XAS) and specular reflectivity data. The steps on the surface form an artificial superstructure suited as a model system for resonant soft x-ray diffraction. A small step density on the surface is sufficient to produce a well defined diffraction peak, showing the high sensitivity of the method. At larger incidence angles, the resonant diffraction spectrum from the steps on the surface resembles the spectrum for specular reflectivity. Both deviate from the XAS data in the relative peak intensities and positions of the peak maxima. We determined the optical parameters of the sample across the resonance and found that the differences between the XAS and scattering spectra reflect the different quantities probed in the different signals. When recorded at low incidence or detection angles, XAS and specular reflectivity spectra are distorted by the changes of the angle of total reflection with energy. Also the step peak spectra, though less affected, show an energy shift of the peak maxima in grazing incidence geometry.
We have measured de Haas-van Alphen oscillations of Cr$_{1-x}$V$_x$, $0 le x le 0.05$, at high fields for samples on both sides of the quantum critical point at $x_c=0.035$. For all samples we observe only those oscillations associated with a single small hole band with magnetic breakdown orbits of the reconstructed Fermi surface evident for $x<x_c$. The absence of oscillations from Fermi surface sheets most responsible for the spin density wave (SDW) in Cr for $x>x_c$ is further evidence for strong fluctuation scattering of these charge carriers well into the paramagnetic regime. We find no significant mass enhancement of the carriers in the single observed band at any $x$. An anomalous field dependence of the dHvA signal for our $x=0.035$ crystal at particular orientations of the magnetic field is identified as due to magnetic breakdown that we speculate results from a field induced SDW transition at high fields.
comments
Fetching comments Fetching comments
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا