اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدRetrieving Dust Grain Sizes from Photopolarimetry: An Experimental Approach
73
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We present the experimental phase function, degree of linear polarization (DLP), and linear depolarization (deltaL) curves of a set of forsterite samples representative of low-absorbing cosmic dust particles. The samples are prepared using state-of-the-art size-segregating techniques to obtain narrow size distributions spanning a broad range of the scattering size parameter domain. We conclude that the behavior of the phase function at the side- and back-scattering regions provides information on the size regime, the position and magnitude of the maximum of the DLP curve are strongly dependent on particle size, the negative polarization branch is mainly produced by particles with size parameters in the approx. 6 to 20 range, and the deltaL is strongly dependent on particle size at all measured phase angles except for the exact backward direction. From a direct comparison of the experimental data with computations for spherical particles, it becomes clear that the use of the spherical model for simulating the phase function and DLP curves of irregular dust produces dramatic errors in the retrieved composition and size of the scattering particles: The experimental phase functions are reproduced by assuming unrealistically high values of the imaginary part of the refractive index. The spherical model does not reproduce the bell-shaped DLP curve of dust particles with sizes in the resonance and/or geometric optics size domain. Thus, the use of the Mie model for analyzing polarimetric observations might prevent locating dust particles with sizes of the order of or larger than the wavelength of the incident light.
قيم البحث
اقرأ أيضاً
The InSight mission has operated on the surface of Mars for nearly two Earth years, returning detections of the first Marsquakes. The lander also deployed a meteorological instrument package and cameras to monitor local surface activity. These instru
ments have detected boundary layer phenomena, including small-scale vortices. These vortices register as short-lived, negative pressure excursions and closely resemble those that could generate dust devils. Although our analysis shows InSight encountered more than 900 vortices and collected more than 1000 images of the martian surface, no active dust devils were imaged. In spite of the lack of dust devil detections, we can leverage the vortex detections and InSights daily wind speed measurements to learn about the boundary layer processes that create dust devils. We discuss our analysis of InSights meteorological data to assess the statistics of vortex and dust devil activity. We also infer encounter distances for the vortices and, therefrom, the maximum vortex wind speeds. Surveying the available imagery, we place upper limits on what fraction of vortices carry dust (i.e., how many are bonafide dust devils) and estimate threshold wind speeds for dust lifting. Comparing our results to detections of dust devil tracks seen in space-based observations of the InSight landing site, we can also infer thresholds and frequency of track formation by vortices. Comparing vortex encounters and parameters with advective wind speeds, we find evidence that high wind speeds at InSight may have suppressed the formation of dust devils, explaining the lack of imaged dust devils.
We propose a new method to retrieve the optical depth of Martian aerosols (AOD) from OMEGA and CRISM hyperspectral imagery at a reference wavelength of 1 {mu}m. Our method works even if the underlying surface is completely made of minerals, correspon
ding to a low contrast between surface and atmospheric dust, while being observed at a fixed geometry. Minimizing the effect of the surface reflectance properties on the AOD retrieval is the second principal asset of our method. The method is based on the parametrization of the radiative coupling between particles and gas determining, with local altimetry, acquisition geometry, and the meteorological situation, the absorption band depth of gaseous CO2. Because the last three factors can be predicted to some extent, we can define a new parameter {beta} that expresses specifically the strength of the gas-aerosols coupling while directly depending on the AOD. Combining estimations of {beta} and top of the atmosphere radiance values extracted from the observed spectra within the CO2 gas band at 2 {mu}m, we evaluate the AOD and the surface reflectance by radiative transfer inversion. One should note that practically {beta} can be estimated for a large variety of mineral or icy surfaces with the exception of CO2 ice when its 2 {mu}m solid band is not sufficiently saturated. Validation of the proposed method shows that it is reliable if two conditions are fulfilled: (i) the observation conditions provide large incidence or/and emergence angles (ii) the aerosol are vertically well mixed in the atmosphere. Experiments conducted on OMEGA nadir looking observations as well as CRISM EPF acquisitions with incidence angles higher than 65{deg} and 33{deg} respectively produce very satisfactory results. Finally in a companion paper the method is applied to monitoring atmospheric dust spring activity at high southern latitudes on Mars using OMEGA.
In this work we investigate the effects of ion accretion and size-dependent dust temperatures on the abundances of both gas-phase and grain-surface species. While past work has assumed a constant areal density for icy species, we show that this assum
ption is invalid and the chemical differentiation over grain sizes are significant. We use a gas-grain chemical code to numerically demonstrate this in two typical interstellar conditions: dark cloud (DC) and cold neutral medium (CNM). It is shown that, although the grain size distribution variation (but with the total grain surface area unchanged) has little effect on the gas-phase abundances, it can alter the abundances of some surface species by factors up to $sim2-4$ orders of magnitude. The areal densities of ice species are larger on smaller grains in the DC model as the consequence of ion accretion. However, the surface areal density evolution tracks are more complex in the CNM model due to the combined effects of ion accretion and dust temperature variation. The surface areal density differences between the smallest ($sim 0.01mu$m) and the biggest ($sim 0.2mu$m) grains can reach $sim$1 and $sim$5 orders of magnitude in the DC and CNM models, respectively.
We explore whether assumptions about dust grain shape affect resulting estimates of the composition and grain size distribution of the AU Microscopii (AU Mic) debris disk from scattered light data collected by Lomax et al. (2018). The near edge-on or
ientation of the AU Mic debris disk makes it ideal for studying the effect of the scattering phase function (SPF) on the measured flux ratios as a function of wavelength and projected distance. Previous efforts to model the AU Mic debris disk have invoked a variety of dust grain compositions and explored the effect of porosity, but did not undertake a systematic effort to explore a full range of size distributions and compositions to understand possible degeneracies in fitting the data. The degree to which modelling dust grains with more realistic shapes compounds these degeneracies has also not previously been explored. We find differences in the grain properties retrieved depending on the grain shape model used. We also present here our calculations of porous grains of size parameters x = 0.1 to 48 and complex refractive indices (m = n+ik) ranging from n = 1.1 to 2.43 and k = 0 to 1.0, covering multiple compositions at visible and near infrared wavelengths such as ice, silicates, amorphous carbon, and tholins.
We analyse spatially resolved ALMA observations at 0.9, 1.3, and 3.1 mm for the 26 brightest protoplanetary discs in the Lupus star-forming region. We characterise the discs multi-wavelength brightness profiles by fitting the interferometric visibili
ties in a homogeneous way, obtaining effective disc sizes at the three wavelengths, spectral index profiles and optical depth estimates. We report three fundamental discoveries: first, the millimeter continuum size - luminosity relation already observed at 0.9 mm is also present at 1.3 mm with an identical slope, and at 3.1 mm with a steeper slope, confirming that emission at longer wavelengths becomes increasingly optically thin. Second, when observed at 3.1 mm the discs appear to be only 9% smaller than when observed at 0.9 mm, in tension with models of dust evolution which predict a starker difference. Third, by forward modelling the sample of measurements with a simple parametric disc model, we find that the presence of large grains ($a_mathrm{max}>1 $mm) throughout the discs is the most favoured explanation for all discs as it reproduces simultaneously their spectral indices, optical depth, luminosity, and radial extent in the 0.9-1.3 mm wavelength range. We also find that the observations can be alternatively interpreted with the discs being dominated by optically thick, unresolved, substructures made of mm-sized grains with a high scattering albedo.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
