اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدMonte Carlo simulations of the Nickel K$alpha$ fluorescent emission line in a toroidal geometry
97
0
0.0
(
0
)
تأليف
Tahir Yaqoob
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We present new results from Monte Carlo calculations of the flux and equivalent width (EW) of the Ni Kalpha fluorescent emission line in the toroidal X-ray reprocessor model of Murphy & Yaqoob (2009, MNRAS, 397, 1549). In the Compton-thin regime, the EW of the Ni Kalpha line is a factor of ~22 less than that of the Fe Kalpha line but this factor can be as low as ~6 in the Compton-thick regime. We show that the optically-thin limit for this ratio depends only on the Fe to Ni abundance ratio, it being independent of the geometry and covering factor of the reprocessor, and also independent of the shape of the incident X-ray continuum. We give some useful analytic expressions for the absolute flux and the EW of the Ni Kalpha line in the optically-thin limit. When the reprocessor is Compton-thick and the incident continuum is a power-law with a photon index of 1.9, the Ni Kalpha line EW has a maximum value of ~3 eV and ~250 eV for non-intercepting and intercepting lines-of-sight respectively. Larger EWs are obtained for flatter continua. We have also studied the Compton shoulder of the Ni Ka line and find that the ratio of scattered to unscattered flux in the line has a maximum value of 0.26, less than the corresponding maximum for the Fe Kalpha line. However, we find that the shape of the Compton shoulder profile for a given column density and inclination angle of the torus is similar to the corresponding profile for the Fe Ka line. Our results will be useful for interpreting X-ray spectra of active galactic nuclei (AGNs) and X-ray binary systems in which the system parameters are favorable for the Ni Kalpha line to be detected.
قيم البحث
اقرأ أيضاً
The Galactic Ridge X-ray Emission (GRXE) spectrum has strong iron emission lines at 6.4, 6.7, and 7.0~keV, each corresponding to the neutral (or low-ionized), He-like, and H-like iron ions. The 6.4~keV fluorescence line is due to irradiation of neutr
al (or low ionized) material (iron) by hard X-ray sources, indicating uniform presence of the cold matter in the Galactic plane. In order to resolve origin of the cold fluorescent matter, we examined the contribution of the 6.4~keV line emission from white dwarf surfaces in the hard X-ray emitting symbiotic stars (hSSs) and magnetic cataclysmic variables (mCVs) to the GRXE. In our spectral analysis of 4~hSSs and 19~mCVs observed with Suzaku, we were able to resolve the three iron emission lines. We found that the equivalent-widths (EWs) of the 6.4~keV lines of hSSs are systematically higher than those of mCVs, such that the average EWs of hSSs and mCVs are $179_{-11}^{+46}$~eV and $93_{-3}^{+20}$~eV, respectively. The EW of hSSs compares favorably with the typical EWs of the 6.4~keV line in the GRXE of 90--300~eV depending on Galactic positions. Average 6.4~keV line luminosities of the hSSs and mCVs are $9.2times 10^{39}$ and $1.6times 10^{39}$~photons~s$^{-1}$, respectively, indicating that hSSs are intrinsically more efficient 6.4~keV line emitters than mCVs. We compare expected contribution of the 6.4 keV lines from mCVs with the observed GRXE 6.4 keV line flux in the direction of $(l,b) approx (28.5arcdeg, 0arcdeg$). We conclude that almost all the 6.4 keV line flux in GRXE may be explained by mCVs within current undertainties of the stellar number densities, while contribution from hSSs may not be negligible.
We present MCRaT, a Monte Carlo Radiation Transfer code for self-consistently computing the light curves and spectra of the photospheric emission from relativistic, unmagnetized jets. We apply MCRaT to a relativistic hydrodynamic simulation of a long
duration gamma-ray burst jet, and present the resulting light-curves and time-dependent spectra for observers at various angles from the jet axis. We compare our results to observational results and find that photospheric emission is a viable model to explain the prompt phase of long-duration gamma-ray bursts at the peak frequency and above, but faces challenges in reproducing the flat spectrum below the peak frequency. We finally discuss possible limitations of these results both in terms of the hydrodynamics and the radiation transfer and how these limitations could affect the conclusions that we present.
