Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userStructures of the reduced niobium oxides Nb12O29 and Nb22O54
219
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
The crystal structure of Nb22O54 is reported for the first time, and the structure of orthorhombic Nb12O29 is reexamined, resolving previous ambiguities. Single crystal x-ray and electron diffraction were employed. These compounds were found to crystallize in the space groups P2/m (a = 15.7491(2) A, b = 3.8236(3) A, c = 17.8521(2) A, beta = 102.029(3)) and Cmcm (a = 3.8320(2) A, b = 20.7400(9) A, c = 28.8901(13) A) respectively and share a common structural unit, a 4x3 block of corner sharing NbO6 octahedra. Despite different constraints imposed by symmetry these blocks are very similar in both compounds. Within a block, it is found that the niobium atoms are not located in the centers of the oxygen octahedra, but rather are displaced inward toward the center of the block forming an apparent antiferroelectric state. Bond valence sums and bond lengths do not show the presence of charge ordering, suggesting that all 4d electrons are delocalized in these compounds at the temperature studied, T = 200 K.
rate research
Read More
We report on an extensive structural and electrical characterization of under-gate dielectric oxide insulators Al2O3 and HfO2 grown by Atomic Layer Deposition (ALD). We elaborate the ALD growth window for these oxides, finding that the 40-100 nm thick layers of both oxides exhibit fine surface flatness and required amorphous structure. These layers constitute a base for further metallic gate evaporation to complete the Metal-Insulator-Semiconductor structure. Our best devices survive energizing up to ~3 MV/cm at 77 K with the leakage current staying below the state-of-the-art level of 1 nA. At these conditions the displaced charge corresponds to a change of the sheet carrier density of 3 times 1013 cm-2, what promises an effective modulation of the micromagnetic properties in diluted ferromagnetic semiconductors.
Kinetics of niobium and titanium carbide precipitates in iron has been simulated with cluster dynamics. The simulations, carried out in austenite and ferrite for niobium carbides, respectively in austenite for titanium carbide, were analyzed for dependency on temperature, solute concentration, and initial cluster distribution. The results are presented for different temperatures and solute concentrations and compared to available experimental data. They show little impact of initial cluster distribution beyond a certain relaxation time and that highly dilute alloys with only monomers present a significantly different behavior than less dilute alloys or alloys with different initial cluster distribution.
We demonstrate that a single zone furnace with a modified synthesis chamber design is sufficient to obtain metal (Fe, Co or Ni) filled carbon nanotubes (CNT) with high filling efficiency and controlled morphology. Samples are formed by pyrolysis of metallocenes, a synthesis technique that otherwise requires a dual zone furnace. Respective metallocene in all three cases are sublimed in powder form, a crucial factor for obtaining high filling efficiency. While Fe@CNT is routinely produced using this technique, well-formed Ni@CNT or Co@CNT samples are reported for the first time. This is achieved by sublimation of nickelocene (or cobaltocene) in combination with camphor. These samples exhibit some of the highest saturation magnetization (Ms) values, at least an order of magnitude higher than that reported for Ni or Co filled CNT, by aerosol assisted pyrolysis. The results also elucidate on why Ni or Co@CNT are relatively difficult to obtain by pyrolyzing powder metallocene alone. Overall, a systematic variation of synthesis parameters provides insights for obtaining narrow length and diameter distribution and reduced residue particles outside filled CNT - factors which are important for device related applications. Finally, the utility of this technique is demonstrated by obtaining highly aligned forest of Fe2O3@CNT, wherein Fe2O3 is a functional magnetic oxide relevant to spintronics and battery applications.
Giant photovoltaic effect due to bulk photovoltaic effect observed in multiferroic BiFeO3 thin films has triggered a renewed interest on photoferroelectric materials for photovoltaic applications. Tremendous advance has been done to improve power conversion efficiency (up to up to 8.1%) in photoferroelectrics via absorption increase using narrow bandgap ferroelectrics. Other strategies, as it is the more efficient use of ferroelectric internal electric field, are ongoing. Moreover, as a by-product, several progress have been also achieved on photostriction that is the photo-induced deformation phenomenon. Here, we review ongoing and promising routes to improve ferroelectrics photoresponse.
It is shown that dilute niobium doping has significant effect on the ferromagnetism and microstructure of dilutely cobalt-doped anatase TiO2 films. Epitaxial films of anatase TiO2 with 3% Co, without and with 1% niobium doping were grown by pulsed-laser deposition at 875 C at different oxygen pressures. For growth at 10^{-5} Torr niobium doping suppresses the ferromagnetism, while it enhances the same in films grown at 10^{-4} Torr. High-resolution Z-contrast Scanning Transmission Electron Microscopy and Electron Energy Loss Spectroscopy show uniform surface segregation of cobalt-rich Ti_{1-x-y}Co_{x}Nb_{y}O_{2-d} phase, but without cobalt metal clusters.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
