Submillimetre-sized dust aggregate collision and growth properties


الملخص بالإنكليزية

The collisional and sticking properties of sub-mm-sized aggregates composed of protoplanetary dust analogue material are measured, including the statistical threshold velocity between sticking and bouncing, their surface energy and tensile strength within aggregate clusters. We performed an experiment on the REXUS 12 suborbital rocket. The protoplanetary dust analogue materials were micrometre-sized monodisperse and polydisperse SiO2 particles prepared into aggregates with sizes around 120 $mu$m and 330 $mu$m, respectively and volume filling factors around 0.37. During the experimental run of 150 s under reduced gravity conditions, the sticking of aggregates and the formation and fragmentation of clusters of up to a few millimetres in size was observed. The sticking probability of the sub-mm-sized dust aggregates could be derived for velocities decreasing from 22 to 3 cm/s. The transition from bouncing to sticking collisions happened at 12.7 cm/s for the smaller aggregates composed of monodisperse particles and at 11.5 and 11.7 cm/s for the larger aggregates composed of mono- and polydisperse dust particles, respectively. Using the pull-off force of sub-mm-sized dust aggregates from the clusters, the surface energy of the aggregates composed of monodisperse dust was derived to be 1.6x10-5 J/m2, which can be scaled down to 1.7x10-2 J/m2 for the micrometre-sized monomer particles and is in good agreement with previous measurements for silica particles. The tensile strengths of these aggregates within the clusters were derived to be 1.9 Pa and 1.6 Pa for the small and large dust aggregates, respectively. These values are in good agreement with recent tensile strength measurements for mm-sized silica aggregates. Using our data on the sticking-bouncing threshold, estimates of the maximum aggregate size can be given. For a minimum mass solar nebula model, aggregates can reach sizes of 1 cm.

تحميل البحث