Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userSpin Bias Measurement Based on a Quantum Point Contact
213
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Electron charge transport through a quantum point contact (QPC) driven by an asymmetric spin bias is studied. A large charge current is induced when the transmission coefficient of the QPC jumps from one integer plateau to the next. Furthermore, for an open external circuit, the induced charge bias instead of the charge current is found to be quite large. It provides an efficient and practical way to detect spin bias by using a very simple device, a QPC or a STM tip. In addition, with the aid of magnetic field, polarization direction of the spin bias can also be determined.
rate research
Read More
A proposal of a spin separator based on the spin Zeeman effect in Y-shaped nanostructure with a quantum point contact is presented. Our calculations show that the appropriate tuning of the quantum point contact potential and the external magnetic field leads to the spin separation of the current: electrons with opposite spins flow through the different output branches. We demonstrate that this effect is robust against the scattering on impurities. The proposed device can also operate as a spin detector, in which -- depending on the electron spin -- the current flows through one of the output branches.
We present a novel design for a single-mode, truly sub-wavelength THz disk laser based on a nano-composite gain medium comprising an array of metal/ferromagnetic point contacts embedded in a thin dielectric layer. Stimulated emission of light occurs in the point contacts as a result of spin-flip relaxation of spin-polarized electrons that are injected from the ferromagnetic side of the contacts. Ultra-high electrical current densities in the contacts and a dielectric material with a large refractive index, neither condition being achievable in conventional semiconductor media, allows the thresholds of lasing to be overcome for the lowest-order modes of the disk, hence making single-mode operation possible.
We measure the transmission phase of a quantum point contact (QPC) at a low carrier density in which electron interaction is expected to play an important role and anomalous behaviors are observed. In the first conductance plateau, the transmission phase shifts monotonically as the carrier density is decreased by the gate voltage. When the conductance starts to decrease, in what is often called the 0.7 regime, the phase exhibits an anomalous increase compared with the noninteracting model. The observation implies an increase in the wave vector as the carrier density is decreased, suggesting a transition to a spin-incoherent Luttinger liquid.
We introduce a new scanning probe technique derived from scanning gate microscopy (SGM) in order to investigate thermoelectric transport in two-dimensional semiconductor devices. The thermoelectric scanning gate Microscopy (TSGM) consists in measuring the thermoelectric voltage induced by a temperature difference across a device, while scanning a polarized tip that locally changes the potential landscape. We apply this technique to perform interferometry of the thermoelectric transport in a quantum point contact (QPC). We observe an interference pattern both in SGM and TSGM images, and evidence large differences between the two signals in the low density regime of the QPC. In particular, a large phase jump appears in the interference fringes recorded by TSGM, which is not visible in SGM. We discuss this difference of sensitivity using a microscopic model of the experiment, based on the contribution from a resonant level inside or close to the QPC. This work demonstrates that combining scanning gate microscopy with thermoelectric measurements offers new information as compared to SGM, and provides a direct access to the derivative of the device transmission with respect to energy, both in amplitude and in phase.
We have developed a novel technique for detection of spin polarization with a quantum dot weakly coupled to the objective device. The disturbance to the object in this technique is very small since the detection is performed through sampling of single electrons in the object with very slow rate. We have applied the method to a quantum point contact (QPC) under a spin-orbit interaction. A high degree of spin polarization in the vicinity of the QPC was detected when the conductance stayed on a plateau at a half of the unit conductance quantum ($G_{rm q}/2equiv e^2/h$), and also on another plateau at $2e^2/h$. On the half-quantum plateau, the degree of polarization $P$ decreased with the bias source-drain voltage of the QPC while $P$ increased on the single-quantum plateau, manifesting that different mechanisms of polarization were working on these plateaus. Very long spin relaxation times in the detector quantum dot probably due to dynamical nuclear spin polarization were observed. Anomalous decrease of $P$ around zero-bias was observed at a Kondo-like resonance peak.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