CoREAS is a Monte Carlo simulation code for the calculation of radio emission from extensive air showers. It is based on the endpoint formalism for radiation from moving charges implemented directly in CORSIKA. Consequently, the full complexity of th
e air-shower physics is taken into account without the need for approximations or assumptions on the emission mechanism. We present results of simulations for an unthinned shower performed with CoREAS for both MHz and GHz frequencies. At MHz frequencies, the simulations predict the well-known mixture of geomagnetic and charge excess radiation. At GHz frequencies, the emission is strongly influenced by Cherenkov effects arising from the varying refractive index in the atmosphere. In addition, a qualitative difference in the symmetry of the GHz radiation pattern is observed when compared to the ones at lower frequencies. We also discuss the strong increase in the ground area subtended by the radio emission when going from near-vertical to very inclined geometries, making very inclined air showers the most promising ones for cosmic ray radio detection.
Blue shifted absorption lines from highly ionised iron are seen in some high inclination X-ray binary systems, indicating the presence of an equatorial disc wind. This launch mechanism is under debate, but thermal driving should be ubiquitous. X-ray
irradiation from the central source heats disc surface, forming a wind from the outer disc where the local escape velocity is lower than the sound speed. The mass loss rate from each part of the disc is determined by the luminosity and spectral shape of the central source. We use these together with an assumed density and velocity structure of the wind to predict the column density and ionisation state, then combine this with a Monte Carlo radiation transfer to predict the detailed shape of the absorption (and emission) line profiles. We test this on the persistent wind seen in the bright neutron star binary GX 13+1, with luminosity L/LEdd ~ 0.5. We approximately include the effect of radiation pressure because of high luminosity, and compute line features. We compare these to the highest resolution data, the Chandra third order grating spectra, which we show here for the first time. This is the first physical model for the wind in this system, and it succeeds in reproducing many of the features seen in the data, showing that the wind in GX13+1 is most likely a thermal-radiation driven wind. This approach, combined with better streamline structures derived from full radiation hydrodynamic simulations, will allow future calorimeter data to explore the detail wind structure.
We present new, high signal-to-noise ratio results from a Monte Carlo study of the properties of the Compton shoulder of the Fe Kalpha emission line in the toroidal X-ray reprocessor model of Murphy & Yaqoob (2009, MNRAS, 397, 1549). The model compre
hensively covers the Compton-thin to Compton-thick regimes and we find that the variety of Compton shoulder profiles is greater than that for both (centrally-illuminated) spherical and disk geometries. Our Monte Carlo simulations were done with a statistical accuracy that is high enough to reveal, for the case of an edge-on, Compton-thick torus, a new type of Compton shoulder that is not present in the spherical or disk geometries. Such a Compton shoulder is dominated by a narrow back-scattering feature at ~6.24 keV. Our results also reveal a dependence of the shape of the Compton shoulder (and its magnitude relative to the Fe Kalpha line core) on the spectral shape of the incident X-ray continuum. We also show the effects of velocity broadening on the Fe Kalpha line profile and find that if either the velocity width or instrument resolution is greater than a FWHM of ~2000 km/s, the Compton shoulder begins to become blended with the line core and the characteristic features of the Compton shoulder become harder to resolve. In particular, at a FWHM of ~7000 km/s the Compton shoulder is NOT resolved at all, its only signature being a weak asymmetry in the blended line profile. Thus, CCD X-ray detectors cannot unambiguously resolve the Compton shoulder. Our results are freely available in a format that is suitable for direct spectral-fitting of the continuum and line model to real data.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
