Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userTheory of Magnetic Order in $ Fe_{1+y}Te_{1-x}Se_x$
125
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We develop a local spin model to explain the rich magnetic structures in the iron-based superconductors $Fe_{1+y}Te_{1-x}Se_x$. We show that our model exhibits both commensurate antiferromagnetic and incommensurate magnetic order along the crystal a-axis. The transition from the commensurate to the incommensurate phase is induced when the concentration of excess $Fe$ atoms is larger than a critical value. Experimentally measurable spin-wave features are calculated, and the mean-field phase diagram of the model is obtained. Our model also suggests the existence of a large quantum critical region due to strong spin frustration upon increasing $Se$ concentration.
rate research
Read More
The magnetic properties attributed to the hydroxide layer of Li1-xFex(OH)Fe1-ySe have been elucidated by the study of superconducting and nonsuperconducting members of this family. Both ac magnetometry and muon spin relaxation measurements of nonsuperconductors find a magnetic state existing below approximately 10 K which exhibits slow relaxation of magnetization. This magnetic state is accompanied by a low-temperature heat capacity anomaly present in both superconducting and nonsuperconducting variants suggesting that the magnetism persists into the superconducting state. The estimated value of magnetic moment present within the hydroxide layer supports a picture of a glassy magnetic state, probably comprising clusters of iron ions of varying cluster sizes distributed within the lithium hydroxide layer.
The (Li$_{1-x}$Fe$_{x}$OH)FeSe superconductor has been suspected to exhibit long-range magnetic ordering due to Fe substitution in the LiOH layer. However, no direct observation such as magnetic reflection from neutron diffraction has be reported. Here, we use a chemical design strategy to manipulate the doping level of transition metals in the LiOH layer to tune the magnetic properties of the (Li$_{1-x-y}$Fe$_{x}$Mn$_{y}$OD)FeSe system. We find Mn doping exclusively replaces Li in the hydroxide layer resulting in enhanced magnetization in the (Li$_{0.876}$Fe$_{0.062}$Mn$_{0.062}$OD)FeSe superconductor without significantly altering the superconducting behavior as resolved by magnetic susceptibility and electrical/thermal transport measurements. As a result, long-range magnetic ordering was observed below 12 K with neutron diffraction measurements. This work has implications for the design of magnetic superconductors for the fundamental understanding of superconductivity and magnetism in the iron chalcogenide system as well as exploitation as functional materials for next generation devices.
We compare the superconducting phase-diagram under high magnetic fields (up to $H = 45$ T) of Fe$_{1+y}$Se$_{0.4}$Te$_{0.6}$ single crystals originally grown by the Bridgman-Stockbarger (BRST) technique, which were annealed to display narrow superconducting transitions and the optimal transition temperature $T_c gtrsim 14$ K, with the diagram for samples of similar stoichiometry grown by the traveling-solvent floating-zone technique as well as with the phase-diagram reported for crystals grown by a self-flux method. We find that the so-annealed samples tend to display higher ratios $H_{c2}/T_c$, particularly for fields applied along the inter-planar direction, where the upper critical field $H_{c2}(T)$ exhibits a pronounced downward curvature followed by saturation at lower temperatures $T$. This last observation is consistent with previous studies indicating that this system is Pauli limited. An analysis of our $H_{c2}(T)$ data using a multiband theory suggests the emergence of the Farrel-Fulde-Larkin-Ovchnikov state at low temperatures. A detailed structural x-ray analysis, reveals no impurity phases but an appreciable degree of mosaicity in as-grown BRST single-crystals which remains unaffected by the annealing process. Energy-dispersive x-ray analysis showed that the annealed samples have a more homogeneous stoichiometric distribution of both Fe and Se with virtually the same content of interstitial Fe as the non-annealed ones. Thus, we conclude that stoichiometric disorder, in contrast to structural disorder, is detrimental to the superconducting phase diagram of this series under high magnetic fields. Finally, a scaling analysis of the fluctuation conductivity in the superconducting critical regime, suggests that the superconducting fluctuations have a two-dimensional character in this system.
The iron chalcogenide Fe$_{1+y}$Te$_{1-x}$Se$_{x}$ on the Te-rich side is known to exhibit the strongest electron correlations among the Fe-based superconductors, and is non-superconducting for $x$ < 0.1. In order to understand the origin of such behaviors, we have performed ARPES studies of Fe$_{1+y}$Te$_{1-x}$Se$_{x}$ ($x$ = 0, 0.1, 0.2, and 0.4). The obtained mass renormalization factors for different energy bands are qualitatively consistent with DFT + DMFT calculations. Our results provide evidence for strong orbital dependence of mass renormalization, and systematic data which help us to resolve inconsistencies with other experimental data. The unusually strong orbital dependence of mass renormalization in Te-rich Fe$_{1+y}$Te$_{1-x}$Se$_{x}$ arises from the dominant contribution to the Fermi surface of the $d_{xy}$ band, which is the most strongly correlated and may contribute to the suppression of superconductivity.
We elucidate the termination surface of cleaved single crystals of the BaFe_(2-x)Co_(x)As_(2) and Fe_(y)Se_(1-x)Te_(x) families of the high temperature iron based superconductors. By combining scanning tunneling microscopic data with low energy electron diffraction we prove that the termination layer of the Ba122 systems is a remnant of the Ba layer, which exhibits a complex diversity of ordered and disordered structures. The observed surface topographies and their accompanying superstructure reflections in electron diffraction depend on the cleavage temperature. In stark contrast, Fe_(y)Se_(1-x)Te_(x) possesses only a single termination structure - that of the tetragonally ordered Se_(1-x)Te_(x) layer.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
