We establish the three-dimensional architecture of the Kepler-419 (previously KOI-1474) system to be eccentric yet with a low mutual inclination. Kepler-419b is a warm Jupiter at semi-major axis a = 0.370 +0.007/-0.006 AU with a large eccentricity e=0.85 +0.08/-0.07 measured via the photoeccentric effect. It exhibits transit timing variations induced by the non-transiting Kepler-419c, which we uniquely constrain to be a moderately eccentric (e=0.184 +/- 0.002), hierarchically-separated (a=1.68 +/- 0.03 AU) giant planet (7.3 +/- 0.4 MJup). We combine sixteen quarters of Kepler photometry, radial-velocity (RV) measurements from the HIgh Resolution Echelle Spectrometer (HIRES) on Keck, and improved stellar parameters that we derive from spectroscopy and asteroseismology. From the RVs, we measure the mass of inner planet to be 2.5+/-0.3MJup and confirm its photometrically-measured eccentricity, refining the value to e=0.83+/-0.01. The RV acceleration is consistent with the properties of the outer planet derived from TTVs. We find that, despite their sizable eccentricities, the planets are coplanar to within 9 +8/-6 degrees, and therefore the inner planets large eccentricity and close-in orbit are unlikely to be the result of Kozai migration. Moreover, even over many secular cycles, the inner planets periapse is most likely never small enough for tidal circularization. Finally, we present and measure a transit time and impact parameter from four simultaneous ground-based light curves from 1m-class telescopes, demonstrating the feasibility of ground-based follow-up of Kepler giant planets exhibiting large TTVs.
تحميل البحث