Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userPhoto-assisted shot noise in Coulomb interacting systems
135
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We consider the fluctuations of the electrical current (shot noise) in the presence of a voltage time-modulation. For a non-interacting metal, it is known that the derivative of the photo-assisted noise has a staircase behavior. In the presence of Coulomb interactions, we show that the photo-assisted noise presents a more complex profile, in particular for the two following systems: 1) a two-dimensional electron gas in the fractional quantum Hall regime for which we have obtained evenly spaced singularities in the noise derivative, with a spacing related to the filling factor and, 2) a carbon nanotube for which a smoothed staircase in the noise derivative is obtained.
rate research
Read More
The effect of an AC perturbation on the shot noise of a fractional quantum Hall fluid is studied both in the weak and the strong backscattering regimes. It is known that the zero-frequency current is linear in the bias voltage, while the noise derivative exhibits steps as a function of bias. In contrast, at Laughlin fractions, the backscattering current and the backscattering noise both exhibit evenly spaced singularities, which are reminiscent of the tunneling density of states singularities for quasiparticles. The spacing is determined by the quasiparticle charge $ u e$ and the ratio of the DC bias with respect to the drive frequency. Photo--assisted transport can thus be considered as a probe for effective charges at such filling factors, and could be used in the study of more complicated fractions of the Hall effect. A non-perturbative method for studying photo--assisted transport at $ u=1/2$ is developed, using a refermionization procedure.
Photo-assisted transport through a mesoscopic conductor occurs when an oscillatory (AC) voltage is superposed to the constant (DC) bias which is imposed on this conductor. Of particular interest is the photo assisted shot noise, which has been investigated theoretically and experimentally for several types of samples. For DC biased conductors, a detection scheme for finite frequency noise using a dissipative resonant circuit, which is inductively coupled to the mesoscopic device, was developped recently. We argue that the detection of the finite frequency photo-assisted shot noise can be achieved with the same setup, despite the fact that time translational invariance is absent here. We show that a measure of the photo-assisted shot noise can be obtained through the charge correlator associated with the resonant circuit, where the latter is averaged over the AC drive frequency. We test our predictions for a point contact placed in the fractional quantum Hall effect regime, for the case of weak backscattering. The Keldysh elements of the photo-assisted noise correlator are computed. For simple Laughlin fractions, the measured photo-assisted shot noise displays peaks at the frequency corresponding to the DC bias voltage, as well as satellite peaks separated by the AC drive frequency.
We observe the suppression of the finite frequency shot-noise produced by a voltage biased tunnel junction due to its interaction with a single electromagnetic mode of high impedance. The tunnel junction is embedded in a quarter wavelength resonator containing a dense SQUID array providing it with a characteristic impedance in the kOhms range and a resonant frequency tunable in the 4-6 GHz range. Such high impedance gives rise to a sizeable Coulomb blockade on the tunnel junction (roughly 30% reduction in the differential conductance) and allows an efficient measurement of the spectral density of the current fluctuations at the resonator frequency. The observed blockade of shot-noise is found in agreement with an extension of the dynamical Coulomb blockade theory.
We work out a theory of shot noise in a special case. This is a noise of the Coulomb drag current excited under the ballistic transport regime in a one-dimensional nanowire by a ballistic non-Ohmic current in a nearby parallel nanowire. We predict sharp oscillation of the noise power as a function of gate voltage or the chemical potential of electrons. We also study dependence of the noise on the voltage V across the driving wire. For relatively large values of V the noise power is proportional to V^2.
When subjected to electromagnetic radiation, the fluctuation of the electronic current across a quantum conductor increases. This additional noise, called photon-assisted shot noise, arises from the generation and subsequent partition of electron-hole pairs in the conductor. The physics of photon-assisted shot noise has been thoroughly investigated at microwave frequencies up to 20 GHz, and its robustness suggests that it could be extended to the Terahertz (THz) range. Here, we present measurements of the quantum shot noise generated in a graphene nanoribbon subjected to a THz radiation. Our results show signatures of photon-assisted shot noise, further demonstrating that hallmark time-dependant quantum transport phenomena can be transposed to the THz range.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
