Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userMagnetic properties of undoped Cu2O fine powders with magnetic impurities and/or cation vacancies
102
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Fine powders of micron- and submicron-sized particles of undoped Cu2O semiconductor, with three different sizes and morphologies have been synthesized by different chemical processes. These samples include nanospheres 200 nm in diameter, octahedra of size 1 micron, and polyhedra of size 800 nm. They exhibit a wide spectrum of magnetic properties. At low temperature, T = 5 K, the octahedron sample is diamagnetic. The nanosphere is paramagnetic. The other two polyhedron samples synthesized in different runs by the same process are found to show different magnetic properties. One of them exhibits weak ferromagnetism with T_C = 455 K and saturation magnetization, M_S = 0.19 emu/g at T = 5 K, while the other is paramagnetic. The total magnetic moment estimated from the detected impurity concentration of Fe, Co, and Ni, is too small to account for the observed magnetism by one to two orders of magnitude. Calculations by the density functional theory (DFT) reveal that cation vacancies in the Cu2O lattice are one of the possible causes of induced magnetic moments. The results further predict that the defect-induced magnetic moments favour a ferromagnetically coupled ground state if the local concentration of cation vacancies, n_C, exceeds 12.5%. This offers a possible scenario to explain the observed magnetic properties. The limitations of the investigations in the present work, in particular in the theoretical calculations, are discussed and possible areas for further study are suggested.
rate research
Read More
The present work reports synthesis, as well as a detailed and careful characterization of structural, magnetic, and dielectric properties of differently tempered undoped and doped CaCu3Ti4O12 (CCTO) ceramics. For this purpose, neutron and x-ray powder diffraction, SQUID measurements, and dielectric spectroscopy have been performed. Mn-, Fe-, and Ni-doped CCTO ceramics were investigated in great detail to document the influence of low-level doping with 3d metals on the antiferromagnetic structure and dielectric properties. In the light of possible magnetoelectric coupling in these doped ceramics, the dielectric measurements were also carried out in external magnetic fields up to 7 T, showing a minor but significant dependence of the dielectric constant on the applied magnetic field. Undoped CCTO is well-known for its colossal dielectric constant in a broad frequency and temperature range. With the present extended characterization of doped as well as undoped CCTO, we want to address the question why doping with only 1% Mn or 0.5% Fe decreases the room-temperature dielectric constant of CCTO by a factor of ~100 with a concomitant reduction of the conductivity, whereas 0.5% Ni doping changes the dielectric properties only slightly. In addition, diffraction experiments and magnetic investigations were undertaken to check for possible correlations of the magnitude of the colossal dielectric constants with structural details or with magnetic properties like the magnetic ordering, the Curie-Weiss temperatures, or the paramagnetic moment. It is revealed, that while the magnetic ordering temperature and the effective moment of all investigated CCTO ceramics are rather similar, there is a dramatic influence of doping and tempering time on the Curie-Weiss constant.
We present an ab initio study of pure and doped TiO2 in the rutile and anatase phases. The main purpose of this work is to determine the role played by different defects and different crystal structures in the appearance of magnetic order. The calculations were performed for varying impurity and vacancy concentrations in both TiO2 structures. For Co impurities the local magnetic moment remained almost independent of the concentration and distribution while for Cu this is not the case, there is magnetism for low concentrations that disappears for the higher ones. Impurity-impurity interactions in both structures favor linear ordering of them. Magnetism in un-doped samples appears for certain vacancy concentrations and structural strain.
We have investigated the magnetic properties of carbon powders which consist of nanodisks, nanocones, and a small fraction of carbon-black particles. Magnetization measurements were carried out using a superconducting quantum interference device in magnetic fields $-5<mu_{0}H<5:mathrm{T}$ for temperatures in the range $2leq T<350:mathrm{K}$. Measurements of the magnetization $M$ versus temperature $T$ and magnetic field $mu_{0}H$ for these carbon samples show diamagnetism and paramagetism with an additional ferromagnetic contribution. The ferromagnetic magnetization is in agreement with the calculated magnetization from Fe impurities as determined by the particle-induced x-ray emission method ($<75:mumathrm{g/g}$). Magnetization measurements in weak magnetic fields show thermal hysteresis, and for strong fields the magnetization $M$ decreases as $Msim aT^{-alpha}$ with $alpha<1$, which is slower than the Curie law ($alpha=1$), when the temperature increases. The magnetization $M$ versus magnetic field $mu_{0}H$ shows paramagnetic free-spin $S=frac{1}{2}$ and $frac{3}{2}$ behaviors for temperatures $T=2:mathrm{K}$ and $15leq Tleq50:mathrm{K}$, respectively. A tendency for localization of electrons was found by electron spin resonance when the temperature $T$ decreases ($2<T<40:mathrm{K}$). The magnetic properties in these carbon cone and disk powder samples are more complex than a free-spin model predicts, which is apparently valid only for the temperature $T=2:mathrm{K}$.
Elemental defects in transition metal oxides is an important and intriguing subject that result in modifications in variety of physical properties including atomic and electronic structure, optical and magnetic properties. Understanding the formation of elemental vacancies and their influence on different physical properties is essential in studying the complex oxide thin films. In this study, we investigated the physical properties of epitaxial SrRuO3 thin films by systematically manipulating cation and/or oxygen vacancies, via changing the oxygen partial pressure (P(O2)) during the pulsed laser epitaxy (PLE) growth. Ru vacancies in the low-P(O2)-grown SrRuO3 thin films induce lattice expansion with the suppression of the ferromagnetic TC down to ~120 K. Sr vacancies also disturb the ferromagnetic ordering, even though Sr is not a magnetic element. Our results indicate that both A and B cation vacancies in an ABO3 perovskite can be systematically engineered via PLE, and the structural, electrical, and magnetic properties can be tailored accordingly.
Multiferroic (Bi1-xLaxFeO3)0.5(PbTiO3)0.5 ceramics was prepared from mechanical synthesized nanopowders. The XRD studies revealed the tetragonal structure and the tetragonality decreased with La content. Dielectric response of the compounds was found to contain three anomalies: 1) relaxor-like behavior due to lattice disorder (below 300 K); 2) dielectric permittivity maxima at~400 K attributed to the presence of oxygen vacancies; 3) grain boundary effect above 475 K. The Curie point at ~500 K was observed for the compound with x=0.5. The composition near the morphotropic boundary: (Bi0.8La0.2FeO3)0.5(PbTiO3)0.5 shoved the highest remnant magnetization. The irreversible magnetic properties of the (Bi1-xLaxFeO3)0.5(PbTiO3)0.5 compounds can be explained in terms of disorder induced spin-glass behavior due to random substitution of La or Pb ions for Bi sites. A sharp step in magnetization about 250 K is caused by the A-site distortion associated with tilts of FeO6 octahedra leading to modification of Fe-O-Fe angles and of antiferromagnetic coupling between magnetic Fe3+ moments.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
